Huawei H35-582 Practice Test – Member Shared Questions, Page 2

Question 11

During the VR service test, in order to maximize the downlink peak value of the cell, which of the following measures can be adopted?

A.

Ensure the downlink LOS environment

B.

Adjust the DMRS type of PDSCH to Type1

C.

Adjust the time slot ratio from 8:2 to 7:3

D.

Adjust the maximum number of downstream scheduled streams to 4 streams or higher

Show Answer Comment (0)

Question 12

In the initial SCG addition process, which of the following messages is not included in the SgNB Addition Request messa ge sent by the MeNB to the SgNB?

A.

Split bearer mode (MCG or SCG Split Bearer)

B.

SgNB IP address

C.

Terminal NR related capabilities

D.

E-RAB information

Show Answer Comment (0)

Question 13

Which of the following is not a requirement for 5G fronthaul network transmission?

A.

eCPRI mainstream interface rate 25Gbps

B.

The one-way delay requirement is less than 100µs

C.

The packet loss rate is 0

D.

The clock accuracy is ±65ns

Show Answer Comment (0)

Question 14

Assuming that the primary synchronization code of NR cell A is 1, and the secondary synchronization code is 2, which of t he following is the PCI of cell A?

A.

2

B.

5

C.

3

D.

7

Show Answer Comment (0)

Question 15

Which of the following descriptions of related parameters in NSA Option3x networking is wrong?

A.

The PDCP sequence length of LTE and NR must be consistent with the RLC mode

B.

LTE and NR offload bearers use different QCIs

C.

The SSB frequency points configured for LTE and NR are the same

D.

You can configure the uplink data to be carried only on the LTE side

Show Answer Comment (0)

Question 16

In the NFV network architecture, which of the following items are included in the MANO component?

A.

VIM

B.

VNFM

C.

EMS

D.

NFVO

Show Answer Comment (0)

Question 17

What is wrong in the following description of the base station configuration?

A.

In a layer 3 network, the VLAN ID of the X2 interface of eNodeB and gNodeB must be the same for normal communication

B.

When configuring routing, if the destination address is a network segment, the mask of the destination address cannot be 32 bits

C.

SCTP port number is a negotiation parameter, you can plan it yourself within a certain range to ensure consistency at both ends

D.

The source address routing configuration has nothing to do with the IP of the opposite end, so the opposite end does not need to configure routing, and normal communication can also be guaranteed

Show Answer Comment (0)

Question 18

Which of the following parameters are used for PRACH power control?

A.

PRACH-configuration index

B.

preambleTransMax

C.

Pathloss

D.

PwrRampingStep

Show Answer Comment (0)

Question 19

What physical layer processing does the uplink CP-OFDM and DFT-S-OFDM waveforms go through?

A.

Modulation

B.

Scrambling

C.

Transformer Precoding

D.

Layer mapper

Show Answer Comment (0)

Question 20

In SA networking, what reasons may cause NRDUCELL to fail to establish?

A.

AAU hardware failure

B.

NG interface failure

C.

External clock is not available

D.

Insufficient license

Show Answer Comment (0)

Huawei H35-582 Practice Test - Questions Answers, Page 2

List of questions

Question 11

Question 12

Question 13

Question 14

Question 15

Question 16

Question 17

Question 18

Question 19

Question 20

Related questions

Huawei H35-582 Practice Test - Questions Answers, Page 2

List of questions

Question 11

Question 12

Question 13

Question 14

Question 15

Question 16

Question 17

Question 18

Question 19

Question 20

Question

Case Study

Drag and Drop

Hot Area

Related questions

Export

Practice Tests