Avaya 78201X Practice Test - Questions Answers, Page 18
List of questions
Question 171

Assuming the Security setting is at its default status, which Service User in Security Administration is responsible for the Avaya IP Office user synchronization between the Avaya IP Office server and one-X Portal?
Question 172

You have purchased a pre-configured Avaya IP Office Application Server. The server has both Voicemail Pro and one-X Portal installed on it.
Which tool could be used to verify if both services are running?
Question 173

During an installation of Server Edition, the main Avaya IP Office service as well as Voicemail Pro and one-X Portal are installed. After the installation these services should be running.
Which two are used to check that these services are running? (Choose two.)
Question 174

After the first start-up of an IP Office system, some default security Rights Groups are available.
Which Rights Group allows access to the diagnostic application that provides real time status, historic utilization, alarm information, and more?
Question 175

What can be used to access the Avaya IP Office security settings?
Question 176

When you erase security settings and set them back to default, which three passwords will you be prompted to change?
Question 177

When saving a configuration after making changes using the Manager Application, you get a warning that your configuration has errors.
Which step is needed to see the errors that are causing this warning message?
Question 178

Refer to the Exhibit.
A customer is setting up an Alarm notification via email.
To get a description of the details of the Minimum Severity Level, if an Event Entity of ''Service'' is checked, which resource is used?
Question 179

When you connect to the Avaya IP Office using System Monitor, the time, date, and IP address of the system you are connected to is displayed.
Which additional key piece of information is displayed?
Question 180

On an Avaya IP Office 500V2 system, which application can be used to display the size of the configuration that is currently loaded into the Control Unit?
Question