LPI 102-500 Practice Test – Member Shared Questions, Page 15

Question 141

Given the following routing table:

How would an outgoing packet to the destination 192.168.2.150 be handled?

A.

It would be passed to the default router 192.168.178.1 on wlan0.

B.

It would be directly transmitted on the device eth0.

C.

It would be passed to the default router 255.255.255.0 on eth0.

D.

It would be directly transmitted on the device wlan0.

E.

It would be passed to the router 192.168.1.1 on eth0.

Show Answer Comment (0)

Question 142

Question 143

Question 144

On a regular users workstation the route command takes a long time before printing out the routing table. Which of the following errors does that indicate?

A.

The local routing information may be corrupted and must be re-validated using a routing protocol.

B.

One of the routers in the routing table is not available which causes the automatic router failure detection mechanism (ARF-D) to wait for a timeout.

C.

There may accidentally be more than one default router in which case a default router election has to be done on the network in order to choose one router as the default.

D.

DNS resolution may not be working as route by default tries to resolve names of routers and destinations and may run into a timeout.

Show Answer Comment (0)

Question 145

Which keyword must be listed in the hosts option of the Name Service Switch configuration file in order to make host lookups consult the /etc/hosts file?

A.

files

Show Answer Comment (0)

Question 146

In an xinetd configuration file, which attribute specifies the network address that will be used to provide the service?

A.

bind, interface

Show Answer Comment (0)

Question 147

What argument to the -type option of find will match files that are symbolic links? (Specify only the argument and no other options or words.)

A.

l

Show Answer Comment (0)

Question 148

With X11 forwarding in ssh, what environment variable is automatically set in the remote host shell that is not set when X11 forwarding is not enabled? (Specify only the environment variable without any additional commands or values.)

A.

DISPLAY,$DISPLAY