Refer to the exhibit Refer to the exhibit A WAN Edge device was recently added to vManage but a control connection could not be established Which action resolves this issue?

Send the serial number to vBond from the vManage controller.

Rectify the Rod CA certificate mismatch on WAN Edge devices

Install the bootstrap code on WAN Edge and check for CSR

Send the serial number to vBond from the vManage controller.

Resolve the ZTP reachability and rectify smart account credentials issue

Which two mechanisms are used by vManage to ensure that the certificate serial number of the WAN Edge router that is needed to authenticate is listed in the WAN Edge Authorized Seal Number Hst' (Choose two)

Synchronize to the Smart Account

The devices register to vManage directly as the devices come online

The vManage is shipped with the list

Synchronize to the Smart Account

Which protocol runs between the vSmart controllers and WAN Edge routers when the vSmart controller acts like a route reflector?

OMP inside the DTLS/TLS control connection

OMP outside the DTLS/TLS control connection

IPsec inside the DTLS/TLS control connection

OMP inside the DTLS/TLS control connection

Remove IP duplication in the network and configure a unique IP address

Recover the vManage controller that is down m a high availability cluster

Change the system IP or restart the VWN Edge 4 the system IP is changed

Remove IP duplication in the network and configure a unique IP address

Recover vBond or wart for the controller to reload which could be caused by a reset

Refer to the exhibit Refer to the exhibit Which NAT types must the engineer configure for the vEdge router to bring up the data plane tunnels?

Enable Full Cone NAT on the vEdge interface

Enable Symmetric MAT on the vEdge interface

Refer to the exhibit Refer to the exhibit A vBond controller was added to the controller list with the same Enterprise Root CA certificate as vManage. The two controllers can reach each other via VPNO and share the same organization name, but the control connection is not initiated- Which action resolves the issue?

Configure a valid vBond IP on vManage.

Synchronize the WAN Edge list on vManage with controllers.

Configure NTP on both controllers to establish a connection.

Configure a valid systom IP on the vBond controller.

Configure a valid vBond IP on vManage.

What is the result during a WAN Edge software upgrade process if the version of the WAN Edge software is higher than the one running on a controller device?

The upgrade proceeds with a warning message

The upgrade button is greyed out

The upgrade proceeds with no warning message.

The upgrade fails with a warning message

The upgrade proceeds with a warning message

Refer to exhibit. An engineer is troubleshooting tear of control connection even though a valid CertificateSerialNumber is entered. Which two actions resolve Issue? (Choose two)

Enter a valid serial cumber on the controller for a given device

Enter a valid product ID (mode) on the PNP portal.

Restore network reachability on the controller.

Enter a valid serial cumber on the controller for a given device

Enter a valid product ID (mode) on the PNP portal.

Match the serial number file between the controller

Remove the duplicate IP in the network

An engineer is configuring a data policy IPv4 prefixes for a site WAN edge device on a site with edge devices. How is this policy added using the policy configuration wizard?

In vManage NMS. select the configure policies screen. select the localized policy tab- and click add policy

In vManage NMS select (he configure policies screen, select the centralized policy tab and click add policy

In vBood orchestrator. select the configure > policies screen select the localized policy tab. and click add policy

In vManage NMS. select the configure policies screen. select the localized policy tab- and click add policy

In vSmart controller select tie configure policies screen, select the localized policy tab, and click add policy

Which actions must be taken to allow certain departments to require firewall protection when interacting with data center network without including other departments? (Choose two.)

Deploy a service-chained firewall service per VPN

The regional hub advertises the availability of the firewall service

Use classification policing and marking

Deploy a service-chained firewall service per VPN

The regional hub advertises the availability of the firewall service

Advertise lo vSmart controllers

What problem happens on a device with two serial numbers, a unique device identifier (UDI), and secure unique device identifier (SUDI) when an engineer provisions ISR 4000 by PnP using only a UDI?

It encounters memory overload problems

It encounters spanning tree issues

It faces interface buffer overflow patterns

It encounters redirection problems.

It encounters memory overload problems

How do WAN Edge devices operate when vSmart is inaccessible or fails to be reached by the WAN Edge?

They continue operating normally for a configurable time.

They cease to forward traffic in the data plane.

They continue operation normally.

They continue to receive reachability updates.

They continue operating normally for a configurable time.

How is the software managed in Cisco SD-WAN?

Software images must be uploaded to vManage through HTTP or FTP

Software downgrades are unsupported for vManage

Software images must be transferred through VPN 512 or VPN 0 of vManage

Software upgrade operation in the group must include vManage. vBond, and vSmart.

Cisco 300-415 Practice Test 9 - Free Online Exam Questions 321-360

An engineer must configure local redundancy on a site. Which configuration accomplish this task?

Become a Premium Member for full access

Unlock Premium Member

Cisco 300-415 Practice Test 9

Question

Cisco 300-415 Practice Tests

Practice Tests