Home / Huawei / H12-891

Huawei H12-891 Practice Test - Questions Answers, Page 60

Question list

List of questions

Question 591

(0)

As shown below, what routes will R2 learn?( Single choice questions).

Question 592

(0)

View the details of all VPN instances on a network device and the results are as follows, which of the following statements is wrong?( Multiple choice questions).

Question 593

(0)

As shown in the figure, the use of redundant links between the branch and the headquarters to establish IPsecVPN, while turning on URLPF on the Router_B for traffic from branch l, which of the follo

Question 594

(0)

As shown in the figure, which of the following options satisfies two routers to establish an ISIS neighbor?( Single choice questions).

Question 595

(0)

The switch SWA and SWB are connected together by 2 Ethernet links, where the switch SWA has the following interface configuration:

Question 596

(0)

As shown in the figure, as shown, as the AS10 has two paths to access THEA1, the optimal route passed from the 4S23 by default is now sprinkled with S00 to ass4O The odds belt wins even more worryin

Question 597

(0)

A multi-protocol network, the topology is shown in the figure. Take a closer look at the topology, router R4 (in Areal) is introduced into the OSPF process via the routes learned by BGP. So what cat

Question 598

(0)

Is the following figure correct about NDP's process of resolving link-layer addresses?

Question 599

(0)

result :(moloteric question).

Question 600

(0)

As shown in the figure, SWA, SWB, SWC all run RSTP, GED/O/2 on SWB Ports and GEO/0/1 ports on SWC have a port role of ? Radio

Question 591

As shown below, what routes will R2 learn?( Single choice questions).

R2 can learn the 101.20/24 and 101.30/24 routes.

R2 can learn the 101.1.0/24 route.

R2 can receive an LSP for R1, but cannot join to the routing table.

R2 can learn all routes to R1.

Show Answer Comment (0)

Question 592

View the details of all VPN instances on a network device and the results are as follows, which of the following statements is wrong?( Multiple choice questions).

The total number of instances that enable the IPv6 address family in the VPN configured on this side is 1 .

VPN-Instance vpna does not receive VPN routes with an RT of 2:1.

The GigabitEthernet 1/0/0 interface is tied to the VPN-Instance vpna

The device assigns a label to each route of the VPN-Instance vpna.

Show Answer Comment (0)

As shown in the figure, the use of redundant links between the branch and the headquarters to establish IPsecVPN, while turning on URLPF on the Router_B for traffic from branch l, which of the following options is correct?

When using IPsec active-standby link redundant backups to enable the URPF function under the physical interface , it is recommended to use URPF loose mode.

When using IPsec multilink redundant backup, the URPF function can be used under the physical interface, and URPF strict mode can be used

When using IPsec multilink redundant backups, urPF can be enabled under the tunnel interface, and URPF strict mode can be used

When using lPsec active-standby link redundancy backup, the URPF function is enabled under the physical interface, and URPF strict mode can be used.

Show Answer Comment (0)

Question 594

As shown in the figure, which of the following options satisfies two routers to establish an ISIS neighbor?( Single choice questions).

Both routers are of The Level-1 type. B. Both routers remain of the default type.

One of the two routers can be of the Level-1-2 type and the other of the Leve1-1 type. D. The ISIS process numbers of the two routers must be consistent.

Show Answer Comment (0)

Question 595

The switch SWA and SWB are connected together by 2 Ethernet links, where the switch SWA has the following interface configuration:

Without changing the current configuration, GigabitEthernet1/0/1 and GigabitEthernet1/0/2 can join the same aggregation group

Because of the different VLANs allowed, GigabitEthernet1/0/1 and GigabitEthernet1/0/2 cannot join the same aggregation group

After link clustering is configured on both SWA and SWB, if MSTP is enabled on the switches SWA and SWB Both GigabitEthernetl1/0/1 and GigabitEthernetl/O/2 are the forwarding status of MSTP

Only if the configuration of GigabitEthernet 1/0/2 is changed to match GigabitEthernet 1/0/1 can the two join the same aggregation group

Show Answer Comment (0)

Question 596

As shown in the figure, as shown, as the AS10 has two paths to access THEA1, the optimal route passed from the 4S23 by default is now sprinkled with S00 to ass4O The odds belt wins even more worrying. Therefore, in the R2 configuration as follows, after the completion of the coordination, it is found that the most worrying route has not changed, and some operations can be adjusted to make the configuration ??[ R2]jpas-path-fiter l permit "4D0& [2]pouteplicy med permit node 10[R2-routepolicyli- match aspath-ilterl[R2-oute-policylapplycoast.20

Configure compare-di fferent-as-med under the BGP process for R2

Configure destiny-med under the BGP process for R1

Configure compare-di fferent-as-med under the BGP process of Rl

Configure the targeted-med under the BGP process for R2

Show Answer Comment (0)

Question 597

A multi-protocol network, the topology is shown in the figure. Take a closer look at the topology, router R4 (in Areal) is introduced into the OSPF process via the routes learned by BGP. So what categories of LS4 will R3 advertise to zone 0?

( Multiple choice questions).