ExamGecko
Search Search Login
Home Home / DELL / D-PSC-MN-01
Question list
Search
Search

List of questions

Search
Open VPLUS File
Convert VPLUS to PDF

Related questions

A platform engineer needs to swap an NVDIMM battery. What prerequisite conditions are required to prevent data loss when removing the NVDIMM battery?
Exhibit. A platform engineer has connected power cables to a Dell PowerScale Gen6 node. What does the status indicator indicate?
Which cable is required to connect to the A300 console?
A customer received replacement parts from Dell without prior communication. Why did they receive the replacement parts?
A customer wants to add SSDs to the drive sleds in a Dell PowerScale H600 node for higher storage performance. What should the platform engineer tell the customer?
Refer to the exhibit. An engineer replaced the drive in C1. They run the isi devices drive list command and obtain the output that is shown. What action must the engineer take?
An existing PowerScale cluster consists of four A300 and three F600 nodes. What is the minimum number of nodes an engineer can add to expand both node pools?
What is a consideration when reimaging a Dell PowerScale node?
A platform engineer is tasked with adding F600 nodes to an existing Dell EMC PowerScale cluster. After racking and stacking the F600 nodes, they determine that the cluster contains X210 and H400 nodes. What should the platform engineer consider?
Which statement is accurate regarding Dell EMC PowerScale hardware platforms?

Question 8 - D-PSC-MN-01 discussion

Report
Export

A platform engineer has created a cluster of 8 F200 nodes. A requirement is for each power supply on each node to supply power to the respective node equally.

What must the platform engineer do to meet the requirement?

A.

Run the isi config and change the settings in the config subsystem

Answers
A.

Run the isi config and change the settings in the config subsystem

B.

Cable each node power connection to a different PDU in the rack

Answers
B.

Cable each node power connection to a different PDU in the rack

C.

Use the iDRAC settings on each node to disable the hot spare feature

Answers
C.

Use the iDRAC settings on each node to disable the hot spare feature

D.

Run the isi set -n command to change the power supply behavior

Answers
D.

Run the isi set -n command to change the power supply behavior

Suggested answer: C

Explanation:

By default, the Power Supply Hot Spare feature may cause one power supply to run while the other is idle.

Steps to Ensure Equal Power Supply Loading:

Access iDRAC Interface:

Log into the iDRAC for each F200 node.

Disable Hot Spare Feature:

Navigate to Power Management settings.

Disable the Power Supply Hot Spare option.

Result:

Both power supplies will share the load equally.

Dell PowerScale

Reference:

Dell EMC PowerScale F200 Hardware Guide:

Power Supply Configuration:

Instructions on adjusting power supply settings via iDRAC.

Best Practices:

Ensure redundancy by connecting power supplies to separate PDUs.

Monitor power usage to confirm balanced loading.

Show Answer
asked 29/10/2024
Venkata Shiva Rajesh Boyinapalli
40 questions
PreviousPreviousNextNext
User
Your answer:
0 comments
Sorted by

Leave a comment first

ExamGecko

Copyright @2023 ExamGecko | All right reserved

Mail us: [email protected]
About us
Contact us
Twitter X
Facebook
Medium
Convert VPLUS to PDF
Open VPLUS files Easily and Quickly
Privacy Policy
Disclaimer
Terms