An administrator needs to report on any alerts generated by a Nutanix cluster that affected the cluster's availability over the past 10 days.Which method should be used to locate these events?

On the Alerts dashboard, filter based on Impact Type and the desired Time Range.

On the Health dashboard, use the Log Collector to export data based on time stamp.

Export the cluster event log to a CSV on the Alerts dashboard.

On the Alerts dashboard, filter based on Impact Type and the desired Time Range.

Configure an Alert Policy to generate an email with the data on the Health dashboard.

CPU utilization climbs above 90% on several VMs. This causes performance degradation for a business-critical application.How can alerts be configured to notify the administrator before VM CPU utilization hits 90%?

On the Health dashboard, locate the VM CPU Check and lower the alert threshold below 90%.

On a CVM, use ncli to set the VM CPU Check threshold for the critical VMs to a value below 90%.

On the Health dashboard, locate the VM CPU Check and lower the alert threshold below 90%.

On a CVM, configure a cron job to run the VM CPU Check more frequently and email the result.

On the Alerts dashboard, ensure that the VM CPU usage alert is not set to auto-resolve.

A two-node ROBO cluster is configured with a witness VM. What happens when Node A goes down?

Node B sends a leadership request to the Witness VM and goes into single-node mode.

The- cluster becomes unavailable and goes into read-only mode.

All operations and services on the Node B are shut down and go into a waiting state.

The cluster is unaffected and no administrator intervention is required.

Node B sends a leadership request to the Witness VM and goes into single-node mode.

How will an HDD failure affect VMs with data on the failed device?

An HA event will occur, causing the affected VMs to restart on a node that contains the replica data.

The VMs will crash, and will be restarted once the failed HDD has been replaced and the data has been restored.

A live migration will be initiated, moving the affected VMs to a host that contains the replica data.

The VMs will remain operational on that host and continue to function normally with no noticeable impact

An HA event will occur, causing the affected VMs to restart on a node that contains the replica data.

A guest VM should be able to tolerate simultaneous failure of two nodes or drives.What are the minimum requirements for the Nutanix cluster?

5 nodes with cluster RF 3 and container RF 3

3 nodes with cluster RF 3 and container RF 3

3 nodes with cluster RF 3 and container RF 2

5 nodes with cluster RF 2 and container RF 3

5 nodes with cluster RF 3 and container RF 3

Refer to the exhibit. An administrator is trying to implement the solution that is shown in the exhibit, but has been unsuccessful.Based on the diagram, what is causing the issue?

Active containers in both sites

An administrator needs to increase bandwidth available to the AHV host and to the CVM.How should the administrator complete this task?

Use manage-ovs commands to update br0 change the configuration to Active-Active.

In Prism, update vs0 to change the configuration to Active-Active.

Use manage-ovs commands to update br0 change the configuration to Active-Active.

In Prism, create a vsl interface and add any remaining uplinks.

Use manage-ovs commands to create br1 and add any remaining uplinks

What is a requirement to enable Flow Networking?

Microservices infrastructure must be enabled.

A dedicated virtual switch has been created for Flow Networking.

Flow Micro segmentation must be enabled.

Microservices infrastructure must be enabled.

Prims Central is using a three-node scale-out deployment

Refer to the exhibit. System Non-Root Partition Usage shows a warning or critical alert The administrator needs to change the frequency of checks and alerts to respond more quickly.Where in Prism Element should the administrator change the frequency of checks and alerts?

Health Dashboard > Manage Checks > Schedule

Health Dashboard > Manage Crocks > Frequency

Alerts Dashboard > Manage Checks > Schedule

Health Dashboard > Manage Checks > Schedule

Alerts Dashboard > Manage Checks > Frequency

An administrator has been tasked with increasing security on Nutanix cluster by disabling password authentication when accessing the CVM and AHV hosts and instead moving to key-based SSH,What is the easiest way for the administrator to meet these needs?

Enable Cluster Lockdown and provide an RSA key.

Configure LDAP authentication through a secure server,

Enable STIES vie commend line on SSH to CVM.

Enable Cluster Lockdown and provide an RSA key.

Restrict access with User Management in Prism.

A user is complaining about slowness of a mission-critical MSSQL Server. The administrator logs into Prism Element to investigate the VM performance and observes what is shown in the diagram. Which action would best improve VM performance?

Add additional RAM to the user VM.

Disable hyperthreading in the BIOS.

Add additional RAM to the user VM.

Add additional RAM to the host on which the VM is running.

Ensure the host's CPUs ere not excessively overcommitted.

Refer to exhibit: Why has an anomaly been triggered?

Observed IOPS exceed normal values.

Normal Controller behavior has increased.

Observed values do not match predicted values.

Refer to Exhibit: Why has an anomaly been triggered?

Because the CPU usage crossed the blue band.

Because the blue band range increased over the last 2 days

Because the CPU usage dropped belon' 20%

Because the CPU usage reached 100%

Refer to Exhibit: An administrator needs to enable inline deduplication for a pre-existing storage container. When trying to enable deduplication on the storage container. this feature is grayed-out.What is the reason for this behavior?

The cluster has hybrid storage and deduplication is supported only on all-flash clusters.

Replication Factor 1 is configured on the storage container.

The cluster has less than 5 nodes which is the minimum node-count to enable deduplication.

Capacity reservation is not enabled on the storage container.

The cluster has hybrid storage and deduplication is supported only on all-flash clusters.

Refer to Exhibit: An administrator is trying to create a custom alert policy for all VMs.Why is the Alert warning if field greyed cut?

The Behavioral Anomaly threshold is set.

The Alert critical if threshold is set.

The Behavioral Anomaly threshold is set.

The Enable Policy option checked.

The Auto resolve alerts option is checked.

Refer to Exhibit: An administrator is attempting to create an additional virtual switch on a newly deployed AHV cluster, using the two currently disconnected interfaces. The administrator is unable to select the disconnected interfaces when creating the virtual switch.What is the likely cause of this issue?

Interfaces must be connected to the network before they can be assigned.

Only one interface is available on the selected hosts.

Interfaces must be connected to the network before they can be assigned.

The disconnected interfaces are currently assigned to virtual switch 0,

Interfaces must be assigned to virtual switches via the cli

Refer to Exhibit: An administrator is trying to put a node into maintenance mode but receives the message shown in the exhibit.What is a potential reason for this dialog?

LinuxVM1 uses a vDisks stored in a RF1 Datastore

LinuxVM1 uses e vDisks stored in a RF3 Datastore

Refer to exhibit: What could be the cause for this behavior?

RBAC is configured and the administrator's user doesn't have the right privileges.

The files were ISO but were uploaded as disk images hence cannot be used or edited.

Images are corrupted and must be re-uploaded.

Images were imported into Prism Central.

An administrator recently added new SSDs to a Nutanix cluster and knows the firmware will be out of date, Due to security constraints, the cluster does not have access to the Internet.Which two steps must be completed to update the firmware? (Choose two.)

Download the disk firmware from the OEM's website.

Download a darksite bundle and deploy an internal webserver,

Download the disk firmware from the OEM's website.

Download a darksite bundle and deploy an internal webserver,

Select Upgrade Software, then upload the firmware bundle.

update the LCM Source and URL to access the firmware bundle.

An administrator needs to periodically send information about cluster efficiency via email to a set of users.What should be configured to accomplish this task?

Add a schedule to Prism Central reports.

Configure Efficiency widget in Prism Central.

Create a new' prism Central project.

update Capacity Configurations in Prism Central.

Add a schedule to Prism Central reports.

An administrator is preparing to deploy a new application on an AHV cluster, Security requirements dictate that all virtual servers supporting this application must be prevented from communicating with unauthorized hosts.Which option would achieve this goal?

Create a new Application Security Policy restricting communication to the authorized hosts and apply it to the servers in enforce mode.

Create a new VLAN, create a subnet on the cluster with the VLAN tag, deploy servers with vNlCs in the new subnet.

Create a new Application Security Policy restricting communication to the authorized hosts and apply it to the servers in enforce mode.

Create a new solation Environment policy apply it to the new servers and all authorized hosts.

Create new' subnet and assign to an existing VPC assign the IP prefix and gateway for the subnet, deploy servers with vNlC5 in the new subnet.

An administrator has been notified by a user that a Microsoft SQL Server instance is not performing well.When reviewing the utilization metrics, the following concerns are noted:Memory consumption has been above 95% for several monthsMemory consumption has been spiking to 100% for the last five daysStorage latency is 2ms.When logging into Prism Central, how could the administrator quickly verify if this VM has performance bottlenecks?

Update Capacity Configurations.

On a Nutanix cluster, what does Network Segmentation refer to?

Isolating intra-cluster traffic from guest VM traffic.

A distributed firewall for security VM to VM traffic.

Physically separating management traffic from guest VM traffic.

Isolating intra-cluster traffic from guest VM traffic.

Isolating management traffic from storage replication traffic.

Nutanix NCP-MCI-6.5 Practice Test 1 - Free Online Exam Prep & Questions

HOTSPOT

An administrator needs to shut down an AHV cluster to relocate hardware. The administrator upgrades NCC and runs health checks.

Which steps should the administrator perform next?

Item instructions: For each procedure, indicate the order in which that procedure must take place to meet the item requirements.

Nutanix NCP-MCI-6.5 image Question 1 5409606 09232024013043000

Correct answer:

Nutanix NCP-MCI-6.5 image answer Question 1 5409606 09232024013043000

Comment (0)

Explanation:

https://next.nutanix.com/how-it-works-22/scheduled-power-outage-relocating-cluster-hardware-ifyou-need-to-shut-down-all-the-nodes-in-your-ahv-cluster-here-s-how-37326

asked 23/09/2024

Peter Kiraly

41 questions

Nutanix NCP-MCI-6.5 Practice Test 1

Question

Nutanix NCP-MCI-6.5 Practice Tests

Practice Tests