ExamGecko
Home Home / Nokia / 4A0-104

Nokia 4A0-104 Practice Test - Questions Answers, Page 7

Question list
Search
Search

Which of the following best completes the sentence: 'An Internet Enhanced Service is a_____________ service where the CE communicates with a ________________interface to send and receive traffic.

A.
distributed/virtual
A.
distributed/virtual
Answers
B.
local/sub
B.
local/sub
Answers
C.
routed/Layer 3
C.
routed/Layer 3
Answers
D.
distributed/routed
D.
distributed/routed
Answers
E.
Layer 2/loopback
E.
Layer 2/loopback
Answers
Suggested answer: C

Which of the following statements is TRUE?

A.
An OSPF adjacency can be established on an IES interface.
A.
An OSPF adjacency can be established on an IES interface.
Answers
B.
IES allows provider MP-BGP sessions to be extended to customers.
B.
IES allows provider MP-BGP sessions to be extended to customers.
Answers
C.
An IES service must use static routes in order to communicate with customer networks.
C.
An IES service must use static routes in order to communicate with customer networks.
Answers
D.
An IES interface supports OSPF and IS-IS in passive mode only.
D.
An IES interface supports OSPF and IS-IS in passive mode only.
Answers
Suggested answer: A

What are the two major differences between configuring an IES service and configuring VPWS or VPLS services? (Choose 2)

A.
IES does not support QoS.
A.
IES does not support QoS.
Answers
B.
IES has a configurable IP-MTU
B.
IES has a configurable IP-MTU
Answers
C.
A virtual route table must be configured for an IES service.
C.
A virtual route table must be configured for an IES service.
Answers
D.
An IES interface has an IP address assigned to it.
D.
An IES interface has an IP address assigned to it.
Answers
Suggested answer: B, D

An ES service can have both MAC and IP filters applied to it.

A.
TRUE
A.
TRUE
Answers
B.
FALSE
B.
FALSE
Answers
Suggested answer: B

What can the sdp-ping command be used for? (Choose 2)

A.
To test the ability of reaching the far-end IP address of an SDP within the SDP encapsulation
A.
To test the ability of reaching the far-end IP address of an SDP within the SDP encapsulation
Answers
B.
To determine the path MTU to the far-end IP address over an SDP.
B.
To determine the path MTU to the far-end IP address over an SDP.
Answers
C.
To determine the service MTU of the service using an SDP.
C.
To determine the service MTU of the service using an SDP.
Answers
D.
To determine the presence of hosts using the service
D.
To determine the presence of hosts using the service
Answers
Suggested answer: A, B

Which of the following statements are TRUE regarding sdp-ping? (Choose 3)

A.
Provides a mechanism to determine the hops an SDP traverses.
A.
Provides a mechanism to determine the hops an SDP traverses.
Answers
B.
Provides in-band uni-directional connectivity tests.
B.
Provides in-band uni-directional connectivity tests.
Answers
C.
Provides in-band round-trip connectivity tests.
C.
Provides in-band round-trip connectivity tests.
Answers
D.
Tests ability of reaching the far-end IP address of an SDP ID within the SDP encapsulation.
D.
Tests ability of reaching the far-end IP address of an SDP ID within the SDP encapsulation.
Answers
E.
Provides information regarding the exact MTU supported between service ingress and service termination.
E.
Provides information regarding the exact MTU supported between service ingress and service termination.
Answers
Suggested answer: B, C, D

Which OAM command can be used to verify the correct and consistent provisioning of a service between two service end points?

A.
sdp-ping
A.
sdp-ping
Answers
B.
Isp-ping
B.
Isp-ping
Answers
C.
sap-ping
C.
sap-ping
Answers
D.
svc-ping
D.
svc-ping
Answers
Suggested answer: D

Which of the following items can NOT be used as a mirror source?

A.
A physical port.
A.
A physical port.
Answers
B.
ASAP.
B.
ASAP.
Answers
C.
Ingress MPLS frames with a specific label.
C.
Ingress MPLS frames with a specific label.
Answers
D.
Entries that match an IP filter.
D.
Entries that match an IP filter.
Answers
E.
Entries that match a MAC filter.
E.
Entries that match a MAC filter.
Answers
F.
All of the above can be used as a mirror source.
F.
All of the above can be used as a mirror source.
Answers
Suggested answer: F

A technician sitting in a Network Operations Center would like to set up a remote mirror on an Nokia 7750 Service Router to examine some data traffic ingressing a port at a remote site. Which of the following are required? (Choose 2)

A.
A mirror destination on the local and remote Nokia Service Router,
A.
A mirror destination on the local and remote Nokia Service Router,
Answers
B.
A mirror source on the local and remote Nokia Service Router.
B.
A mirror source on the local and remote Nokia Service Router.
Answers
C.
A mirror source with the remote source specified on the remote Nokia Service Router.
C.
A mirror source with the remote source specified on the remote Nokia Service Router.
Answers
D.
A mirror source with the remote source specified on the local Nokia Service Router.
D.
A mirror source with the remote source specified on the local Nokia Service Router.
Answers
E.
An SDP between the local and remote Nokia Service Routers.
E.
An SDP between the local and remote Nokia Service Routers.
Answers
Suggested answer: A, E

Click on the exhibit button below.

Assuming the customer only needs to monitor traffic from PE3 to the customer site, what three items are missing from PE3's configuration? (Assume that the IP/MPLS network structure between the local and remote PEsis in place.)

A.
The mirror destination configuration on PE5 is missing the 'remote-source' command,
A.
The mirror destination configuration on PE5 is missing the 'remote-source' command,
Answers
B.
The mirror destination on PE3 needs a 'remote-source' command.
B.
The mirror destination on PE3 needs a 'remote-source' command.
Answers
C.
The mirror service IDs on the local and remote destinations must match.
C.
The mirror service IDs on the local and remote destinations must match.
Answers
D.
The mirror source on PE3 needs a 'remote-source' command.
D.
The mirror source on PE3 needs a 'remote-source' command.
Answers
E.
The mirror source command on the remote PE3 needs a command that tells it to monitor port 1/1/2.
E.
The mirror source command on the remote PE3 needs a command that tells it to monitor port 1/1/2.
Answers
Suggested answer: A, C, E
Total 290 questions
Go to page: of 29