Huawei H13-629 Practice Test - Questions Answers, Page 15
Question list
List of questions
Related questions
Customers set up a vio server environment on an IBM server, and the storage devices connected to the server through vio server provide storage space to a virtual partition in the server. Customers buy Huawei Oceanstor18000 deposit Storage and plan to replace the original storage device. What is the recommended best practice?
In a customer environment with SuSE 10SP3, HBA QLogic QLE2562, using the operating system comes with HBA card driver. The storage array is Huawei OceanStor V3 storage. When storing the FC host port on the system and the HBA on the host. When the card port mode is inconsistent, it is usually recommended to modify the FC host port mode on the storage side to solve the problem.
Which description of OceanStor V3 storage system tuning process is incorrect?
When you install the Simpana backup client on a virtual machine and perform a backup, the backup job status becomes pending and reports an error message "Cannot decode packet header: invalid start signature ", which of the following may be the cause of this problem?
The peak write bandwidth for an application is 10MB / S, with an average write latency of 200KB / s and an average write IO size of 4KB (bandwidth utilization of 70%).
If you need to use OceanStor V3 storage array to implement data disaster recovery and set it as asynchronous replication mode, you need the minimum network-wide bandwidth of which of the following?
When the storage controller BBU is damaged, the controller automatically sets the IO write policy to transparent and is locked to ensure data reliability. Before the fault is recovered, it can be forced to write back.
VMware's storage resources can be provided through VMFS, native direct-attached storage via ESXi host-FC / FCOE or iSCSI link of the shared storage. You can also share the file system over the NFS network to support third-party NAS storage.
The OceanStor 18500 uses the RAID 2.0 virtualization architecture. When planning to configure storage, which of the following is incorrect?
OceanStor V3 does not start up normally within 15 minutes after the system is powered on. What can you use to log in to the storage system in order to locate this fault? (Multiple choice.)
The figure shows an N8500 (V200R001) NAS engine chassis. The two NAS engine nodes in the chassis form a two-node N8500 NAS cluster. Which description of the front-end and back-end network planning of the cluster is correct. (Multiple choice.)
Question