Home / Citrix / 1Y0-241

Citrix 1Y0-241 Practice Test - Questions Answers, Page 5

Question list

List of questions

Question 41

(0)

Scenario: A Citrix Administrator configured a responder policy as follows: > add responder action Redirect_Act respondwith “DIAMETER.NEW_REDIRECT(\”aaa://host.example.com\”)” > add responde

Question 42

(0)

A Citrix Administrator needs to protect the HTTP backend server type without actually removing theheader. Which rewrite action type can the administrator apply to the Citrix ADC configuration to ac

Question 43

(0)

The Citrix ADC SDX architecture allows instances to share ___________ and __________. (Choose the two correct options to complete the sentence.)

Question 44

(0)

Which mode does a Citrix Administrator need to configure to allow a Citrix ADC to control the packetforwarding function based on the route table lookups?

Question 45

(0)

Question 46

(0)

Scenario: A load-balancing vServer is configured to utilize the least bandwidth load-balancing method. A service attached to this vServer is brought into the effective state during production hours.

Question 47

(0)

Scenario: A Citrix Administrator manages an environment that has a Citrix ADC high availability (HA) pair running on two MPX appliances. The administrator notices that the state of the secondary Cit

Question 48

(0)

Scenario: A Citrix ADC receives packets destined for a MAC address owned by the Citrix ADC. The destination IP address of the packets does NOT belong to the Citrix ADC. Layer 3 mode is enabled by de

Question 49

(0)

Which two protocols would provide end-to-end data encryption, while allowing a Citrix ADC to optimize the responses? (Choose two.)

Question 50

(0)

set gslb vServer-GSLB-1-MIR ENABLED What will the Citrix ADC appliance send when the above command is executed?

Related questions

In a global server load balancing (GSLB) active-active environment, the connection proxy is used as the site persistence method. What is used to source the traffic when the connection is proxied?

Scenario: The primary content switching vServer has gone down. To troubleshoot, a Citrix Administrator has issued the following command: > show csvserver CSV CSV (10.1.100.100:443) – HTTPS Type: CONTENT State: UP Last state change was at Mon Jun 29 15:20:43 2020 Time since last state change: 1 day, 06:47:58 610 Client Idle Timeout: 180 sec Down state flush: ENABLED Disable Primary vServer On Down: DISABLED Appflow logging: ENABLED Port Rewrite: DISABLED State Update: DISABLED Default: Content Precedence: URL vServer IP and Port insertion: OFF Persistence: NONE redirect: http://www.site1.com/mysite1/maintenance Backup: vServer–LB–2 Listen Policy: NONE IcmpResponse: PASSIVE RHIstate: PASSIVE Traffic Domain: 0 Based on this output, where will the subsequent request be redirected?

Scenario: A load-balancing vServer is configured to utilize the least bandwidth load-balancing method. A service attached to this vServer is brought into the effective state during production hours. During the startup of a vServer, which load-balancing method is used by default?

Scenario: A Citrix Administrator is configuring a Citrix ADC high availability (HA) pair. The administrator needs to ensure that one Citrix ADC is UP and primary at all times to guarantee that business websites are always available. In the event that both nodes become unavailable or fail a health check, what does the administrator need to do to ensure that the Citrix ADCs still handle web traffic?

A Citrix Administrator needs to confirm that all client certificates presented to the authentication vServer are valid until the year 2023. Which expression can the administrator use to meet this requirement?

Scenario: A Citrix Administrator needs to configure persistence on a global server load balancing (GSLB) vServer to which a service is bound. Service must continue to handle requests from the client even after it is disabled manually – accepting new requests or connections only to honor persistence. After a configured period of time, no new requests or connections are directed to the service and all existing connections are closed. To achieve these requirements, which parameter can the administrator configure while disabling the service?

How can a Citrix Administrator configure a rewrite policy to change the version of HTTP from 1.1 to1.0 in every request?

Scenario: To receive data alerts for failures, a Citrix Administrator is configuring SNMP on the Citrix ADC. The administrator is confident that the manager, alarms and SNMP traps are configured correctly. The following week, there is a Citrix ADC-related outage and the administrator does NOT receive any alerts. What could be the reason for this alert failure?

Where do the monitor probes originate by default, after creating and correctly configuring a custom user monitor?

Question 41

Scenario: A Citrix Administrator configured a responder policy as follows:

> add responder action Redirect_Act respondwith

“DIAMETER.NEW_REDIRECT(\”aaa://host.example.com\”)”

> add responder policy Redirect_Pol “diameter.req.avp(264).value.eq(\”host1.example.net\”)” Redirect_Act

> bind lb vServer vs1 –policyName Redirect_Pol –priority 10 –type REQUEST What will be the effect of this configuration?

Request originated from “host1.example.net” will be redirected to “host.example.com”.

Response originated from “host1.example.net” will be redirected to “host.example.com”.

Response originated from “host.example.net” will be redirected to “host1.example.com”.

Request originated from “host.example.net” will be redirected to “host1.example.com”.

Show Answer Comment (0)

Question 42

A Citrix Administrator needs to protect the HTTP backend server type without actually removing theheader.

Which rewrite action type can the administrator apply to the Citrix ADC configuration to accomplish this?

REPLACE

CORRUPT_HTTP_HEADER

REPLACE_HTTP_REQ

REPLACE_ALL

Show Answer Comment (0)

Question 43

The Citrix ADC SDX architecture allows instances to share ___________ and __________. (Choose the two correct options to complete the sentence.)

memory

a CPU

a physical interface

the kernel

Show Answer Comment (0)

Question 44

Which mode does a Citrix Administrator need to configure to allow a Citrix ADC to control the packetforwarding function based on the route table lookups?

MBF

USIP

Layer 2

Layer 3

Show Answer Comment (0)

Scenario: A Citrix Administrator executed the command below in an active-active, global server load balancing (GSLB) setup. set gslb parameter –ldnsprobeOrder DNS PING TCP The order to calculate the _____ for dynamic proximity will be the DNS UDP query followed by the ping and then TCP. (Choose the correct option to complete the sentence.)

Time to live (TTL)

Empty Domain Service (EDS)

Multiple IP responses (MIR)

Round-trip time (RTT)

Show Answer Comment (0)

Question 46

Scenario: A load-balancing vServer is configured to utilize the least bandwidth load-balancing method. A service attached to this vServer is brought into the effective state during production hours.

During the startup of a vServer, which load-balancing method is used by default?

Least connections

Least bandwidth

Custom load

Round-robin

Show Answer Comment (0)

Question 47

Scenario: A Citrix Administrator manages an environment that has a Citrix ADC high availability (HA) pair running on two MPX appliances. The administrator notices that the state of the secondary Citrix ADC is ‘Unknown’.

What is causing the secondary state to be ‘Unknown’?

The synchronization on the secondary appliance is disabled.

TCP port 22 is disabled between the primary and secondary ADCs.

The administrator made both Citrix ADCs primary.

The remote procedure call (RPC) nodes are incorrectly configured.

Show Answer Comment (0)

Question 48

Scenario: A Citrix ADC receives packets destined for a MAC address owned by the Citrix ADC. The destination IP address of the packets does NOT belong to the Citrix ADC. Layer 3 mode is enabled by default on the Citrix ADC.

The Citrix ADC will __________ the packets in this scenario. (Choose the correct option to complete the sentence.)

route

process

bridge

drop

Show Answer Comment (0)