HP HPE0-J68 Practice Test - Questions Answers, Page 10

List of questions
Question 91

A customer needs to be manually map out preferred paths within a multi-switch fabric, based on application ,priority ,and topology, while allowing failover to a non-preferred path if the preferred path fails, Which B-series FC switch functionality should be used to provide this?
Question 92

What allows volume level data to be copied between an HPE 3PAR and an HPE store Virtual VSA?
Question 93

A customer has an excisting environment with 3PAR,Nimble and MS
Question 94

Which statement describes HPE StoreVirtual Network RAID functionality?
Question 95

During a proof-of-concept you need to implement an inter-switch-link (ISL)between two HPE
SN6000B switches. Which port mode must be set enable communication between the switches?
Question 96

In an ISCSI based storage system Proof-Of-Concept project ,the customer is not satisfied with the performance of their video streaming application .What would you recommended to the customer to optimize the excisting environment?
Question 97

You are designing a new HPE 3PAR StoreServ all-flash array for the customer.. Which ratio should you expect to have the highest efficiency?
Question 98

A customer need to update the local sever at each of their branches keep up with the increasing demand for High-performance storage. The customer cannot afford to move to SAN at each state. Which HPE storage technology can increase performance for this customer?
Question 99

Refer to the exhibit:
Which type of data format do you expect in the red rectangle?
Question 100

Which 3PAR storeServ feature allow to host to continue I/O uninterrupted during a firmware update?
Question