Fortinet NSE8_812 Practice Test - Questions Answers, Page 10

A FortiGate is configured to perform outbound firewall authentication with Azure AD as a SAML IdP.

What are two valid interactions that occur when the client attempts to access the internet? (Choose two.)

Refer to the exhibits.

During the implementation of a Fortinet Security Fabric configuration, CLI commands were issued in the order shown in the exhibit. On the next day, the local admin for FGTC issues the following command:

FGTC # config system csf

set configuration-sync default

end

In this scenario, which outcome is true regarding the 'subnet_1' firewall address object on FGTC?

Which two types of interface have built-in active bypass in FortiDDoS devices? (Choose two.)

Refer to the exhibits, which show a network topology and VPN configuration.

A network administrator has been tasked with modifying the existing dial-up IPsec VPN infrastructure to detect the path quality to the remote endpoints.

After applying the configuration shown in the configuration exhibit, the VPN clients can still connect and access the protected 172.16.205.0/24 network, but no SLA information shows up for the client tunnels when issuing the diagnose sys link-monitor tunnel all command on the FortiGate CLI.

What is wrong with the configuration?

Refer to the exhibit.

A customer reports that they are not able to reach subnet 10.10.10.0/24 from their FortiGate device.

Based on the exhibit, what should you do to correct the situation?

A FortiGate must be configured to accept VoIP traffic which will include session initiation protocol (SIP) traffic. Which statement about the VoIP configuration options is correct?

Refer to the exhibits.

You must integrate a FortiMail and FortiSandbox Enhanced Cloud solution for a customer who is concerned about the e-mails being delayed for too long.

According to the configuration shown in the exhibits, which would be an expected behavior?

You have configured a Site-to-Site IPsec VPN tunnel between a FortiGate and a third-party device but notice that one of the error counters on the tunnel interface keeps increasing.

Which two configuration options can resolve this problem? (Choose two.)

A FortiGate deployment contains the following configuration:

What is the result of this configuration?