Juniper JN0-363 Practice Test - Questions Answers, Page 2

An Integrated Routing and Bridging (IRB) interface is used to provide Layer 3 routing services to hosts within a bridge domain. The IRB acts as a default gateway for hosts in that domain, enabling communication with other networks.

Juniper Networks Technical Documentation on IRB Interfaces

The exhibit shows that the Label Switched Path (LSP) is down. One common reason for this could be that the IGP is not providing traffic engineering information to the MPLS process. Since the exhibit shows the OSPF configuration, enabling traffic engineering extensions for OSPF would allow OSPF to distribute the labels and traffic engineering information necessary for LSP establishment.

Juniper Networks Technical Documentation on MPLS and OSPF

https://supportportal.juniper.net/s/article/EX-Identify-the-Root-Bridge-in-a-Spanning-Tree-STP-network?language=en_US The root bridge in a spanning-tree network is the bridge with the smallest or the lowest bridge ID.

In the absence of a manually configured priority, the Spanning Tree Protocol (STP) elects the root bridge based on the lowest bridge ID, which is a combination of the priority and the MAC address. The device with the lowest MAC address will have the lowest bridge ID and thus be elected as the root bridge.

Juniper Networks Technical Documentation on STP

https://www.networkfuntimes.com/junos-aggregate-routes-vs-generate-routes-how-to-summarise-on-juniper-routers/

Generated routes are a type of route that can be created to summarize and generate more specific routes within the routing table. Unlike aggregate routes, which summarize existing routes and inherit a next-hop, generated routes do not necessarily have to match an existing route and will have a next-hop of reject by default unless specified otherwise.

Juniper Networks Technical Documentation on Routing Policies and Route Generation

The FE80::/10 prefix is reserved for IPv6 link-local addresses. These addresses are auto-configured on all IPv6-enabled interfaces and can be used for communication within the local link (subnet) only.

Juniper Networks Technical Documentation on IPv6 Addressing