Cisco 010-151 Practice Test - Questions Answers, Page 10
Question list
List of questions
Related questions
Which Cisco UCS Virtual Interface Card Series is designed exclusively for the M5 generation?
M81KR VIC
VIC 1400 Series
VIC 1300 Series
VIC 1200 Series
When activating the firmware via UCSM which two firmware versions must be activated at the same time?
UCS Manager and System
UCS Manger and Kernel
CIMC and Kernel
System and Kernel
In Cisco UCS C480 M5 server, which PCle slot is the default slot for the rear RAID controller when the rear drive module is used with SAS/SATA drives?
PCle slot 09
PCle slot 10
PCle slot 11
PCle slot 12
Refer to the exhibit. Which statement correctly identifies the hardware features on the Cisco Nexus 9500 Series supervisor A modules?
A is 10/100/1000 Management port; B is USB port; C is Console port; D is external clock input
A is Console port; B is USB port; C is 10/100/1000 Management port; D is external clock input
A is Optical port; B is USB port; C is 10/100/1000 Management port; D is external clock input
A is Console port; B is USB port; C is 10/100/1000 Management port; D is Diagnostic port
Which two statements about the Ethernet media are true? (Choose two.)
A twisted-pair cable system has each pair of wires twisted together to reduce electromagnetic interference.
Compared to multimode fiber, the single-mode fiber is designed for shorter distances with higher cost.
40 Gigabit Ethernet twinax cables deploy Enhanced Quad Small Form Factor Pluggable (QSFP+) connectors.
The twinax cables can be found in either a shielded twisted-pair or an unshielded twisted-pair variation.
A passive twinax cable can carry an Ethernet signal over 5m.
Which two commands allow you to view the state of high availability between the two clustered Fabric Interconnects? (Choose two.)
show cluster state extended
show cluster extended-state
show cluster HA status
show cluster state
show cluster HA state
Which statement about RAID is true?
RAID is a scheme used to logically combine several independent disks to form an array or group of drives.
RAID provides data redundancy with either odd parity or even parity.
RAID drive group appears to the host computer as multiple physical storage units.
RAID parity information can be stored across multiple RAID levels.
RAID stores data in the array with data striping, encryption, and parity to organize the data among the disks.
Which type of optics module is supported by a Cisco Nexus 7700 F4-Series 30-Port 100-Gigabit Ethernet Module?
QSFP28
SFP+
Cisco CPAK
QSFP+
Refer to the exhibit. Which item does C represent?
CMOS Battery
Internal USB
Mini Storage Connector
mLOM Connector
GPU
Which two statements about PCIe are true? (Choose two.)
The PCle supports native hot-swap functionality.
You can install a PCI Express x16 adapter into an x4 slot.
The PCIe standard is a bus-based system in which all the devices share the same bidirectional, 32-bit or 64-bit, parallel signal path.
The PCIe 4.0 standard doubles the transfer rate compared to PCIe 5.0.
A link that is composed of four lanes is called an x4 link.
Question