A network engineer designed and implemented a new office space with the following characteristics: One month after the office space was implemented, users began reporting dropped signals when entering another room and overall poor connections to the 5GHz network. 'which of the following should the engineer do to best resolve the issue?

Reconfigure the network to support 2.4GHz_

A network engineer is installing hardware in a newly renovated data center. Major concerns that were addressed during the renovation induded air circulation, building power redundancy, and the need for continuous monitoring. The network engineer IS creating alerts based on the following operation specifications: Which of the following should the network engineer configure?

SNMP traps to report when the chassis temperature exceeds 950F (3500)

Environmental monitoring alerts for humidity greater than 95%

SIEM to parse syslog events for a failed power supply

SNMP traps to report when the chassis temperature exceeds 950F (3500)

UPS monitoring to report when input voltage drops below 220VAC

Users have reported an issue connecting to a server over the network. A workstation was recently added to the network and configured with a shared USB printer. Which of the following is most likely causing the issue?

The workstation was configured with a static IP that is the same as the server.

The switch is oversubscribed and cannot handle the additional throughput.

The printer is tying up the server with DHCP discover messages

The web server's back end was designed for only single-threaded applications.

The workstation was configured with a static IP that is the same as the server.

A customer calls the help desk to report that users are unable to access any network resources_ The issue started earlier in the day when an employee rearranged the wiring closet A technician goes to the site but does not observe any obvious damage. The statistics output on the switch indicates highCPI-J usage, and all the lights on the switch are blinking rapidly in unison_ Which of the following is the most likely explanation for these symptoms?

A cable was looped and created a broadcast storm.

The switch was rebooted and set to run in safe mode.

The line between the switch and the upstream router was removed

A cable was looped and created a broadcast storm.

A Cat 6 cable from the modem to the router was replaced with Cat 5e.

A network technician is troubleshooting internet connectivity issues with users in a subnet. From a host, the technician runs and then attempts to navigate to a website using a web browser. The technician receives the following output:Afterward, the browser displays an error. Which of the following explains this issue?

The host is configured with incorrect DNS settings

A routing loop is within the network.

The host is configured with incorrect DNS settings

A broadcast storm is occurring on the subnet

The host is missing a route to the website.

A customer is adding fiber connectivity between adjacent buildings. A technician terminates the multimode cable to the fiber patch panel. After the technician connects the fiber patch cable, the indicator light does not come on. Which of the following should a technician try first to troubleshoot this issue?

Examine the cable runs for visual faults.

A security team updated a web server to require https:// in the URL. Although the IP address did not change, users report being unable to reach the site. Which of the following should the security team do to allow users to reach the server again?

Configure inbound firewall rules to allow traffic to port 443.

Configure the switch port with the correct VLAN.

Configure inbound firewall rules to allow traffic to port 443.

Configure the router to include the subnet of the server.

Configure the server with a default route.

An organization recently connected a new computer to the LAN. The user is unable to ping the default gateway. Which of the following is the most likely cause?

The DHCP server is not available.

An RFC1918 address is being used

A network technician is investigating a trouble ticket for a user who does not have network connectivity. All patch cables between the wall jacks and computers in the building were upgraded over the weekend from Cat 5 to Cat 6. The newly installed cable is crimped With a TIA/EIA 568A on one end and a TIA/EIA 568B on the other end. Which of the following should the technician do to most likely fix the issue?

Crimp the cable as a straight-through cable.

Ensure the switchport has POE enabled.

Crimp the cable as a straight-through cable.

Ensure the switchport has STP enabled.

Crimp the cable as a rollover cable.

A network technician is investigating why a core switch is logging excessive amounts of data to the syslog server. The running configuration of the switch showed the following logging information: Which of the following changes should the technician make to BEST fix the issue?

Change lo asynchronous logging.

Which of the following indicates a computer has reached end-of-support?

No more patches or bug fixes are available indefinitely.

The computer does not have any users.

The antivirus protection is expired.

The operating system license is expired.

No more patches or bug fixes are available indefinitely.

A user reports having intermittent connectivity issues to the company network. The network configuration for the user reveals the following:IP address: 192.168.1.10Subnet mask: 255.255.255.0Default gateway: 192.168.1.254The network switch shows the following ARP table: Which of the following is the most likely cause of the user's connection issues?

Another PC with manually configured IP

A port with incorrect VLAN assigned

A switch with spanning tree conflict

Another PC with manually configured IP

A router with overlapping route tables

CompTIA N10-008 Practice Test 15 - Free Online Exam Questions 561-600

The results of a recently completed site survey indicate a significant, undesired RSSI in the parking lot and other exterior areas near the like to mitigate access to the wireless network in exterior access areas. The current access point settings are listed in the following table:

CompTIA N10-008 image Question 561 96445 10022024175235000000

Which of the following is the BEST step for the technician to take to resolve the issue?

Become a Premium Member for full access

Unlock Premium Member

CompTIA N10-008 Practice Test 15

Question

CompTIA N10-008 Practice Tests

Practice Tests