Network Appliance NS0-175 Practice Test - Questions Answers, Page 5
Question list
List of questions
Related questions
Click the Exhibit button.
You are building a new FlexPod system booting from SAN.
Referring to the exhibit, how many paths will there be to the target LUN?
You are asked to design a new FlexPod solution that will host VMware virtual machines using NFS datastores, file services using SMB, and NFS-mounted home directories. You need to ensure that the network traffic of these three use cases are isolated?
In this scenario, which supported end-to-end network topology would be used to accomplish this task?
You received from a customer the requirements shown below.
-- 25 servers
-- 25GbE connectivity
-- NFS and iSCSI protocols
-- 30 TB flash storage
-- 50 TB hybrid storage
In this scenario, which FlexPod solution would satisfy the requirements?
A customer wants to upgrade their current VMware vSphere 6.5 environment to vSphere 7.x.
Where would you go to determine which Cisco UCS configurations support this goal?
A customer wants a low latency and high IOPS FlexPod solution and decides on an end-to-end NVMe design.
In this scenario, which three components are required to accomplish this task? (Choose three.)
A customer with a FlexPod solution wants to expand their NetApp ONTAP 9.7 switchless cluster. The new hardware must support expansion slots. In addition, they will also upgrade to a 100 Gbps-capable cluster interconnect switch for future growth.
In this scenario, which two additional components will satisfy the requirement? (Choose two.)
An administrator is designing a FlexPod solution with NetApp ONTAP 9.7 software with a logical separation of data for each department.
In this scenario, which two components must be part of the design? (Choose two.)
Your customer wants to change from local boot to SAN boot for the compute layer.
What must be present on the network layer to meet the customer's design change?
You want to ensure the uniqueness of the Cisco UCS WWNNs and WWPNs in the SAN for a FlexPod solution.
In this situation, Cisco recommends using which WWN prefix for all blocks in a pool?
A customer wants to replace their Cisco UCS 6248UP with the current Cisco UCS 6454. They are currently using six 16 Gbit uplinks per Fabric Interconnect for FC and do not want to change the speed and number of ports used.
In this scenario, what is the minimum number of unified ports that must be configured for FC for a comparable configuration?
Question