DELL D-XTR-MN-A-24 Practice Test - Questions Answers, Page 6

In a single X-Brick XtremIO X2 configuration, the port SC1-IB1 should be connected to IBSW1-P01. This connection ensures proper communication and data flow between the storage controller and the InfiniBand switch, which is critical for system performance and redundancy.

To service an XtremIO X2 with the Technician Advisor tool, the connection is made through the dedicated Management port located on the back of the Storage Controller (SC). This port is specifically designed for management tasks and allows service technicians to access the system for diagnostics and configuration using the Technician Advisor tool1.

The process typically involves:

Locating the dedicated Management port on the back of the SC.

Connecting a compatible cable from the technician's device to the Management port.

Using the Technician Advisor tool to perform the necessary service tasks.

This information is outlined in the Official Dell XtremIO Maintenance Achievement document, which provides detailed instructions for servicing and maintaining XtremIO X2 storage systems1.

=========================

For a multi X-Brick XtremIO X1 cluster, each X-Brick requires one Battery Backup Unit (BBU) that provides protective power to both Storage Controllers within the X-Brick. Additionally, there are two BBU COM (communication) ports required, with one connected to each Storage Controller. This configuration ensures that in the event of a power failure, the BBU can maintain power to the Storage Controllers, allowing them to safely shut down and protect data integrity1.

The installation process would typically involve:

Installing the BBU in the designated slot within the X-Brick.

Connecting the BBU power cable to the power supply of both Storage Controllers.

Connecting a BBU COM port to each Storage Controller for communication and monitoring purposes.

This setup is crucial for maintaining the high availability and data protection standards that XtremIO systems are known for1.

=========================

Determine the cause of the shutdown

Power up the Battery Backup Units

Power up the XMS

Power up the Storage Controllers

Start the cluster