An engineer recently installed a new distribution switch and connected two servers provisioned with the following IPs: 192.168.17.20 and 192.168.17.30. The servers cannot connect to the Internet, but they can reach themselves. The engineer observes that the distribution switch has the following setup: The engineer is able to reach the core router 192.168.17.1 from the distribution switch. Which of the following is the most likely cause of this issue?

The servers are not configured with default gateway.

There is an improper Layer 1 connection between the router and the ISP modem.

The cybersecurity department needs to monitor historical IP network traffic on the WAN interface of the outside router without installing network sensors. Which of the following would be best to allow the department to complete this task?

Enabling NetFlow on the interface

Enabling 802.1Q on the Interface

Which of the following describes the differences between switches and hubs?

Switches operate on the data link layer, while hubs operate on the physial layer.

Switches operate on the physical layer, while hubs operate on the data link layer.

Switches operate on the session layer, while hubs operate on the transport layer.

Switches operate on the data link layer, while hubs operate on the physial layer.

Switches operate on the transport layer, while hubs operate on the data link layer.

A network administrator is adding a new wired loT device to the internal network. The only devices that will be communicating are the HVAC system and the loT device. Which of the following should the network administrator do?

Set up the guest network isolation.

A technician troubleshoots user reports about high latency while trying to access some of the web servers. Which of the following would be the best way for the technician to identify the issue?

Use ping, nmop, and traceroute.

Use NetFlow on an edge device to view all traffic data.

Use nslookup and dig to Identify issues.

Use ping, nmop, and traceroute.

Use Wireshark and tcpdump on users' devices to log all data.

An older web server on a screened subnet is serving unencrypted web traffic. The server is not capable of serving HTTPS traffic directly but the firewall is capable of doing so. Which of the following should be done to encrypt all traffic coming into the web server from outside the network? (Select two).

Incoming port 443 traffic at the firewall should be forwarded to port 80 on the server.

A certificate should be installed on the firewall

A certificate should be installed on the server

Incoming port 80 traffic at the firewall should Be forwarded to port 443 on the server.

Incoming port 60 traffic at the firewall should be forwarded to port 80 on the server.

Incoming port 443 traffic at the firewall should be forwarded to port 80 on the server.

A certificate should be installed on the firewall

A proxy server should be Installed on the screened subnet.

CompTIA N10-008 Practice Test 22 - Free Online Exam Questions 841-865

A network engineer is installing APs for a SOHO where every staff member uses a cordless phone. Which of the following standards would work best to reduce interference?

Become a Premium Member for full access

Unlock Premium Member

CompTIA N10-008 Practice Test 22

Question

CompTIA N10-008 Practice Tests

Practice Tests