Huawei H12-831_V1.0 Practice Test - Questions Answers, Page 9

A campus has deployed IPv6 for service testing. In the early stage of deployment, engineers wanted to achieve network interoperability through IPv6 static routes. When creating an IPv6 static route. You can specify both the outbound interface and the next hop, or only the outbound interface or only the next hop.

When configuring the DHCP Relay function on the device, the VLAN ANIF interface of the relay connection client must be bound with a DHCP server group, and the IP address of the proxy DHCP server must be configured in the bound DHCP server group.

When MPLS is deployed in the network and the network layer protocol is IP, the route corresponding to the FEC must exist in the IP routing table of the LSR, otherwise the label forwarding entry of the FEC will not take effect.

In the DU label distribution mode, if the Liberal retention mode is adopted, the device will retain the labels distributed by all LDP peers, regardless of whether the LDP peer is the optimal next hop to the destination network segment.

The rollback operation of project cutover can be temporarily determined according to the situation during cutover, and no advance plan is required.

In BGPIMPLS IP VPN, if the OSPF protocol is used between PEs and CEs to exchange routing information, the domain identifier (Domain ID) is used to distinguish whether the incoming routes in the VPI instance come from the same OSPF domain.

If you want to check the files under Flash, which command should you use?

Which of the following descriptions is correct about configuring static LSPs in MPLS networks?

(Multiple Choice) Which LSAs in OSPFv3 can be flooded in an area?