Juniper JN0-682 Practice Test - Questions Answers, Page 11

List of questions
Question 101

You are deploying a switch using ZTP.
Which two statements are true in this scenario? (Choose two.)
Question 102

You are asked to build a single export policy that can be applied to all devices to advertise only loopback IP addresses in the 172.16.0.0/24 subnet into your EBGP IP fabric. In this scenario, which two solutions would accomplish this task? (Choose two.)
Question 103

The MC-LAG group shown in the exhibit is providing high availability services for the directly connected servers. The backup liveness detection is applied to the ICL-PL link, however, when one of the members rebooted, there was traffic loss for a few seconds.
In this scenario, where should you apply the backup liveness detection?
Question 104

You are deploying a VXLAN using signaling overlay network in your new data center. You are able to establish your MP BGP peering session and see your EVPN routes, but traffic will not traverse the VXLAN using signaling overlay network.
What is a solution to this problem?
Question 105

What is the endpoint of a VXLAN tunnel?
Question 106

Host1 and host2 are connected to an EVPN signaled VXLAN overlay, and must have Layer 3 connectivity. The VNI and VLAN assignments are shown in the exhibit.
In this scenario, which two statements are true? (Choose two.)
Question 107

Referring to the exhibit, what would cause the problem on VCP 0/50?
Question 108

You are logged in to Leaf 1. When examining the routing table, you notice that you have no routes from Leaf 2.
Referring to the exhibit, which two commands would you use to troubleshoot the problem? (Choose two.)
Question 109

You have deployed two data centers that require a Layer 2 stretch between host1 and host2.
Referring to the exhibit, what does a Layer 2 stretch require?
Question 110

What are three functions supported by the Contrail Command user interface?
Question