ExamGecko
Login
Home / Huawei / H35-260 / List of questions
Ask Question

Huawei H35-260 Practice Test - Questions Answers, Page 11

Add to Whishlist

List of questions

Question 101

Report Export Collapse

For ODUK SNCP protection, which of the following types does not apply to the pass-through site being an electrical relay site?

SNC/I
SNC/I
SNC/N
SNC/N
SNC/S and SNCN
SNC/S and SNCN
SNC/S
SNC/S
Suggested answer: A
asked 18/09/2024
Nguyen Tan Hung
54 questions

Question 102

Report Export Collapse

Which of the following logical function blocks is used for multiplexing section switching?

MST
MST
MSP
MSP
SPI
SPI
MSA
MSA
Suggested answer: B
asked 18/09/2024
Steven Reyes
42 questions

Question 103

Report Export Collapse

During the troubleshooting process, if you need to loopback the protected services carried by the NG WDM device, which of the following operations need to be performed first when performing the loopback operation?

Switch to the protection channel
Switch to the protection channel
Lock on the current channel
Lock on the current channel
Test to see if the ring is normal
Test to see if the ring is normal
Verify that the APS protocol is enabled
Verify that the APS protocol is enabled
Suggested answer: B
asked 18/09/2024
Maxime SELLY
45 questions

Question 104

Report Export Collapse

Regarding the IS-IS backbone area, which of the following statements are correct?

It is composed of all L2 routers (including L1/L2)
It is composed of all L2 routers (including L1/L2)
Can be discontinuous
Can be discontinuous
For inter-area routing
For inter-area routing
Identified with the area aea0
Identified with the area aea0
Suggested answer: A, C
asked 18/09/2024
Aziz ZENNOUN
57 questions

Question 105

Report Export Collapse

Which one is correct about the description of MC-LAG on L2/13 nodes in LTE network?

The L2VE interface can be directly selected as a member port of MC-LAG
The L2VE interface can be directly selected as a member port of MC-LAG
Configurable to load burden mode
Configurable to load burden mode
The higher the active/standby priority value, the lower the priority
The higher the active/standby priority value, the lower the priority
The heartbeat is carried by unidirectional LSP and configured with 1:1 protection
The heartbeat is carried by unidirectional LSP and configured with 1:1 protection
Suggested answer: C
asked 18/09/2024
Katia Santa Olalla S
36 questions

Question 106

Report Export Collapse

Which statement about MPLS OAM is wrong?

The hardware supports the transmission of messages
The hardware supports the transmission of messages
Support real-time monitoring of performance events such as packet loss rate and delay
Support real-time monitoring of performance events such as packet loss rate and delay
Can be used to trigger protection switching
Can be used to trigger protection switching
Tunnel's OAM and PW OAM are related and affect each other
Tunnel's OAM and PW OAM are related and affect each other
Suggested answer: D
asked 18/09/2024
Jessica Mahoney
45 questions

Question 107

Report Export Collapse

Which of the following statements about MST functional modules are true?

MST is both the source and sink of MS
MST is both the source and sink of MS
MST implements BIP-8 statistical calculation of B2 bytes.
MST implements BIP-8 statistical calculation of B2 bytes.
MST returns bit error information, but does not return a specific number of bit errors.
MST returns bit error information, but does not return a specific number of bit errors.
MST provides its rdenire channel.
MST provides its rdenire channel.
Suggested answer: A, D
asked 18/09/2024
Heritier kandolo
50 questions

Question 108

Report Export Collapse

Which of the following statements is incorrect about the optical layer interfaces OTM-nm and OTMnrm of OTN?

n represents the number of wavelengths carried by the maximum capacity,
n represents the number of wavelengths carried by the maximum capacity,
m represents the rate. Value can be 1.2 or 3.
m represents the rate. Value can be 1.2 or 3.
r means OTM without OSC function
r means OTM without OSC function
OTM-nr.m with OSC signal is OTM-nm.
OTM-nr.m with OSC signal is OTM-nm.
Suggested answer: B
asked 18/09/2024
Pavol Adamcin
40 questions

Question 109

Report Export Collapse

Which item is wrong about the description of PTN network MC-PWAPS protection features?

1+1 mode is not supported
1+1 mode is not supported
DNI-PW can only be used to transmit base station traffic
DNI-PW can only be used to transmit base station traffic
DNI-PW supports multi-hop, but single-hop PW is recommended for service deployment
DNI-PW supports multi-hop, but single-hop PW is recommended for service deployment
The existing network is generally not linked with MCLAG
The existing network is generally not linked with MCLAG
Suggested answer: B
asked 18/09/2024
Neil Mallia
55 questions

Question 110

Report Export Collapse

Regarding PW labels and tunnel labels, which of the following statements are correct?

PW labels are mainly used to distinguish PWs, but for CES services, because CES services do not support aggregation, there is no need to use PW labels
PW labels are mainly used to distinguish PWs, but for CES services, because CES services do not support aggregation, there is no need to use PW labels
Tunnel label is mainly used for transmission in the tunnel, it mainly uses the tunnel label to establish MPLS tunnel
Tunnel label is mainly used for transmission in the tunnel, it mainly uses the tunnel label to establish MPLS tunnel
They are all based on MPLs tags
They are all based on MPLs tags
PW signing only needs negotiation between the source and sink network elements, and has nothing to do with the intermediate tansit network elements
PW signing only needs negotiation between the source and sink network elements, and has nothing to do with the intermediate tansit network elements
Suggested answer: B, C, D
asked 18/09/2024
Arlind Tereziu
48 questions
Total 338 questions
Go to page: of 34
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which one is correct about the description of MC-LAG on L2/13 nodes in LTE network?
Which of the following 7900 single-board software function descriptions are correct?
The U2000 license file is stored in the following directory /u2000/server path. If the license file is invalid, the U2000 will not work normally.
The base station is deployed, the Tunnel and PW tests are normal, and the base station management is normal, but the base station cannot access the core network normally. What is the reason for the impossibility?
On the PTN equipment, when the tunnel bears data and forwards, which one is wrong in the description of the actions of each node on the LSP?
To determine whether the optical fiber lines and connectors on the wavelength division side are normal, which of the following loopback methods is most suitable?
PTN can support in-band DCN. At this time, the port needs to enable the DCN function. Therefore, in CES service, PTN setup cannot be managed by in-band DCN.
When the data is forwarded by the PTN device, when the value of the TYPE field of the Ethernet header is OxO8O0, which protocol is the encapsulated inner packet?
When the switch is working, the device forwards data according to the MAC address forwarding table. Which of the following statements is correct?
When TCAT adds points, it recalculates the Tunnel and distributes the configuration. Which of the following information is being modified?