Cisco 400-007 Practice Test - Questions Answers, Page 30

The General Bank of Greece plans to upgrade its legacy end-of-life WAN network with a new flexible, manageable, and scalable solution. The mam requirements are ZTP support, end-to-end encryption application awareness and segmentation. The CTO states that the main goal of the bank is CAPEX reduction. Which WAN technology should be used for the solution?

A software-defined networking (SDN) controller teams network topology information by using BGP link-state sessions with the route reflectors of an MPLS-enabled network. The controller then uses the topology information to apply on-demand traffic policies to the network through a protocol that is supported from all Layer 3 routers Each policy is represented as a RIB entry in the control plane of the router Which SDN model has been implemented?

When consumers that leverage laaS reach 100% resource capacity, what can be used to redirect the overflow of traffic to the public cloud so there is no disruption to service?

Enterprise XYZ wants to implement fast convergence on their network and optimize timers for OSPF However they also want to prevent excess flooding of LSAs if there is a constantly flapping link on the network Which timers can help prevent excess flooding of LSAs for OSPF?

What is the most important operational driver when building a resilient and secure modular network design?

A business wants to centralize services via VDI technology and to replace remote WAN desktop PCs with thin client-type machines to reduce operating costs Which consideration supports the new business requirement?

Refer to the exhibit.

Company XYZ BGP topology is as shown in the diagram. The interface on the LA router connected toward the 10.1.5.0/24 network is faulty and is going up and down, which affects the entire routing domain. Which routing technique can be used in the routing policy design so that the rest of the network is not affected by the flapping issue?

A consultant needs to evaluate project management methodologies for a new service deployment on the existing network of a customer. The customer wants to be involved in the end-to-end project progress and be provided with frequent updates. The customer also wants the ability to change the requirements if needed, as the project progresses. Which project management methodology should be used?

In a redundant hub and spoke 'wheel' design, all spokes are connected to the hub, and spokes are connected to other spokes as well. During failure on one spoke link, the traffic from that site can be sent to a neighboring site for it to be forwarded to the hub site. But during peak hours, a link is overloaded and traffic is re-routed to a neighbor, which subsequently becomes overloaded. This overload results in network traffic oscillation as the load varies at each spoke site. This design provides more redundancy but not more resiliency because the routing protocol must process many alternate paths to determine the lowest cost path. Which two design changes help to improve resilience in this case? (Choose two.)