Cisco 300-510 Practice Test - Questions Answers, Page 25

What does conditional matching operate with RPL?

Which attribute is used to instruct the router that packets must be processed by an ASA that is associated with the segment?

Refer to the exhibit.

Router 1. Router 2. and Router 3 are co-located in an onsite data center of an office, but Router 4. Router 5. and Router 6 are installed in another data center 'eral miles away A network engineer is troubleshooting an RSVP-TE issue on the network On most of the devices, the engineer can move all LSPs away from a selected interface and take it down for maintenance without interrupting traffic. However, when an interface on Router 3 is taken down, traffic on the network is disrupted What must the engineer enable to resolve the issue on Router 3?

Refer to the exhibit.

ISP_1 uses eBGP for connection to all clients LDP with OSPF and IS-IS is used in the ISP_1 network Client_A and Client_B are in the same VRF_VoD. After oftware upgrade on all routers on the ISP_1 network, Client_A has lost the connection to Client_C. A network engineer must troubleshoot the connection from R1 to R4 via M. After initial checks, the engineer confirmed that all routes are installed correctly. Which two tasks must the engineer perform to correct the problem? (Choose two.)

network engineer must implement a segment routing policy rule that specifies that SIDs are bounded manually. The policy will be used for traffic steering based on incoming label ..with the binding SIDs, adjacency SIDs, and BGP peering SIDs. All labels will be in the local segment with the range from 40000 to 50000. How must the engineer implement ... label allocation?

Refer to the exhibit.

The network is situated at different locations on the customer site. The customer runs a mission-critical application behind CE2. which is connected over a 10 link to the local network of the customer After recent configuration changes to the P and PE routers, an LSP failure has occurred, causing connectivity issues. CE1 is unable to which the CE2 internal IP address Which action resolves this issue?

Refer to the exhibit.

All backbone interfaces on the network are in VRF_MPLS and ip rsvp signalling hello is preconfigured on all MPLS routers in the network. After router R2 is upgraded and its configuration restored from backup. LSP signaled via RSVP that the tunnel from R1 had been tom down The network engineer confirmed IP reachability line the backbone network Which action must the engineer take to fix the issue?

A network administrator working for a private service provider with an employee ID 4784 41 907 wants to configure timers for the BGP process on their Cisco IOS XE router Which configuration follows guideline timer recommendations and is a valid BGP timer deployment?

A)

B)

C)

D)

Refer to the exhibit.

A network engineer must enable connections from customers on PE1 to the external network via the SR-MPLS forwarding plane with a range of 8000 SID. In the current environment

Which configuration must the engineer apply?