What is a primary benefit of DAS?

It is connected directly to a server.

It takes advantage of Common Internet File System (CIFS).

It is presented as an iSCSI LUN to the attached server.

It can be accessed by both server and non-server devices simultaneously.

It is connected directly to a server.

Refer to the exhibit. When performing a code upgrade on an HPE Nimble array, you noticed a connection failure on ESX1.Refer to the exhibit showing the complete zoning configuration of one of the HPE SN3000B switches.What should you do to ensure storage access is not interrupted when doing the next update?

Create a new zone for ESX1 and the second storage controller.

Create and ISL between the two HPE SN3000B switches.

Create a new zone for ESX1 and the second storage controller.

Change the timeout values on the SN3000B switch.

Configure the same zone on a second HPE SN3000B.

You have configured a port on an HPE FlexFabric 5900 series switch that is connected to a VMware ESXi server to support multiple VLANs. Given the configuration above, what should happen to any of the untagged traffic coming from the VMware ESXi host?

The untagged traffic will be transmitted in vlan 50.

The untagged traffic with be dropped.

The untagged traffic will be transmitted in vlan 2.

The untagged traffic will be transmitted in vlan 50.

The untagged traffic will be transmit.ted in vlan 1.

Which hardware and software components make up a Nimble dHCI infrastructure?

HPE M-Series switch, HPE ProLiant DL servers, HPE Nimble, and VMware

Aruba Switches, HPE Synergy, HPE Nimble, and VMware

HPE M-Series switch, HPE ProLiant DL servers, HPE Nimble, and Hyper-V

Aruba Switches, HPE Synergy, HPE Nimble, and Hyper-V

Refer to the exhibit. An administrator connected a hypervisor to interface Ten-GigabitEthernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. VLAN 10 is configured to be tagged, and VLAN 20 is configured to be untagged on the hypervisor.The administrator found that all the virtual machines in VLAN 20 can communicate with each other, but not with any virtual machines on VLAN 20 external to the hypervisor.Given the output in the exhibit, customer needs a new environment to support an ERP system. The sizing information you received shows the following

Configure the PVID of the interface to be VLAN 20.

Permit VLAN 1 on the interface.

Configure the PVID of the interface to be VLAN 20.

Configure the interface as an access port.

Configure the interface as an IRF port. check

A customer is planning to deploy a new Top of Rack solution. They plan to use a stacking technology that meets the following requirements:Support for Multi Chassis Link Aggregation in an active-active mode.The control plane must not be a single point of failure.Rapid Fail-over. Unified Management.They require a maximum of two switches per stack.Which stacking technology meets the customer's requirements?

Aruba Virtual Switching Extension (VSX)

HPE Intelligent Resilient Framework (IRF)

Aruba Virtual Switching Extension (VSX)

Aruba Virtual Switching Framework (VSF)

A customer environment is being managed and monitored with HPE OneView. A review of the OneView log shows that there have been several trap storm events.Which series of events must take place for OneView to insert a Trap Storm event entry into the log of system events?

Four or more identical SNMP traps have been logged within the past 30 seconds.

SNMP traps from three or more identical hosts have been logged within the past 256 seconds.

Four or more identical SNMP traps have been logged within the past 30 seconds.

Three or more SNMP trap messages have been logged with increasingly critical variable string values.

Four or more ports on the same network switch have reported sequential SNMP trap mesages

You are installing an HPE Nimble HF20 into a customer's existing rack.Prior to installation, what should you consider?

HPE recommends racks with a depth of 1200 mm

An HPE Nimble array has left-to-right airflow

HPE recommends installing the HPE Nimble array at the top of the rack

The HPE Nimble array will require 3-phase power

HPE recommends racks with a depth of 1200 mm

HPE support asks you to provide the Active Health System log from HPE StoreEasy 1660 Storage to expedite a troubleshooting process.Which procedures will generate the AHS log for HPE Support? (Choose two.)

Boot to Intelligent Provisioning and download the AHS log from maintenance section

Configure Remote Support on the iLO to send the log to HPE

Download the AHS log from Server Manager dashboard

Download the AHS log from Federation dashboard in StoreEasy Management Console

Log in to the StoreEasy system with SSH and use the hpessacli command

Boot to Intelligent Provisioning and download the AHS log from maintenance section

Configure Remote Support on the iLO to send the log to HPE

Refer to the exhibit. You are asked to review a server configuration for a customer before it is quoted. The server will be used in a business-critical environment and high availability is required. The server configuration is shown in the exhibit.What should be added to the configuration to ensure availability?

HPE 800W Flex Slot Platinum Hot Plug Low Halogen Power Supply Kit

HPE Smart Array P408i-a SR Gen10 12 G SAS Modular Controller

HPE DL380 Gen10 Intel Xeon-Gold 6143 (2.8 GHz/16-core/205 W) Processor Kit

HPE 800W Flex Slot Platinum Hot Plug Low Halogen Power Supply Kit

HPE DL38X Gen10 12 Gb SAS Expander Card Kit

A customer acquires an HPE 3PAR Storeserv 8200 Solution for a data center environment with the following configuration:2 Controllers NodesPhysical Service Processor2-tier configuration using 16 SSD and 12 NL HDD2 SN3000 San Switch each with 24 FC portsAfter installation and configuration, the storage is put in production. When tiering with the Adaptive Optimization SW is being performed, the customer encountered performance differential issue.What could be the cause of this issue?

Solid State Drives and Nearline Drives are mixed.

Disk enclosure are insufficient.

All-inclusive Multi-system software is missing.

Solid State Drives and Nearline Drives are mixed.

A customer needs to locate an exact time when a link down event occurred at the FC port of Nimble storage Which on-premises tool can the customer use?

HPE Nimble Storage web-based user interface

HPE StoreServ Management Console

Which factors are used to determine RAM configuration maximum memory capacity? (Choose two.)

number and model of qualified processors

largest DIMM capacity qualified on the server

number and model of qualified processors

largest DIMM capacity qualified on the server

number of cores in the processor

Read the question, and then refer to the exhibit.<Switch-A>display interface Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state:Administratively DOWN Line protocol state: DOWN IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK_SFP_PLUS Unknown-speed mode, unknown-duplex modeLink speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100%PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10, 20 VLAN permitted: 10, 20 Trunk port encapsulation: IEEE 802.1q Port priority: 0 Last link flapping: 0 hours 0 minutes 18 seconds Last clearing of counters:Never Peak input rate: 78 bytes/sec, at 2011-03-31 04:55:57 Peak output rate: 15 bytes/sec, at 2011- 03-30 23:00:57 Last 300 second input: 0 packets/sec 67 bytes/sec - % Last 300 second output: 0 packets/sec 14 bytes/sec - % Input (total): 62670 packets, 8565340 bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input (normal): 62670 packets, - bytes 0 unicasts, 0 broadcasts, 62670 multicasts, 0 pauses Input: 0 input errors, 0 runts, 0 giants, 0 throttles 0 CRC, 0 frame, - overruns, 0 aborts – ignored, - parity errors Output (total): 3707 packets, 1294835 bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output (normal): 3707 packets, - bytes 0 unicasts, 0 broadcasts, 3707 multicasts, 0 pauses Output: 0 output errors, - underruns, - buffer failures 0 aborts, 0 deferred, 0 collisions, 0 late collisions 0 lost carrier, - no carrier A customer added a new switch to their network. They connected it using interface Ten-GigabitEthernet 1/0/1. They are using VLAN 10 and 20 for the devices in their network.The new switch was fully operational. Then, the customer experienced a power failure later that day and could not reach any device on the new switch after the power returned.From the output in the exhibit, would could be the issue?

The interface is administratively down.

The interface loopback is not set.

The interface link-speed and duplex are unknown.

The interface is administratively down.

The interface is configured for a PVID of VLAN 1.

A customer needs to move from their traditional tape-based backup infrastructure to a standalone application to disk based backup solution using HPE StoreOnce. The environment does not use a hypervisor.The customer has the following goals for their long-term backup retention: retain data for over two years at low cost data is archival and rarely accessed, if ever Which HPE StoreOnce components can help meet the customer goals in the most cost effective manner? (Choose three.)

HPE StoreOnce Cloud Bank Storage license

What does the term composable mean when applied to HPE infrastructure?

to simplify and accelerate DevOps and business innovation

hardware-defined infrastructure

to provide all-flash like performance, but at a hybrid price point

to simplify and accelerate DevOps and business innovation

Read the question, and then refer to the exhibit.<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description:Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio:100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.What must you do to resolve this issue?

Permit VLAN 20 on the interface.

Configure the interface as an access port.

Configure the PVID of the interface to be VLAN 20.

Permit VLAN 20 on the interface.

Configure the interface as an IRF port.

You are reviewing a series of MSA2052 storage designs for a customer's remote locations. Their largest remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?

12 HPE MSA 2 TB drives, configured with RAID6

14 HPE MSA 2 TB drives, configured with RAID1

8 HPE MSA 2 TB drives, configured with RAID5

10 HPE MSA 2 TB drives, configured with RAID0

12 HPE MSA 2 TB drives, configured with RAID6

HP HPE0-V14 Practice Test 2 - Free Online Exam Questions 41-80

Question 1 / 40

A customer needs to verify inbound packet statistics for interfaceTen-GigabitEthernet 1/0/10 on an HPE FlexFabric 5900 series switch used by an iSCSI storage array.

Which command can be used in the CLI to perform this operation?

show inbound counters port 1/0/10

display counters inbound interface Ten-GigabitEthernet 1/0/10

display all statistics from port 1/0/10

interface Ten-GigabitEthernet 1/0/10 show counters

Comment (0)

HP HPE0-V14 Practice Test 2

Question

HP HPE0-V14 Practice Tests

Practice Tests