ExamGecko
Home / Huawei / H35-260 / List of questions
Ask Question

Huawei H35-260 Practice Test - Questions Answers, Page 18

Add to Whishlist

List of questions

Question 171

Report Export Collapse

Which of the following are the possible causes of PW failures in the network?

Become a Premium Member for full access
  Unlock Premium Member

Question 172

Report Export Collapse

Which of the following Ethernet port alarms is not a physical layer alarm, that is, LSR_NO_HTED has no correlation with it, and there is no suppression relationship?

Become a Premium Member for full access
  Unlock Premium Member

Question 173

Report Export Collapse

Which of the following options is not the cause of the R-LOF alarm?

Become a Premium Member for full access
  Unlock Premium Member

Question 174

Report Export Collapse

Now NE1 and NE2 form a chain network, and E1 service is configured between NE1 and NE2. One day, the fiber from NE1 to NE2 is interrupted (each segment of the reverse fiber). Which of the following alarms will NE2 report?

Become a Premium Member for full access
  Unlock Premium Member

Question 175

Report Export Collapse

The signal-to-noise ratio is an important factor that limits the DWDM system, and the source of the noise is which of the following single boards are widely used in the system?

Become a Premium Member for full access
  Unlock Premium Member

Question 176

Report Export Collapse

Which networking type is the main networking type in the metro WDM network?

Become a Premium Member for full access
  Unlock Premium Member

Question 177

Report Export Collapse

It is known that the nominal value of single-wave input and output of OAU101 is -16/+4dbm, and the gain range is 20?31db. If there is a wave of -20dbm signal at the input end, use DCM (A) (insertion loss 4db), which is To make it reach the nominal output, the gain on the network management should be set to which of the following values

Become a Premium Member for full access
  Unlock Premium Member

Question 178

Report Export Collapse

In the Ethernet LAG, which of the following modes needs to enable the LACP protocol?

Become a Premium Member for full access
  Unlock Premium Member

Question 179

Report Export Collapse

Of the following protections, which items are protected by the double transmission and reception of the electrical layer?

Become a Premium Member for full access
  Unlock Premium Member

Question 180

Report Export Collapse

Which of the following parameter settings will cause PW creation to fail?

Become a Premium Member for full access
  Unlock Premium Member
Total 338 questions
Go to page: of 34