Huawei H12-891 Practice Test - Questions Answers, Page 59

As shown in the following figure, a part of the LSDB LSDB of a router LSDB is shown in the first one in the following figure. A new LSP has been received, the second one in the figure below, and the following statement is incorrect (single choice).

As shown in the figure, all routing diagrams declare the loopback address in OSPF, where R2 does not return the address is 10022/32, it is advisable to tell AraD. The R3 loopback address is 10033/321001.1.0/24 external routing, in order to reduce the burden on the RI router, the configuration command is as follows:( Multiple choice questions)[Rlip ip-prefix 1 permit 001.1.024 [RLIJospfl [RL-ospf-1]filter-policy ip-prefix l import please ask the following description is correct?

The following topology diagram is available, and it is correct to analyze the following statement accordingly

As shown in the figure, Department A of Branch 1 has access to the Internet, but Department B can only use an encrypted VP to access headquarters resources, and NAT can be configured on the egress device The policy enables Department A to access the Internet, while the PSecVPN (ESP Protocol) + Tunnel mode method configured for Department B gives it access to headquarters.

A company's two-layer phase network architecture as shown in the figure, when the engineer is configured to find that the business between departments can not communicate, through the command to view the status of the equipment as follows, please determine the possible causes?

As shown in the following figure, R1, R2, R3 establish a neighbor relationship of Level2 The IP routing table for R3 is correct (multiple choice).

The data results of a router are as follows, and the analysis conclusion is correct (single choice).

As shown in the figure, a company wants to achieve secure mutual access between the head office and branches through MPLSVPN, and at the same time requires that the IPN traffic of the branch bank must be forwarded through the head office to achieve traffic monitoring

As shown in the figure, three switches S1, SW, and SN3, where SWI is the root bridge, and link congestion occurs between SI and SW2, SWD cannot receive the configuration BPDU sent by the root bridge, which spanning tree protection mechanism does the administrator need to configure to prevent the problem caused by link congestion?( Single choice questions).