In the early phase of a project, after the project requirements are clarified, the project owner should Checklist to describe the customer's requirements. (Capitalize the first letter of each word.)

Customer Requirement Specification

Which of the following statements are true about the WLAN site survey In different typical scenarios? (Select All that Apply)

In a classroom scenario. If the walls are made of reinforced concrete, the signal attenuation Is high. In this case, you are advised to test the attenuation during the site survey. Additionally, pay attention to the locations of ELV rooms in the teaching building.

In an office scenario, the load-bearing columns and partitions affect the signal coverage. If an integrated ceiling is used, deploy APs near maintenance entrances. If a metal ceiling is used, mount APs on the ceiling or wall.

In a ward-round scenario, high requirements are posed on the coverage field strength, roaming effect, and bandwidth. Determine the interference of medical equipment and the areas where Wi-Fi signals are not allowed.

In a stadium scenario, the onsite environment is complex and cabling is difficult. Therefore, confirm with the property management company about ELV rooms and cabling. If the transmission distance is too long, consider deploying more switches. During the survey, focus on the interference between APs and AP mounting modes.

In a classroom scenario. If the walls are made of reinforced concrete, the signal attenuation Is high. In this case, you are advised to test the attenuation during the site survey. Additionally, pay attention to the locations of ELV rooms in the teaching building.

In an office scenario, the load-bearing columns and partitions affect the signal coverage. If an integrated ceiling is used, deploy APs near maintenance entrances. If a metal ceiling is used, mount APs on the ceiling or wall.

In a ward-round scenario, high requirements are posed on the coverage field strength, roaming effect, and bandwidth. Determine the interference of medical equipment and the areas where Wi-Fi signals are not allowed.

In a stadium scenario, the onsite environment is complex and cabling is difficult. Therefore, confirm with the property management company about ELV rooms and cabling. If the transmission distance is too long, consider deploying more switches. During the survey, focus on the interference between APs and AP mounting modes.

Which of the following statements about WLAN roaming and signal strength Is false?

Generally, a STA roams when it detects that the signal strength is less than -75 dBm.

Smart roaming can be enabled on the WAC to help ST As roam and associate with APs with better signals.

Generally, a STA roams when it detects that the signal strength is less than -75 dBm.

STAs can roam between WACs in dual-link HSB mode.

In most cases, the signal strength of a STA should range from -45 dBm to -65 dBm.

After the HTTP domain name is entered in a browser, the user Is not redirected to the Portal URL.Which of the followings is the possible cause for this failure? (Select All that Apply)

The DNS server IP address is not added to the authentication-free rule.

The URL template is incorrectly configured.

The web server is incorrectly configured.

The DNS server IP address is not added to the authentication-free rule.

The URL template is incorrectly configured.

The web server is incorrectly configured.

Which of the following configurations may cause ST As to experience a slow Internet connection?(Select All that Apply)

QoS CAR is configured in the traffic profile.

TKIP encryption is configured, causing a low link setup rate.

Rate limiting is configured in the SSID profile.

QoS CAR is configured in the traffic profile.

TKIP encryption is configured, causing a low link setup rate.

Rate limiting is configured in the SSID profile.

Which of the following statements about the access layer design are true when Huawei's CloudCampus Solution is applied to small and midsize campus networks? (Select All that Apply)

When selecting a switch, ensure that the following condition is met; Number of connected APs x AP power ^ Power provided by the PoE switch. Therefore, select PoE switches with a proper power supply based on the AP model and quantity.

Select appropriate models of access switches based on whether PoE support is required and how many APs need to access the network.

In the mini-store scenario, APs and egress devices must be deployed if Wi-Fi coverage is required.APs cannot directly connect to egress links and do not support NAT.

When selecting a switch, ensure that the following condition is met; Number of connected APs x AP power ^ Power provided by the PoE switch. Therefore, select PoE switches with a proper power supply based on the AP model and quantity.

Select appropriate models of access switches based on whether PoE support is required and how many APs need to access the network.

For relatively large networks in midsize shopping malls, supermarkets, and primary/secondary education campuses, it is recommended that stack networking be used at the access layer. If a single device can provide sufficient access capacity for downstream terminals, single-device networking can be used at the access layer. If the upstream devices of access-layer devices are stacked, it is recommended that Eth-Trunks be used to connect to such upstream devices. If more APs need to be deployed, use the PoE switch to increase the number of APs to be connected.

On a campus network, which of the following problems may occur when you manually create a static VXLAN tunnel? (Select All that Apply)

Although the static VXLAN tunnel mode supports the distributed gateway scenario, the configuration involves a heavy workload and is complex to adjust.

If N devices need to establish VXLAN tunnels, you need to manually configure the ingress replication list up to N x (N-l)/2 times.

Although the static VXLAN tunnel mode supports the distributed gateway scenario, the configuration involves a heavy workload and is complex to adjust.

A static VXLAN tunnel uses related protocols on the control plane, consuming device resources.

If N devices need to establish VXLAN tunnels, you need to manually configure the ingress replication list up to N x (N-l)/2 times.

Remote MAC addresses can be learned only through data flooding.

Which of the following statements about VXLAN is false?

Layer 2 and Layer 3 VXLAN gateways must maintain VBDIF interfaces. Otherwise, users cannot communicate with each other through these interfaces.

A Layer 2 VXLAN gateway forwards traffic to a VXLAN network and can also be used for Intrasubnet communication on the same VXLAN network.

Layer 2 and Layer 3 VXLAN gateways must maintain VBDIF interfaces. Otherwise, users cannot communicate with each other through these interfaces.

A VBDIF interface is a logical interface created based on a BD. It is similar to a VLANIF interface on a traditional network.

A Layer 3 VXLAN gateway is used for inter-subnet communication on a VXLAN network and communication with external non-VXLAN networks.

Which of the following statements are true about data collection of IMaster NCE-Campuslnslght?(Select All that Apply)

iMaster NCE-Campuslnsight uses telemetry to Implement efficient data collection.

To collect data from WLAN devices, ensure that WACs can communicate with the southbound IP address of iMaster NCE-Campuslnsight. APs do not need to communicate with the southbound IP address of iMaster NCE-Campuslnsight.

iMaster NCE-Campuslnsight uses telemetry to Implement efficient data collection.

Calculated data can be displayed on iMaster NCE-Campuslnsight only after a license Is loaded on the device management page.

To collect data from WLAN devices, ensure that WACs can communicate with the southbound IP address of iMaster NCE-Campuslnsight. APs do not need to communicate with the southbound IP address of iMaster NCE-Campuslnsight.

The UTC time of iMaster NCE-Campuslnsight must be the same as that of its managed devices.

Which of the following may be the reason why no data Is displayed on the telemetry management page of IMaster NCE-CampusInsight? (Select All that Apply) A. The network connecting devices and iMaster NCE-Campuslnsight Is faulty.

Telemetry data reporting is not configured on devices according to the configuration guide.

The UTC time of devices is inconsistent with that of iMaster NCE-Campuslnsight.

Telemetry data reporting is not configured on devices according to the configuration guide.

Devices are not added to iMaster NCE-Campuslnsight.

The UTC time of devices is inconsistent with that of iMaster NCE-Campuslnsight.

Huawei H12-351_V1.0 Practice Test 2 - Free Online Exam Prep & Questions

Spam

Selling illegal goods, money scams etc.

Hate Speech

Serious attack on a group.

Harassment and bullying

Harassing an individual (including doxing)

Harmful activities

Threatening or glorifying violence or serious harm, including self-harm

Adult content (Consensual)

Nudity/Sexual content

Sexual exploitation and abuse (child safety)

Sexually explicit or suggestive imagery or writing involving minors

Sexual exploitation and abuse (adults and animals)

Sexually explicit or suggestive imagery or writing involving non-consenting adults or non-humans

Plagiarism

Reusing content without attribution (link and blockquotes)

Poorly written

Not in English or has very bad formatting, grammar, and spelling

Inappropriate credential

Author's credential is offensive, spam, or impersonation

Other

Ex. Illegal content, incomplete question...

Huawei H12-351_V1.0 Practice Test 2

Question

Huawei H12-351_V1.0 Practice Tests

Practice Tests