ExamGecko
Home / Huawei / H35-260 / List of questions
Ask Question

Huawei H35-260 Practice Test - Questions Answers, Page 14

Add to Whishlist

List of questions

Question 131

Report Export Collapse

An OSN 9800 ring network is configured with ODUK ring network protection. Now a section of the optical cable on the ring needs to be reconstructed. In order to avoid frequent repetition of services during the reconstruction, which of the following operations should be performed?

Become a Premium Member for full access
  Unlock Premium Member

Question 132

Report Export Collapse

A certain wavelength division system is configured with the 1st to 20th waves, using the NS4 single board, and testing the M40 output port with a spectrum analyzer during commissioning. It is found that the optical power of the 20th wave is significantly lower than the other 19th waves. What is the possible reason? ?

Become a Premium Member for full access
  Unlock Premium Member

Question 133

Report Export Collapse

A company has a class C IP address segment 198.160.110.0/24. The company has 6 departments, each department is located in a different subnet, and the number of hosts in each subnet is the same as 25-30. Which of the following can be used as the subnet mask to reasonably plan the P address space?

Become a Premium Member for full access
  Unlock Premium Member

Question 134

Report Export Collapse

In the current network, which of the following is the most common way of dividing VUNs?

Become a Premium Member for full access
  Unlock Premium Member

Question 135

Report Export Collapse

When configuring GE services, the types of services in one direction can be different for the transmission and reception of a service.

Become a Premium Member for full access
  Unlock Premium Member

Question 136

Report Export Collapse

When configuring the L3VPN service, which operation will cause the service configuration to fail?

Become a Premium Member for full access
  Unlock Premium Member

Question 137

Report Export Collapse

When configuring electrical layer crossing, what are the rules for time slot configuration?

Become a Premium Member for full access
  Unlock Premium Member

Question 138

Report Export Collapse

If the E1 interface board D75S is not plugged into the OSN3500 hardware, the indicator on PQ1 will light up red

Become a Premium Member for full access
  Unlock Premium Member

Question 139

Report Export Collapse

Which of the following descriptions is correct?

Become a Premium Member for full access
  Unlock Premium Member

Question 140

Report Export Collapse

Which of the following descriptions are correct?

Become a Premium Member for full access
  Unlock Premium Member
Total 338 questions
Go to page: of 34