Which two features are associated with single-mode fiber-optic cable? (Choose two.)

consists of a single strand of glass fiber

carries a higher bandwidth that multimode fiber

consists of a single strand of glass fiber

has higher attenuation that multimode fiber

carries a higher bandwidth that multimode fiber

costs less than multimode fiber

operates over less distance than multimode fiber

Refer to the exhibit. Which two statements about the hardware components are true? (Choose two.)

3 is a USB 5-pin mini USB Type B port.

2 is a USB 5-pin mini USB Type B to USB Type A console cable.

2 is an RJ-45 to USB Type A console cable.

3 is a USB 5-pin mini USB Type B port.

2 is a USB 5-pin mini USB Type B to USB Type A console cable.

Which two statements about a SmartJack are true? (Choose two.)

It regenerates the signal to compensate for signal degradation from line transmission.

It acts as a concentration point for dial-in and dial-out connections.

It operates at Layer 2 of the OSI model.

It regenerates the signal to compensate for signal degradation from line transmission.

Which two commands are valid for copying a saved configuration to RAM? (Choose two.)

copy startup-config running-config

copy running-config startup-config

Which set of steps best describes how to assign a static IP address to the Ethernet port on a computer?

From the Network and Sharing Center, click Change adapter, then double-click a local area connection. Select Internet Protocol (TCP/IP) > Properties > Use the Following Address, and then configure the IP information.

From the Network and Sharing Center, click Internet Protocol (TCP/IP), and follow the New Connection Wizard instructions.

From the Network and Sharing Center, click Change adapter, then double-click a local area connection. Select Internet Protocol (TCP/IP) > Properties > Use the Following Address, and then configure the IP information.

Click Start. Enter cmd and click OK. Enter the IP address XXX.XXX.XXX.XXX.

From the Network and Sharing Center, double-click Local Area Connection. Select Properties > iPass Protocol (IEEE 802.1x) > Properties > Static IP.

Refer to the exhibit. What are two identifications for the hardware components? (Choose two.)

2 is an RJ-45 to USB Type A console cable.

2 is a USB 5-pin mini USB Type B to USB Type A console cable.

3 is a USB 5-pin mini USB Type B port.

An Ethernet interface is up and the line protocol is down. What are two possible causes? (Choose two.)

There is a speed or duplex mismatch with the remote device.

There is a Layer 2 mismatch in the encapsulation type.

There is a speed or duplex mismatch with the remote device.

There is a Layer 2 mismatch in the encapsulation type.

The Ethernet interface has been manually disabled.

Keepalives are not being received by the local device.

The Ethernet cable might not be attached properly.

From the enable mode, which command loads the configuration during the password recovery process on a Cisco router?

copy startup-config running-config

copy running-config startup-config

copy startup-config running-config

How are IPv6 addresses notated?

2001:0DB8:130F:0000:0000:7000:0000:140B

Cisco 100-490 Practice Test 2 - Free Online Exam Prep & Questions

What is the fastest way to recover a software version that supports a USB flash port on a Cisco device?

Become a Premium Member for full access

Unlock Premium Member

Cisco 100-490 Practice Test 2

Question

Cisco 100-490 Practice Tests

Practice Tests