ExamGecko
Login
Home / Huawei / H12-261 / List of questions
Ask Question

Huawei H12-261 Practice Test - Questions Answers, Page 3

Add to Whishlist

List of questions

Question 21

Report Export Collapse

Which of following statements is true about IS-IS LDP synchronization?

LDP establishes a neighbor relationship faster than IS-IS, so LDP synchronization is disabled by default
LDP establishes a neighbor relationship faster than IS-IS, so LDP synchronization is disabled by default
LDP synchronization can prevent traffic loss during an active/standby link switchover
LDP synchronization can prevent traffic loss during an active/standby link switchover
LDP synchronization can be enabled globally
LDP synchronization can be enabled globally
LDP synchronization can be configured on Loopback interfaces
LDP synchronization can be configured on Loopback interfaces
Suggested answer: C
asked 18/09/2024
Arndt Langer
48 questions

Question 22

Report Export Collapse

When a router within the HW network makes a forwarding decision, the _____is always used to select the best route from those installed in the routing table.

Routing process ID
Routing process ID
Longest prefix match
Longest prefix match
Administrative Distance
Administrative Distance
Router ID
Router ID
Peer ID
Peer ID
Suggested answer: B
asked 18/09/2024
Miguel Sartori
41 questions

Question 23

Report Export Collapse

Which of the following are found in a basic Network Layer Packet? (Multiple Choice.)

Network Layer Header
Network Layer Header
Path records
Path records
Data Link Layer Header
Data Link Layer Header
Upper Layer Data
Upper Layer Data
Network Layer Trailer
Network Layer Trailer
Suggested answer: A, D, E
asked 18/09/2024
Jason Siemens
44 questions

Question 24

Report Export Collapse

OSPF is running on a network. In OSPF, what LSA type would only cause an Incremental SPF calculation? (Multiple Choice)

Type 3
Type 3
Type 4
Type 4
Type 1
Type 1
Type 2
Type 2
Type 5
Type 5
Suggested answer: A, B, E
asked 18/09/2024
Jurriaan van Ingen
38 questions

Question 25

Report Export Collapse

With regard to TCP headers, which control bit tells the receiver to reset the TCP connection?

SND
SND
CLR
CLR
PSH
PSH
SYN
SYN
RST
RST
ACK
ACK
Suggested answer: E
asked 18/09/2024
Yun-Ting Lo
44 questions

Question 26

Report Export Collapse

Two routers configured to run BGP have been connected to a firewall, one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer, including the correct BGP session endpoint addresses and the correct BGP session hop-count limit (EBGP multihop). What is a good first test to see if BGP will work across the firewall?

There is no way to make BGP work across a firewall without special configuration, so there is no simple test that will show you if BGP will work, other than trying to start the peering session.
There is no way to make BGP work across a firewall without special configuration, so there is no simple test that will show you if BGP will work, other than trying to start the peering session.
Attempt to Telnet from the router connected to the inside of the firewall to the router connected to the outside of the firewall. If Telnet works, BGP will work, since telnet and BGP both use TCP to transport data
Attempt to Telnet from the router connected to the inside of the firewall to the router connected to the outside of the firewall. If Telnet works, BGP will work, since telnet and BGP both use TCP to transport data
There is no way to make BGP work across a firewall
There is no way to make BGP work across a firewall
Ping from the router connected to the inside interface of the firewall to the router connected to the outside interface of the firewall. If you can ping between them, BGP should work, since BGP uses IP to transport packets.
Ping from the router connected to the inside interface of the firewall to the router connected to the outside interface of the firewall. If you can ping between them, BGP should work, since BGP uses IP to transport packets.
Suggested answer: B
asked 18/09/2024
Francesco Facco
36 questions

Question 27

Report Export Collapse

Which of the following can be used for BGP route selection? (Multiple Choice)

DSCP
DSCP
IP-PREFIX
IP-PREFIX
ACL
ACL
AS-PATH-FILTER
AS-PATH-FILTER
Suggested answer: B, C, D
asked 18/09/2024
Paulina Radziszewska
39 questions

Question 28

Report Export Collapse

Authentication can be configured in the IS-IS protocol to enhance IS-IS security. The IS-IS authentication functions include interface authentication, area authentication, and routing domain authentication.

FALSE
FALSE
TRUE
TRUE
Suggested answer: B
asked 18/09/2024
Gianmarco Salvaticchio
32 questions

Question 29

Report Export Collapse

Each DD packet has a DD sequence number for packet acknowledgment. A DD sequence number is two-bytes long.

TRUE
TRUE
FALSE
FALSE
Suggested answer: B
asked 18/09/2024
Javier Portabales
44 questions

Question 30

Report Export Collapse

You must configure a router for Policy Based Routing (PBR). PBR allows network administrators to implement routing policies to allow or deny paths on which of the following? (Multiple Choice)

Protocol
Protocol
Identification of a particular end system
Identification of a particular end system
Application
Application
Throughput
Throughput
Size of packets
Size of packets
Suggested answer: A, B, C, E
asked 18/09/2024
Rama Krishna
42 questions
Total 298 questions
Go to page: of 30
Open VPLUS File
Convert VPLUS to PDF

Related questions

Which of the following statements regarding CE dual-homing features is false?
Which packet type is used when BGP EVPN is used to establish VXLAN tunnels?
Subnets of one subnet is as follows: RT=10:10 both and TR=1000:1000 export in the EVPN instance and RT=100:100 in the VPN instance. Which of the following configurations can be made for another subnet?
Which of the following statements regarding Filter-policy is true?
Which of the following statements regarding the stub area and NSSA in OSPF is false?
Which of the following AS-_Path attribute values can be matched by the AS-Path filter configured using ip as-path filter 1 permit .*(100|400$command?
The VRRP priority cannot be set to 0, so the device that sends a VRRP packet with priority 0 stops participating in the VRRP group and notifies the backup device to become the master device right away, without waiting for the Master_Down_Interval timer to expire?
The Next Header field only exists in the basic header of an IPv6 packet, and its function is only to indicate whether the IPv6 packet has an extension header.
Assume that BGP/MPLS IPv4 VPN configured with OSPF, LDP, and static routing has been deployed on a PE router. To enable the NSF function, which of the following protocols need to be configured to enable the GR function on the PE router?
On router HW1, you want to view the status of a frame relay connection. Which "display" commands will show the status of a Frame-Relay PVC? (Multiple choice)