Cisco ACI fabric must send a packet between two pods in a Cisco AC1 Multi-Pod topology where ARP flooding is disabled within the bridge domain. How does a Cisco ACI spine switch .. ARP messages from a leaf switch in POD1 to POD2?

An ARP Glean message is sent to multicast address 239.255.255.240.

The ARP message is dropped and connectivity is lost between the endpoints.

ARP optimization is applied and sends ARP to remote anycast.

A proxy ARP message is sent to destination group 225.224.0.0.

An ARP Glean message is sent to multicast address 239.255.255.240.

Engineer resolves an underlying condition of a fault but notices that the fault was not deleted from the Faults view. Which two actions must be taken to remove the fault? (Choose two.)

The fault is deleted after the retention interval.

Acknowledge the fault as an administrator.

The fault is deleted after the retention interval.

Acknowledge the fault as an administrator.

Refer to the exhibit. Refer to the exhibit. An engineer created a local user named User on Cisco ACI. The engineer must configure the fabric so that the User can access only common and PROD tenants, ch set of actions accomplishes the goal?

Add security domain 'common' to User. Associate security domain 'common' under PROD tenant.

Add security domain 'all' to User. Associate security domain 'all' under PROD tenant.

Add security domain 'Tenant' to User. Associate security domain 'Tenant' under PROD tenant.

Add security domain 'common' to User. Associate security domain 'common' under PROD tenant.

Add security domain 'mgmt' to User Associate security domain 'mgmt' under PROD tenant.

An engineer created a monitoring policy called Test in a Cisco ACI fabric and had to change the severity level of the monitored object Call home source. Which set of actions prevent the event from appearing in event reports?

Select Event Severity Assignment Policies. Set severity level to squelched.

Select Event Severity Assignment Policies. Set severity level to cleared.

Select Faults Severity Assignment Policies. Set severity level to cleared.

Select Event Severity Assignment Policies. Set severity level to squelched.

Select Faults Severity Assignment Policies. Set severity level to squelched.

Refer to the exhibit. The engineer is planning to configure in-band management for the Cisco ACI fabric. The goal is to allow the network operators to reach the Cisco APIC servers and fabric switches from the in-band network. Which configuration must be applied on the bridge domain to accomplish these goals?

Enable Unicast Routing. Set scope to Advertised Externally.

Enable Unicast Routing. Configure a virtual IP address.

Enable Unicast Routing. Set scope to Advertised Externally.

Scope: Shared between VRF. Set the IP address as primary.

Make this IP address primary. Configure an L30ut for Route Profile.

Cisco 300-620 Practice Test 7 - Free Online Exam Questions 241-247

An engineer must configure a service graph for the policy-based redirect to redirect traffic to a transparent firewall. The policy must be vendor-agnostic to support any firewall appliance, Which two actions accomplish these goals? (Choose two.)

Become a Premium Member for full access

Unlock Premium Member

Cisco 300-620 Practice Test 7

Question

Cisco 300-620 Practice Tests

Practice Tests