A web server administrator informs the BIG-IP Administrator that web servers are overloaded Starting next month, the BIG-IP device will terminate SSL to reduce web server load. The BIG-IP device is ready using client SSL client profile and Rules on HTTP level. What actions should the BIG-IP Administrators to achieve the desired configuration?

Remove the server SSL profile and configure the Pool Members to use HTTP

Remove the client SSL profile and configure the Pool Members to US HTTP

Remove the chart SSL profile and change the Virtual Server to accept HTTP

Remove the server SSL profile and change the Virtual Server to accept HTTP traffic

A BIG-IP Administrator uses a device group to share the workload and needs to perform service on a BIG-IP device currently active for a traffic group. The administrator needs to enable the traffic group to run on another BIG-IP device in the device group. What should the administrator do to meet the requirement?

Select Traffic Group and then select Force to Standby

Create a new Traffic Group and then fail to Standby Unit

Select Traffic Group and then select Failover

Select Traffic Group and then select Force to Standby

Select Traffic Group on Primary Unit and then select Demote

A BIG-IP Administrator receives an RMA replacement for a failed F5 device. The BIG-IP Administrator tries to restore a UCS taken from the previous device, but the restore fails. The following error appears inthe/var/log/itm.mcpd [****J: ******;0; License is not operational (expired or digital signature does not match contents.)What should the BIG-IP Administrator do to avoid this error?

Use the appropriate tmsh command with the no-license option

Revoke the license prior to restoring

Reactivate the license on the new device using the manual activation method

Remove the license information from the UCS archive

A BIG-IP Administrator need to ensure that a pool member and down by the monitor the BIG-IP system sends existing connections to another be pool member.Which should the BIG-IP Administrator perform to meet this goal?

Set Action Service Down setting under the pool configuration to reselect.

Set Action on Service Down sing under the server configuration to reselect.

Reconfigure the pool motor members as UP.

Enable mirroring within the persistence profile.

Set Action Service Down setting under the pool configuration to reselect.

Refer to the exhibitThe network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.Which action should the BIG-IP Administrators to resolve this issue?

Assign a physical interface to the new VLAN

Set Port Lockdown of Set IP to Allow All

Change Auto Last Hop to enabled

Assign a physical interface to the new VLAN

Create a Floating Set IP Address

Refer to the exhibit The network team creates a new VLAN on the switches. The BIG-IP Administrator needs to create a configuration on the BIG-IP device. The BIG-IP Administrator creates a new VLAN and Self IP, but the servers on the new VLAN are NOT reachable from the BIG-IP device.Which action should the BIG-IP Administrators to resolve this issue?

Assign a physical interface to the new VLAN

Set Port Lockdown of Set IP to Allow All

Change Auto Last Hop to enabled

Assign a physical interface to the new VLAN

Create a Floating Set IP Address

Refer to the exhibit. During maintenance, the BIG-IP Administrator manually disables a pool member as shown.What is the result?

All pool members continue to process persistent connections

All pool members stop accepting new connections.

The disabled pool member stops processing persistent connections.

The disabled pool member stops processing existing connections

During a maintenance window, an EUD test was executed and the output displayed on the screen. The BIG-IP Administrator did NOT save the screen output. The BIG-IP device is currently handling business critical traffic. The BIG-IP Administrator needs to minimize impact. What should the BIG-IP Administrator do to provide the EUD results to F5 Support?

Collect file /shared/log/eud.log

Boot the device into EUD then collect output from console

Execute EUD from tmsh and collect output from console

Collect file /shared/log/eud.log

An application is configured so that the same pool member must be used for an entire session, as well as for HTTP and FTP traffic.A user reports that a session has terminated, and the user must restart the session. The BIG-IP Administrator determines that the active BIG-IP device failed over to the standby BIG-IP device. Which configuration settings should the BIG-IP Administrator verify to ensure proper behaviour when BIG-IP failover occurs?

Persistence mirroring and Match Across Services

cookie persistence and session timeout

Stateful failover and Network Failover detection

Persistence mirroring and Match Across Services

syn-cookie insertion threshold and connection low-water mark

Refer to the exhibit. The BIG-IP Administrator needs to avoid overloading any of the Pool Members with connections, when they become active.What should the BIG-IP Administrator configure to meet this requirement?

Different Ratio for each member

Same Priority Group to each member

Action On Service Down to Reselect

A 8IG-IP Administrator configures a Virtual Server to load balance traffic between 50 webservers for an ecommerce website Traffic is being load balanced using the Least Connections (node) method.The webserver administrators report that customers are losing the contents from their shopping carts and are unable to complete their orders.What should the BIG-IP Administrator do to resolve the issue?

Change Default Persistence Profile setting to cookie

Change Load Balancing method to Ratio (member)

Change Default Persistence Profile setting to sipjnfo

Change Load Balancing method to Ratio (node)

A BIG-IP Administrator sees the following error message in /var/log/ltm diskmonitor: *******; Disk partition shared has less than 30$ freeWhich section of the Configuration Utility should the BIG-IP Administrator access to investigate this error message?

Statistics > Module Statistics > System

A new BIG-IP VE is deployed with default settings. The BIG-IP Administrator completes the setup utility in the Configuration Utility. The internal self IP address fails to respond to a ping request. What is a possible cause of this issue?

Internal interface VLAN is set to tagged

Port lockdown on internal self IP is set to Allow None

Route is NOT assigned to internal self IP.

Internal interface VLAN is set to untagged

Internal interface VLAN is set to tagged

Refer to the exhibitThe BIG-IP Administrator is unable to access the management console via Self-IP 10.10 1.33 and port 443.What is the reason for this problem?

Self IP is configured to allow UDP 443

Packet Filter needs to be configured to allow a source

Self IP is configured to allow TCP All

Self IP is configured to allow UDP 443

Packet Filter is configured to allow port 443

A BIG-IP Administrator is performing maintenance on the active BIG-IP device of an HA pair. The BIG-IP Administrator needs to minimize traffic disruptions.What should the BIG-IP Administrator do to start the maintenance activity?

Force the BIG-IP device to standby.

Move resources to a new Traffic Group.

Force the BIG-IP device to standby.

Disable switch ports of the BIG-IP device.

Refer to the exhibit. How long will the persistence record remain in the table?

300 seconds after the last packet

180 seconds after the last packet

180 seconds after the initial table entry

300 seconds after the initial table entry

300 seconds after the last packet

A BIG-IP device has only LTM and ASM modules provisioned. Both have nominal provisioning level. The BI6-IP Administrator wants to dedicate more resources to the LTM module. The ASM module must remain enabled. Which tmsh command should the BIG-IP Administrator execute to obtain the desired result?

modify/sys provision asm level minimum

modify /sys provision Itm level dedicated

modify /sys provision asm level none

modify /sys provision Itm level minimum

A VLAN has the following objects configured:Self-IP 10.10.10.100 with port lockdown set to Allow defaultVirtual server 10.10.10.100:443 with UDP profile enabledVirtual server 10.10.10.0/24 port forwarding virtual serverGlobal destination NAT forwarding 10.10.10.100 to internal server 172.168.10.100<a target='_blank' href='https://10.10.10.100'>Which object will process this request when https://10.10.10.100 is entered into a browser?</a>

self-IP 10.10.10.100 with port lockdown set to Allow default

virtual server 10.10.100/24 port o forwarding virtual server

global destination NAT forwarding 10.10.10.100 to internal server 172.168.10.100

virtual server 10.10.10.100.443 with UDP profile enabled

A BIG-IP Administrator needs to configure the BIG-IP system to perform load balancing for FTP servers running passive mode FTP.How should the administrator configure the Virtual Server to perform this load balancing?

A Standard Virtual Server + FTP profile

A Performance Layer 4 Virtual Server + FTP profile

A Message Routing Virtual Server

A BIG-IP Administrator remotely connects to the appliance via out-of-band management using https://mybigip mycompany net. The management portal has been working all week. When the administrator attempts to login today, the connection times out. Which two aspects should the administrator verify? (Choose two)

DNS is property resolving the FQDN of the device.

The administrator has TCP connectivity to the device.

DNS is property resolving the FQDN of the device.

The device is NOT redirecting them to http.

The administrator has the latest version of the web browser.

Packet Filters on the device are blocking port 80.

The administrator has TCP connectivity to the device.

What should the BIG-IP Administrator do to apply and activate a hotfix to a BIG-IP device that is currently running version 11.0.0 on active partition HD1.1?

1. confirm that 11.0.0 is installed on inactive partition HD1.2 2. apply a hotfix to partition HD 1.2 3. activate partition HD1.2

1. reactivate the license on partition HD1.1 2. apply a hotfix to partition HD1.1

1. activate partition HD1.2 2 confirm version 11.0.0 on partition HD1.2 3. install a hotfix on partition HD1.2

1. set partition HD1.2 active 2. apply a hotfix to partition HD1.2

An IT support engineer needs to access and modify Virtual Servers in three partitions (Common /Banking and Dev) daily on a BIG-IP device. The company operates a Least Privilege access policy. What level of access does the IT support engineer need to ensure completion of daily roles?

Manager in /common/Banking, and /Dev partitions

Application Editor in /Common, /Banking, and /Dev partitions

Application Editor in all partitions

The BIG-IP Administrator needs to perform a BIG-IP device upgrade to the latest version of TMOS. Where can the administrator obtain F5 documentation on upgrade requirements?

Local Traffic > Virtual Servers

F5 201 Practice Test 4 - Free Online Exam Questions 121-160

The BIG-IP Administrator disable all pool members in a pool Users are still able to reach the pool members.

What is allowing users to continue to reach the disabled poo! members?

Become a Premium Member for full access

Unlock Premium Member

F5 201 Practice Test 4

Question

F5 201 Practice Tests

Practice Tests