ExamGecko
Home Home / VMware / 3V0-42.20

VMware 3V0-42.20 Practice Test - Questions Answers, Page 4

Question list
Search
Search

List of questions

Search

Related questions











A Solution Architect will be deploying an Ethernet Virtual Private Network (EVPN) in their NSX-T Data Center environment.

What two selections must be prepared for the EVPN deployment? (Choose two.)

A.
deployed Tier-0 gateway
A.
deployed Tier-0 gateway
Answers
B.
deployed Load Balancer
B.
deployed Load Balancer
Answers
C.
deployed Tier-1 gateway
C.
deployed Tier-1 gateway
Answers
D.
remote gateway with support for IGP and VLAN priority
D.
remote gateway with support for IGP and VLAN priority
Answers
E.
remote gateway with support for MP-BGP and VXLANAnswer: BE
E.
remote gateway with support for MP-BGP and VXLANAnswer: BE
Answers
Suggested answer: B, E

Which three choices are part of a Design Approach when discussing design alternatives and their effects? (Choose three.)

A.
backup
A.
backup
Answers
B.
budget
B.
budget
Answers
C.
cost
C.
cost
Answers
D.
performance
D.
performance
Answers
E.
knowledge
E.
knowledge
Answers
F.
security
F.
security
Answers
Suggested answer: D, E, F

An architect is helping an organization with the Logical Design of an NSX-T Data Center solution.

This information was gathered during the assessment:

There must be a performance based SLA for East – West traffic.

Which two key performance features should the architect recommend? (Choose two.)

A.
Configure N-VDS enhanced Data Path
A.
Configure N-VDS enhanced Data Path
Answers
B.
Install advanced Edge pNIC Features
B.
Install advanced Edge pNIC Features
Answers
C.
Setup RSS to leverage multiple cores
C.
Setup RSS to leverage multiple cores
Answers
D.
Leverage DPDK drivers
D.
Leverage DPDK drivers
Answers
E.
Enable GENEVE Offload
E.
Enable GENEVE Offload
Answers
Suggested answer: C, E

Which two VMware recommendations should an architect follow when configuring top of rack (ToR) switches in an NSX-T Data Center environment? (Choose two.)

A.
Use only IPv4 addressing in all deployments.
A.
Use only IPv4 addressing in all deployments.
Answers
B.
Configure redundant physical switches to enhance availability.
B.
Configure redundant physical switches to enhance availability.
Answers
C.
Configure switch ports that connect to ESXi host manually as trunk ports.
C.
Configure switch ports that connect to ESXi host manually as trunk ports.
Answers
D.
Configure switch ports with a Dynamic Trunking Protocol.
D.
Configure switch ports with a Dynamic Trunking Protocol.
Answers
E.
Modify the Spanning Tree Protocol to increase the time to transition to the forwarding state.Answer: DE
E.
Modify the Spanning Tree Protocol to increase the time to transition to the forwarding state.Answer: DE
Answers
Suggested answer: D, E

A Solutions Architect is working with a customer which wants to extend their traditional Telco IP/MPLS core network to an NFV cloud.

Which NSX-T Data Center feature can be recommended by the architect? (Choose the best answer.)

A.
Distributed IDS
A.
Distributed IDS
Answers
B.
EVPN
B.
EVPN
Answers
C.
Load Balancer
C.
Load Balancer
Answers
D.
BGPAnswer: D
D.
BGPAnswer: D
Answers
Suggested answer: D

An NSX-T architect is working with a customer who wants to improve performance and future-proof their workloads with a multi-site architecture.

A current-state analysis captured this information:

Latency between sites is 160ms.

Bandwidth is 2Gbps.

The MTU is 1600.

What two VMware design recommendations should the architect recommend to the organization to achieve future-proofing? (Choose two.)

A.
MTU is recommended to be 9000.
A.
MTU is recommended to be 9000.
Answers
B.
MTU must be at least 1700.
B.
MTU must be at least 1700.
Answers
C.
Bandwidth must be at least 10Gbps.
C.
Bandwidth must be at least 10Gbps.
Answers
D.
Latency RTT is acceptable.
D.
Latency RTT is acceptable.
Answers
E.
Latency must be less than 150ms.
E.
Latency must be less than 150ms.
Answers
Suggested answer: A, E

An architect is helping an organization with the Conceptual Design of an NSX-T Data Center solution.

This information was gathered by the architect during the Discover Task of the Engagement Lifecycle:

There are applications which use IPv6 addressing.

Network administrators are not familiar with NSX-T Data Center solutions.

Hosts can only be configured with two physical NICs.

There is an existing management cluster to deploy the NSX-T components.

Dynamic routing should be configured between the physical and virtual network.

There is a storage array available to deploy NSX-T components.

Which two requirements were documented by the architect? (Choose two.)

A.
There are applications which use IPv6 addressing.
A.
There are applications which use IPv6 addressing.
Answers
B.
Dynamic routing should be configured between the physical and virtual network.
B.
Dynamic routing should be configured between the physical and virtual network.
Answers
C.
Hosts can only be configured with two physical NICs.
C.
Hosts can only be configured with two physical NICs.
Answers
D.
The storage array has enough capacity to deploy NSX components.
D.
The storage array has enough capacity to deploy NSX components.
Answers
E.
Network administrators are not familiar with NSX-T Data Center solutions.
E.
Network administrators are not familiar with NSX-T Data Center solutions.
Answers
Suggested answer: B, D

An NSX-T Architect is working in a brownfield environment with 4 ESXi hosts. These constraints were documented: new servers cannot be purchased North/South bandwidth must be guaranteed Top-of-Rack switches have additional uplinks Which three recommendations should the architect implement? (Choose three.)

A.
Remove one of the ESXi hosts and install a bare-metal Edge.
A.
Remove one of the ESXi hosts and install a bare-metal Edge.
Answers
B.
Use a resource pool for production workloads.
B.
Use a resource pool for production workloads.
Answers
C.
Use a resource pool to deploy the Edge nodes on.
C.
Use a resource pool to deploy the Edge nodes on.
Answers
D.
Recommend obtaining 2 new physical NICs for the servers.
D.
Recommend obtaining 2 new physical NICs for the servers.
Answers
E.
Install Edge nodes on a separate cluster.
E.
Install Edge nodes on a separate cluster.
Answers
Suggested answer: A, C, D

An architect is helping an organization with the Physical Design of an NSX-T Data Center solution.

This information was gathered during the Assessment Phase:

There is a critical application used by the Finance Team.

The critical application has an availability and recoverability SLA of 99.999%.

The critical application is sensitive to network changes.

Which two selections should an architect include in their design? (Choose two.)

A.
Configure Tier-0 gateway for eBGP and ECMP.
A.
Configure Tier-0 gateway for eBGP and ECMP.
Answers
B.
Configure Tier-1 gateway for eBGP and ECMP.
B.
Configure Tier-1 gateway for eBGP and ECMP.
Answers
C.
Enable BFD on Tier-0 gateway.
C.
Enable BFD on Tier-0 gateway.
Answers
D.
Install and configure hosts with 100Gbps physical NICs.
D.
Install and configure hosts with 100Gbps physical NICs.
Answers
E.
Configure multiple static routes on Tier-1 gateway.
E.
Configure multiple static routes on Tier-1 gateway.
Answers
Suggested answer: B, D

Which two protocols are typically used for multicast in a NSX-T Data Center environment? (Choose two.)

A.
PIM Full Form
A.
PIM Full Form
Answers
B.
PIM Dense Mode
B.
PIM Dense Mode
Answers
C.
IGMPv2
C.
IGMPv2
Answers
D.
PIM Sparse mode
D.
PIM Sparse mode
Answers
E.
IGMPv3Answer: CD
E.
IGMPv3Answer: CD
Answers
Suggested answer: C, D
Total 57 questions
Go to page: of 6