Huawei H12-831_V1.0 Practice Test - Questions Answers, Page 20

When 0SPFV2 evolves to 0SPFV3, the LSA format and function are exactly the same, but the network layer in the LSA address from IPv4 to IPv6o

Basic QinQ can choose the outer tag encapsulation method according to the business type.

As shown in the figure, on the R1 router, network administrator A sends the routing entry to R2 through the routing policy

After modifying the Local Preference value, you can control the path of traffic leaving the AS100

display interface GEO/O/O once, and found that the Total Eror count (the total number of error packets at the physical layer of the interface) is not correct. . At this time, it can be concluded that the current time and fall has not disappeared.

In BGP/MPLS IP VPN, the 0SPF multi-instance process uses the DN bit to prevent Type5 LSA loops.

For the same MA, C address, manually configured MA, C entries have higher priority than automatically generated entries.

The correct description for the configuration on this switch is:

[Huawei]dhcp enable

[Huawei]interface Vlanif 100 [Huawei-Vlanif 100]dhcp select relay

From this picture, we can judge

<Redisplay ipv6 routing table protocolTuozhen

Public Routing Table . ISIS

Summary Count 6

ISIS Routing Table's Status : < Active >

Summary Count 6

As shown in the figure, OSPF is enabled on all the routers. The IP address marked in the figure is the IP address of the loopbackO interface of the device. The LoopbackO of R1 and R2 is advertised in area 1, the LoopbackO of R4 is advertised in area 0, and the LoopbackO of R3 and R5E is advertised in area 0. In area 2, which of the following IP addresses can ping each other?