Home / Huawei / H12-891

Huawei H12-891 Practice Test - Questions Answers, Page 29

Question list

List of questions

Question 281

(0)

Regarding BGP/MPLS IP VPN routing interactions, the following description is incorrect?

Question 282

(0)

Regarding the BGP/MPLS IP VPN network architecture, what is the error described below?

Question 283

(0)

RTA is the source DR router, RTB is the RP router, and the multicast source sends multicast data to the RTA, but the PIM is not visible on the RTB Register the multicast source to which the message

Question 284

(0)

Regarding the description of the permanent multicast address, the error is ?

Question 285

(0)

If all the public IP addresses are used by a company's intranet users to access the Internet using NAT's No-pat method, what will happen to subsequent intranet users who access the Internet?

Question 286

(0)

The correct statement about the VRRP protocol version is ?

Question 287

(0)

The Layer 3 logical interface on XLAN L3 Gateway that enables communication between different VXLAN virtual networks is ?

Question 288

(0)

The RSTP protocol provides a variety of protection functions, such as when the edge port is configured as a protection state, the edge port receives the BPDU packet processing method;

Question 289

(0)

The role of Link-LSA in OSPFv3 does not include ?

Question 290

(0)

Regarding BGP MED, which of the following descriptions is correct?

Question 281

Regarding BGP/MPLS IP VPN routing interactions, the following description is incorrect?

The ingress PE changes the IPv4 route received by the CE to the VPNv4 route, and the storage

PE is carried out according to different VPN instances What interacts with the CE is IPv 4 routing information

After receiving the VPNv4 route issued by the ingress PE, the egress PE filters the VPNv4 route according to the RT attribute carried by the route

The egress PE can send an IPv4 route to the remote CE via BGP, IGP, or static routing

Show Answer Comment (0)

Question 282

Regarding the BGP/MPLS IP VPN network architecture, what is the error described below?

sites can be accessed each other through vPNs, and a site can only belong to a VPN

P devices only need basic MPLS forwarding capabilities and do not maintain VPN-related information

BGP/MPLSIPVPN network architecture consists of CE (Customer Edge), PE (Provider Edge) and P (Provider), of which PE and P Is a carrier device, CE is BGP/MPLSIPVPN with Household equipment

Under normal circumstances, CE devices are not aware of the presence of VPN, and CE devices do not need to support MPLS MP-BGP, etc

Show Answer Comment (0)

RTA is the source DR router, RTB is the RP router, and the multicast source sends multicast data to the RTA, but the PIM is not visible on the RTB Register the multicast source to which the message is registered, then the possible causes are ?

Multicast network statically configures RP, while RTA router does not statically configure RP

The RP elected by RTA is not an RTB

RTB to RTA has no unicast routing, causing the RTB to fail RPF checks for the source

The multicast network dynamically elects the RP instead RTA failed RPF check for BSR

Show Answer Comment (0)

Question 284

Regarding the description of the permanent multicast address, the error is ?

All routers running the PIM protocol listen on 22400100

All routers listen on 224002

All hosts and routers in the network segment listen on 224001

All routers running the OSPF protocol listen to 224005

Show Answer Comment (0)

Question 285

If all the public IP addresses are used by a company's intranet users to access the Internet using NAT's No-pat method, what will happen to subsequent intranet users who access the Internet?

automatically switch NAT to PAT after the Internet

Subsequent intranet users will not be able to access the Internet

Synchronize messages to other NAT conversion devices for NAT conversion

Squeeze out the previous user and force NAT conversion to go online

Show Answer Comment (0)

Question 286

The correct statement about the VRRP protocol version is ?

VRRPv2 is only available for IPv4

VRRPv3 does not support authentication

VRRPv2 supports authentication

VRRPv3 is only available for IPv6

Show Answer Comment (0)

Question 287

The Layer 3 logical interface on XLAN L3 Gateway that enables communication between different VXLAN virtual networks is ?

Layer 2 sub-interface

NVE interface

VBDIF interface

VLANIF interface

Show Answer Comment (0)

Question 288

The RSTP protocol provides a variety of protection functions, such as when the edge port is configured as a protection state, the edge port receives the BPDU packet processing method;

Directly discard the BPDU packet

Close the port

After parsing the BPDU message, the relevant information is obtained

Forward BPDU packets as required

Show Answer Comment (0)

Question 289

The role of Link-LSA in OSPFv3 does not include ?

Advertise to other routers on the link optional that is set in the Network LSA from which this link originates

Advertise the per-port ID of this router to other routers on the link

Advertise the link-local address

of this interface to other routers on the link Advertise this IPv6 prefix list to other routers on the link

Show Answer Comment (0)

Question 290

Regarding BGP MED, which of the following descriptions is correct?

In the BGP routing rules, MED has a lower priority than AS Path, Praferred-value, Local-Preference, etc Origin

The default value for the B. BGP routing MED is 0

By default, if there is no MED value in the route attribute, it is processed by 0 If the bestroute med-none-as-maximum command is configured, MED is processed as the maximum 4294967295

By default, BGP routing rules can MED comparison of routes from different autonomous systems

Show Answer Comment (0)

Total 610 questions