Huawei H12-831_V1.0 Practice Test - Questions Answers, Page 29

On the OSPFv3 network shown in the figure, OSPFv3 is enabled on the interfaces connecting R1, R2, and R3. The router ID of each router is 10.0.X.X, where X is the number of the router. If you check detailed information about an LSA on R3, the command output shows that the LSA is generated by R2 and describes the IPv6 prefix address associated with the Router-LSA.

R1 and R2 use directly connected interfaces to establish an EBGP peer relationship. R1 imports 2000:: 1/128 to BGR By default, which of the following is the next hop of the route from R2 to 2000:: 1/128?

On the OSPFv3 network shown in the figure, area 1 is a common are a. Which of the following statements are true?

On the OSPFv3 network shown in the figure, area 1 is a stub area, area 2 is a common area, and area 3 is an NSSA. Which of the following LSAs is displayed only in area 2?

To support the processing and calculation of IPv6 routes, IS-IS adds a new NLPID to TLV 129. The NLPID is an 8-bit field that identifies network layer protocol packets. Which of the following is the NLPID of IPv6?

On the 05PFv3 network shown in the figure, each interface of R1 and R2 has two IPv6 addresses. Although the IPv6 address prefixes of R1 and R2 are different, they can still be used to establish an OSPFv3 neighbor relationship. If R2 is the DR, the Intra-Area-Prefix-LSA generated by R2 contains four prefixes.

On the OSPFv3 network shown in the figure, the IPv6 address of Loopback0 on R3 is 2000-3/128, and OSPFv3 is enabled. Which of the following statements are true?

Which of the following TLVs is added to IS-IS to support multi-topology?

If the display ospfv3 peer verbose command is run to check OSPFv3 neighbor information, the command output contains information such as the peer router ID, global unicast address of the peer interface, and neighbor status.