AP The systematic process of radio frequency resource management is ().

Acquisition -> Analysis -> Decision -> Execution

Acquisition -> Decision -> Analysis -> Execution

Analysis -> Acquisition -> Decision -> Execution

Acquisition -> Analysis -> Execution -> Decision

Acquisition -> Analysis -> Decision -> Execution

about 5G The working principle of priority, the following statement is correct ().

5G Priority request AP Is dual frequency AP Can work normally

5G Priority characteristics refer to 5G Client sends data first

5G After the priority is turned on, only support 2.4G The network transmission speed of the client will be slower

5G Priority request AP Is dual frequency AP Can work normally

5G Priority requires all clients to support at the same time

How to set the condition of switching trigger (). (Select 2 Answers)

Set current AP With neighbors AP Signal strength ratio, switch when reaching the threshold

Check the packet loss rate and start the handover when the packet loss rate reaches a certain value

when STA Yohara AP Start switching after reaching a certain distance

Set current AP With neighbors AP Signal strength ratio, switch when reaching the threshold

Check the packet loss rate and start the handover when the packet loss rate reaches a certain value

Yohara AP Start the switch when the network speed is very slow during association

Among the following options, () is the reason for using 5G priority access.

5G frequency band can provide better access capability and capacity

It is easier to make network planning in the 5G frequency band

5G frequency band can provide better access capability and capacity

The connection speed between users and APs in the 5G frequency band is very fast

The transmission rate of the 5G frequency band is higher than that of the 2.4G frequency band

The following statement about the AP access control method is incorrect ().(Select 2 Answers)

By default, the control method for AP to access AC is non-authentication

By configuring the AP in an offline state, authentication is required to automatically access

By default, the control method for AP to access AC is non-authentication

By configuring the AP in an offline state, authentication is required to automatically access

The configuration whitelist can be authenticated based on MAC or SN

If MAC authentication is used for AP access control, APs outside of the MAC authentication list can also go online after manual confirmation

About Huawei WLAN Description of the characteristics of the product, the following statement is correct ().

WLAN The switching threshold of load balancing has two configurations based on the number of users and the number of sessions.

Wireless controllers can achieve high availability through stacking

Huawei AP The radio frequency tuning function is divided into global tuning and local tuning. The local tuning is AP Done independently

WLAN The switching threshold of load balancing has two configurations based on the number of users and the number of sessions.

After dual-link backup is configured, if the user adopts the tunnel forwarding mode, even if it is active AC User services will not be interrupted after failure and restart

In the following options, () is not the main purpose of roaming.

Ensure that the user's network rate remains unchanged

Avoid long authentication time during roaming, resulting in packet loss or even business interruption

Ensure that the user authorization information remains unchanged

Guarantee users IP The address remains unchanged

Ensure that the user's network rate remains unchanged

Which of the following are the relevant parameters of the Traffic template ().(Select 2 Answers)

802.3 priority mapping strategy

Tunnel priority mapping strategy

802.3 priority mapping strategy

Tunnel priority mapping strategy

STA issued 802.11 Message to pass AP When entering the Ethernet, it is converted to 802.3 Packets that are not in the priority mapping method are().

Arrive according to the message AP Precedence

According to different VAP Set different priorities

Arrive according to the message AP Precedence

according to UP Map to priority

Int-Serv The model provides users with end-to-end absolute

Not conducive to traffic monitoring

Is the following statement about the introduction of frequency planning correct ()?(Select 2 Answers)

2.4GHz generally uses 1, 6, 11 three non-overlapping channels for coverage

If the AP is dual-band, it is recommended to use the 5G priority function

2.4GHz generally uses 1, 6, 11 three non-overlapping channels for coverage

In China, 5GHz generally has 23 non-overlapping channels available

Microwave interference will occur in the entire 2.4GHz frequency band

If the AP is dual-band, it is recommended to use the 5G priority function

The gain of the antenna can be explained ().

The antenna's ability to collect or emit electromagnetic waves in a certain direction is strong or weak

Antenna's ability to amplify high-frequency electrical signals

The antenna's ability to collect or emit electromagnetic waves in a certain direction is strong or weak

Ability to amplify electromagnetic waves

The antenna's ability to collect or emit electromagnetic waves in all directions is strong or weak

Among the following options, the common WLAN The source of interference is ().(Select 3 Answers)

Bluetooth transmission equipment

AC Perform the load balancing process according to () information.

STA Periodically report the current associated AP Logo

AP Periodically to AC Send its associated STA Information

STA Periodically report the current associated AP Logo

AC Timed query AP Associated STA number

STA Periodically search the surrounding AP Information and through association AP Report AP Logo

Among the following options, () is a prerequisite for enabling Huawei's load balancing function.

AP In the same AC Under management, and AP Signal overlap

STA Can scan to each other for load balancing AP

AP The output power settings are the same

It can be connected with the antenna via ().

50 ohm RF coaxial cable Coaxial cable

Huawei H12-311_V3.0 Practice Test 6 - Free Online Exam Questions 201-240

Spam

Selling illegal goods, money scams etc.

Hate Speech

Serious attack on a group.

Harassment and bullying

Harassing an individual (including doxing)

Harmful activities

Threatening or glorifying violence or serious harm, including self-harm

Adult content (Consensual)

Nudity/Sexual content

Sexual exploitation and abuse (child safety)

Sexually explicit or suggestive imagery or writing involving minors

Sexual exploitation and abuse (adults and animals)

Sexually explicit or suggestive imagery or writing involving non-consenting adults or non-humans

Plagiarism

Reusing content without attribution (link and blockquotes)

Poorly written

Not in English or has very bad formatting, grammar, and spelling

Inappropriate credential

Author's credential is offensive, spam, or impersonation

Other

Ex. Illegal content, incomplete question...

Huawei H12-311_V3.0 Practice Test 6

Question

Drag and Drop

Hot Area

Huawei H12-311_V3.0 Practice Tests

Practice Tests