Ask Question
HP HPE0-V15 Practice Test - Questions Answers
List of questions
Question 1
What does the term composable mean when applied to HPE infrastructure?
Infrastructure that can be provisioned on the fly with software-defined intelligence allows for optimal application performance. Logically pooling resources reduces both underutilization and overprovisioning to create a more agile, cost-effective data center. A unified management interface integrates formerly siloed infrastructure and operations and allows IT to be offered as a service, enabling modern DevOps practices to be adopted by organizations with critical legacy applications that need to remain on premises.
Question 2
When configuring a single ProLiant Gen10 server, which embedded tool can be used to deploy a reliable and consistent configuration?
Reference: https://support.hpe.com/hpesc/public/docDisplay?docId=a00026391en_us&docLocale=en_US#:~:text=Intelligent%20Provisioning%20is%20a%20single,later% 20includes%20HPE%20SMB%20Setup.
Question 3
Read the question, and then refer to the exhibit.
<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description:
Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio:
100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?
Question 4
You are reviewing a series of MSA2052 storage designs for a customer's remote locations. Their largest remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?
Reference: https://h20195.www2.hpe.com/V2/getpdf.aspx/a00008277enw.pdf
Question 5
What is the correct cable type to use when connecting a server to a switch using 10 Gbps Short Range (SR) SFP+ optical connections?
Reference: https://support.hpe.com/hpesc/public/docDisplay?docId=c02705558
Question 6
A customer needs a server memory subsystem that meets the following requirements: approaches the speed of traditional DRAM ensures high capacity, high performance, and ongoing data safety in case of a power failure Which HPE memory feature meets the customer needs?
Reference: https://www.hpe.com/emea_europe/en/servers/persistent-memory.html
Question 7
DRAG DROP
Match the speed and protocol with the appropriate component.
Reference: https://support.hpe.com/hpesc/public/docDisplay?docLocale=en_US&docId=emr_naa00035594en_us
Question 8
Refer to the exhibit.
You are validating a Nimble HF40 configuration created in OCA, and you receive an error when you run a CLIC check.
Which Nimble component needs to be added to the configuration to complete the solution?
Question 9
Which storage array feature records only changes made to the base volume and keeps an earlier state of the original volume?
Reference: https://assets.ext.hpe.com/is/content/hpedam/a00093683enw (10)
Question 10
A local state college is implementing a new VDI cluster to support computer and testing labs. They have the following requirements:
Three VMware ESXi Hosts, each with one AMD processor, 1 TB of RAM, 16 Gbps FC Dual Port HBA.
HPE Nimble AF20 with 17 TB usable capacity.
Integration into an existing HPE FlexFabric 5710 and HPE SN3000B Fibre Channel SAN switches.
The solution must fit in 7U of rack space. If the customer needs more capacity in the future, they will use scale-out growth.
Which server model should you recommend to this client?
Related questions
Export
If you didn't receive an email within 5 minutes, you should submit a support request to [email protected].
|
BASIC - 1 Month
$
10
Full latest questions
No CAPTCHA
New Updates
Export to VPLUS
Export to PDF - All questions
Team support
|
PLUS - 2 Months
$
15
Full latest questions
No CAPTCHA
New Updates
Export to VPLUS
Export to PDF - All questions
Team support
|
PRO - 6 Months
$
40
Full latest questions
No CAPTCHA
New Updates
Export to VPLUS
Export to PDF - All questions
Team support
|
Full latest questions
No CAPTCHA
New Updates
Export to VPLUS
Export to PDF - All questions
Team support
Full latest questions
No CAPTCHA
New Updates
Export to VPLUS
Export to PDF - All questions
Team support
Full latest questions
No CAPTCHA
New Updates
Export to VPLUS
Export to PDF - All questions
Team support
Selling illegal goods, money scams etc.
Serious attack on a group.
Harassing an individual (including doxing)
Threatening or glorifying violence or serious harm, including self-harm
Nudity/Sexual content
Sexually explicit or suggestive imagery or writing involving minors
Sexually explicit or suggestive imagery or writing involving non-consenting adults or non-humans
Reusing content without attribution (link and blockquotes)
Not in English or has very bad formatting, grammar, and spelling
Author's credential is offensive, spam, or impersonation
Ex. Illegal content, incomplete question...
Question