You need to provide a customer an action plan to update an ONTAP system after a security bulletin has been issued.In this scenario, how do you accomplish this task?

Download the target version and do a pre-check.

Use the Interoperability Matrix Tool.

Review the ONTAP 9 product page.

Download the target version and do a pre-check.

Use Upgrade Advisor on Active IQ.

What are two reasons to use VLANs in a NetApp storage solution?(Choose two.)

to isolate UDP traffic from TCP traffic

to isolate iSCSI traffic from NAS traffic

to isolate UDP traffic from TCP traffic

to isolate management traffic from other IP traffic

to isolate iSCSI traffic from NAS traffic

to isolate FC traffic from other IP traffic

You are working on a fabric MetroCluster. After a site failure, the plex starts to resync automatically to the aggregate mirror of Aggr1. The plex now shows a status of resyncing. During this process, you experience a slow resync of the SyncMirror plex.In this scenario, how do you solve the problem?

Tune the resync speed by adding a QoS policy and limit the concurrent I/O to the aggregate.

Add more disks to the aggregate to add more I/O capacity.

Destroy and re-create plex, then run a baseline sync.

Tune the resync speed by adding a QoS policy and limit the concurrent I/O to the aggregate.

Tune the resync speed using the storage raid-options command.

When you replace a motherboard, which step will completely test the newly installed component?

From the LOADER prompt, type boot_ontap maint, then execute sldiag.

From the LOADER prompt, type boot_diags, then execute sldiag.

From the LOADER prompt, execute sldiag.

A disaster causes a FlexGroup volume to be unrecoverable, but it was protected by a SnapMirror relationship. You solve the issue, and the source is operational. Now, you want to return to serving the data from the original source.In this scenario, what do you do next?

Initialize the SnapMirror relationship.

Restore data from a backup copy.

Delete the SnapMirror relationship.

Which type of MetroCluster is shown in the exhibit?

4-node Fabric-Attached MetroCluster

You have an ONTAP 2-node cluster. You run a read/write test workload against an SMB share, and it is slower than you expected. You run the same test again, but this time you monitor the storage using a QoS command. Referring to the exhibit, what is the problem?

An HA interconnect problem is present.

The SMB read sizes should be increased.

The NVRAM needs to be replaced.

You have a 4-node MetroCluster system. A node needs to be taken down for maintenance, but all data needs to remain online.In this scenario, what should you do to bring down a single node?

Perform an HA takeover of the node.

Perform a MetroCluster switchover.

Disable HA on each side of the MetroCluster.

Perform an aggregate relocation of the CFO aggregates on the node.

What is the consequence of a loss of connectivity between a Cloud Volumes ONTAP (CVO) instance and Cloud Manager for four or more days?

Cloud Manager removes the CVO instance from its inventory.

The CVO instance sends an AutoSupport message.

The CVO instance must be added back manually to Cloud Manager.

Cloud Manager removes the CVO instance from its inventory.

What are two conditions that would cause writes in memory to be written to disk?(Choose two.)

Drive capacity becomes available.

Which two statements describe ONTAP NVRAM? (Choose two.)

ONTAP NVRAM stores uncommitted writes.

ONTAP NVRAM is used as write cache.

ONTAP NVRAM is used as read cache.

ONTAP NVRAM stores uncommitted writes.

ONTAP NVRAM is used as write cache.

Your Windows clients were able to access your CIFS SVM yesterday. Today they are no longer able to access the CIFS SVM on your NetApp cluster. Your IT security team just pushed out a new group policy to enhance security.In this scenario, which statement is true?

Your CIFS SVM is not using DNS.

Your CIFS SVM is configured to use SMBv1 and SMBv2.

Your CIFS SVM is configured for NFSv3 access.

Your CIFS SVM is configured for the wrong domain.

A volume was accidentally deleted two hours ago by another administrator. No backups exist.In this scenario, what do you do to restore the data?

Use the volume recovery queue to restore the volume.

Use the ONTAP System Manager to recover the volume.

Use a volume snapshot to return the data to the active file system.

Use the volume recovery queue to restore the volume.

Use an aggregate snapshot to revert the aggregate to an earlier state.

You are using AFF storage with the NVMe storage protocol on your Linux clients.In this scenario, which NVMe feature must be present and enabled for the client to see storage failover happen?

Asymmetric Namespace Access (ANA)

Asymmetric Logical Unit Access (ALUA)

You are asked to replicate 15 of 20 volumes and the network configuration of your storage virtual machine to your other data center.In this scenario, which NetApp technology should you use?

SVM peeringAnswer: AC ........................................................................................................................................................................................................................................................................................................................................... 2D ........................................................................................................................................................................................................................................................................................................................................................................................... 2

You want to set up a FabricPool between an ONTAP cluster and GoogleCloud Storage.In this scenario, which two components are required to accomplish this task? (Choose two.)

a Certificate Authority (CA) certificate

Test user "LAB\tester" can perform an operation in the CIFS share "HR" from the SVM "svm1". However, the rest of the users from the HR department cannot perform the same operation. You want to determine why only "LAB\tester" can perform the operation.In this scenario, which security trace filter accomplishes this task?

vserver security trace filter create -vserver svm1 -index 1 -protocol cifs -windows- name LAB\tester -trace-allow yes D. vserver security trace filter create -vserver svm1 -index 1 -protocol nfs -unix-name tester -trace-allow yes

vserver security trace filter create -vserver svm1 -index 1 -protocol nfs -unix-name tester -trace-allow no

vserver security trace filter create -vserver svm1 -index 1 -protocol cifs -windows- name LAB\tester -trace-allow no

vserver security trace filter create -vserver svm1 -index 1 -protocol cifs -windows- name LAB\tester -trace-allow yes D. vserver security trace filter create -vserver svm1 -index 1 -protocol nfs -unix-name tester -trace-allow yes

A customer asks what is the correct way to configure an ONTAP system for multi-tenancy.The customer wants to serve data and also protect data using SnapMirror from tenant A using network A and from tenant B using network B.In this scenario, which statement is correct?

This setup can only work if tenant A and tenant B use a shared network infrastructure.

The customer must use different VLANs for the two tenants.

This setup can only work if tenant A and tenant B use a shared network infrastructure.

The customer must set up two different IPspaces for the two tenants.

Each node can only communicate with tenant A or tenant B, but not with both at the same time.

Source Path Destination Path Relationship ID Relationship Type msgld: msragld: 78e304e0-9781-1234-abcd-00a098d771bd XDP msxpgld: msraxpgld: 3ca42ab4-9782-1234-abcd-00a098d771bd XDP na_docavgld: ndradocavgld: a4b233b2-9783-1234-abcd-00a098d771bd XDP na_dr: ndradr: c97d36a0-6d7c-11e8-83fb-00a098d771bd XDP na_gld: ndragld: 9e7e034d-9782-1234-abcd-00a098d771bd XDP na_mpgld: ndrampgld: 16e52e0d-9783-1234-abcd-00a098d771bd XDP na_opengld: ndraopengld: dabb1813-9780-1234-abcd-00a098d771bd XDP na_poc: ndrapoc: c1d632d7-977b-1234-abcd-00a098d771bd XDP na_pubgld: ndrapubgld: 1a3f866c-9780-1234-abcd-00a098d771bd XDPReferring to the output, which type of SnapMirror destination relationship is being used?

Single Volume SnapMirror Asynchronous

Single Volume SnapMirror Synchronous

Network Appliance NS0-194 Practice Test 1 - Free Online Exam Prep & Questions

For security reasons, you must track the access of files of a specific folder.

In this scenario, what should you do to accomplish this task from the storage side?

Implement a Vscan solution.

Use a cron job to save the audit log.

Use role-based access control to track access.

Implement an FPolicy solution.

Comment (0)

Network Appliance NS0-194 Practice Test 1

Question

Network Appliance NS0-194 Practice Tests

Practice Tests