Home / HP / HPE0-V15

HP HPE0-V15 Practice Test - Questions Answers, Page 8

Question list

List of questions

Question 71

(0)

DRAG DROP Refer to the exhibit. Drag the correct protocols from the left to the appropriate area on the topology on the right.

Question 72

(0)

A customer needs to add storage capacity to a host In a remote branch office. They have limited IT resources, so the solution requires ease of integration at a low price point Which HPE Storage fami

Question 73

(0)

What is the process or writing data to two locations within a single array in real time?

Question 74

(0)

A customer purchased a Nimble HF20 a year ago They are experiencing an issue with a few of their VMware servers in the RTP Nimble date center and asked that you make a recommendation based on the da

Question 75

(0)

Which feature in a block storage array is effective in decreasing the size of blocks?

Question 76

(0)

A customer requests a quote for an HPE storage solution that meets these requirements • fully redundant dual-controller storage array with no single points of failure • 1 Gb or 10 Gb ISCSI connect

Question 77

(0)

A customer is facing high and unpredictable latency on an HPE ProLiant DL380 Gen10 server equipped with P408i-a controller Which tool can display an Array Diagnostic Report?

Question 78

(0)

Which HPE Proliant server should you recommend for a home office environment where the server will be located in the same office as the user?

Question 79

(0)

What is used to identify a storage HBA port in a Fibre Channel SAN fabric?

Question 80

(0)

A customer wants to optimize the performance of its storage array by moving data residing in one class of disks to a more appropriate class of disks based on data access patterns without manual inte

Related questions

What does the term composable mean when applied to HPE infrastructure?

A customer needs to add storage capacity to a host In a remote branch office. They have limited IT resources, so the solution requires ease of integration at a low price point Which HPE Storage family best meets these needs?

Which network protocol is used to build a loop-free logical topology for Ethernet networks?

You are discussing storage types with a customer that is configuring their NAS solution. The company's application developers use user-generated media and image files. For which type of data should this customer use file storage?

An administrator has two switches connected with a single link. The administrator observes that, during hours of peak activity, the storage traffic tends to consume the link. The link is shared with other types of traffic that is time sensitive. What technology can the administrator use to help alleviate the situation while they are working towards a long-term solution?

A customer requires an entry-level, all-flash system with predictable performance at the lowest possible price. They have performance-sensitive workloads that require speed and efficiency. Which HPE storage system needs the customer's requirements?

A customer has a single HPE ProLiant Gen 10 server. Which embedded management tool should they use to monitor the server?

A customer needs a solution for a rack of servers. They need connectivity for 14 HPE DL380 servers, which each have two 10-GBASE-T Ethernet ports, and 10 HPE DL360 servers, which have two 10GBASE-X SFP+ Ethernet ports. They need switch redundancy for each server and want to connect all servers to the same switch stack. The client also needs a 400 Gb backbone connection to the data center core switch from the solution you are creating. Which architecture meets the customer requirements?

You are reviewing a series of MSA2052 storage designs for a customer's remote locations. Their largest remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?

Read the question, and then refer to the exhibit. <Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description: Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio: 100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor. The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor. What must you do to resolve this issue?

Question 71

DRAG DROP

Refer to the exhibit.

Drag the correct protocols from the left to the appropriate area on the topology on the right.

Show Answer Comment (0)

Question 72

HPE D3000 Enclosure

HPE 3PAR StoreServ

HPE MSA Storage Array

HPE NimbIe Storage

Show Answer Comment (0)

Question 73

What is the process or writing data to two locations within a single array in real time?

replication

business continuity

data mirroring

clustering

Show Answer Comment (0)

A customer purchased a Nimble HF20 a year ago They are experiencing an issue with a few of their VMware servers in the RTP Nimble date center and asked that you make a recommendation based on the data in infoSight.

What should you recommend'?

Add cache to the array for the RTP Nimble Datacenter.

increase the cache size for VMware-DS-Space-NoDeDup

increase the datastore size for VMware-DS-Space-NoDeDup.

Add another datastore for the RTP Nimble Datacenter

Show Answer Comment (0)

Question 75

Which feature in a block storage array is effective in decreasing the size of blocks?

thin provisioning

thick provisioning

compression

deduplication

Show Answer Comment (0)

Question 76

A customer requests a quote for an HPE storage solution that meets these requirements

• fully redundant dual-controller storage array with no single points of failure

• 1 Gb or 10 Gb ISCSI connectivity

• at least four host-facing ISCSI ports

• capable of expanding usable capacity in small increments of one-to-two disks Which HPE storage solution should be proposed?

D3000

MSA 1050

Nimble AF20Q

Nimble HF20

Show Answer Comment (0)

Question 77

A customer is facing high and unpredictable latency on an HPE ProLiant DL380 Gen10 server equipped with P408i-a controller Which tool can display an Array Diagnostic Report?

Smart Storage Administrator

HPE OneView

UEFl Embedded Diagnostics

HPE InfoSight

Show Answer Comment (0)

Question 78

Which HPE Proliant server should you recommend for a home office environment where the server will be located in the same office as the user?

HPE ML110

HPE DL20

HPE MicroServer

HPEXL170r

Show Answer Comment (0)

Question 79

What is used to identify a storage HBA port in a Fibre Channel SAN fabric?

WWN

MAC Address

SCSI ID

ION

Show Answer Comment (0)

Question 80

A customer wants to optimize the performance of its storage array by moving data residing in one class of disks to a more appropriate class of disks based on data access patterns without manual intervention.

Which HPE storage technology/feature will meet the customer requirement when the data is stored on an HPE Primera storage?

Nothing needs to be done since this is part of the OS

Activate SSD read cache on volume level

This is not supported

Enable Automated Tiering on the Storage Pool level

Show Answer Comment (0)

Total 80 questions

3 4 5 6 7 8

Go to page: of 8