Fortinet NSE8_812 Practice Test - Questions Answers, Page 7

Refer to the exhibit showing a FortiView monitor screen.

After a Secure SD-WAN implementation a customer reports that in FortiAnalyzer under FortiView Secure SD-WAN Monitor there is No Device for selection.

What can cause this issue?

Review the Application Control log.

Which configuration caused the IPS engine to generate this log?

Refer to the exhibit.

You are managing a FortiSwitch 3032E that is managed by FortiLink on a FortiGate 3960E. The 3032E is heavily utilized and there is only one port free.

The requirement is to add an additional three FortiSwitch 448E devices with 10Gbps SFP+ connectivity directly to the 3032E. The plan is to use split port (phy-mode) with QSFP28 mode to connect the new 448E switches.

In this scenario, which statement about the switch deployment is correct?

A customer has FortiAP devices in three branch offices managed from a FortiGate in the HQ. Each FortiAP is connected to a dedicated management VLAN.

The customer wants the users connected to the FortiAP SSIDs to use the branch local internet connection, but each branch uses a different VLAN ID for the bridge. HQ users travel to different branches and connect to the same SSID.

Which configuration option will solve this requirement?

Refer to The exhibit showing a FortiEDR configuration.

Based on the exhibit, which statement is correct?

You are performing a packet capture on a FortiGate 2600F with the hyperscale licensing installed. You need to display on screen all egress/ingress packets from the port16 interface that have been offloaded to the NP7.

Which three commands need to be run? (Choose three.)

Refer to the exhibits.

The exhibits show the configuration and debug output from a FortiGate Public SDN Connector.

What is a possible reason for this dynamic address object to be empty?

Refer to the exhibit.

A customer needs to create a multi-tier MCLAG set up with the topology as shown in the exhibit.

A1/A2

B1/B2

C1/C2

Which command snippet should be applied to it, to allow active/active links in this topology?

Refer to the exhibit.

A customer wants to automate the creation and configuration of FortiGate VM instances in a VMware vCenter environment using Terraform. They have the creation part working with the code shown in the exhibit.

Which code snippet will allow Terraform to automatically connect to a newly deployed FortiGate if its IP was dynamically assigned by VMware NSX-T?