Cisco 010-151 Practice Test - Questions Answers, Page 5
Question list
List of questions
Related questions
What is the correct path to verify the Overall Status of Chassis 1 | Server 3?
Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 Status tab
Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
Equipment Tab > Chassis > Chassis 1 > Servers > Server 3 FSM tab
Servers Tab > Chassis > Server 3 General tab
Status Tab > Chassis > Chassis 1 > Servers > Server 3
Admin Tab > Chassis > Chassis 1 > Servers > Server 3 General tab
If the Overall Status for a Cisco UCS B-Series Blade Server indicates a failure in the Cisco UCS Manager, such as discovery-failed, which statement is true?
The server shuts down.
The server automatically reboots reboot in 3 minutes.
The endpoints on that server cannot be upgraded.
The server is online, but the administrator cannot assign a service profile to that blade.
Which action should the administrator take before physically removing a blade server for maintenance or replacement?
Force the server to shut down.
Disassociate the service profile.
Decommission the server.
Perform a graceful shutdown of the server.
Which three statements about powering down a Cisco UCS C-Series Rack-Mount Server to perform maintenance or replacement are true? (Choose three.)
Standby power mode: Power is supplied only to the service processor and the cooling fans, and it is safe to power off the server from this mode.
Power status LE
Green indicates that the server is in main power mode and can be safely powered off.
Graceful shutdown: Press and release the power button. The operating system performs a graceful shutdown, and the server goes to standby mode, which isindicated by an amber power status LED.
Disconnect the power cords from the power supplies in your server to completely power off the server.
Only an emergency shutdown can be performed using the power button on the server front panel.
The Cisco UCS C-Series Rack-Mount Server has only one power mode.
Which three components are hot swappable in a Cisco UCS Blade Server and Chassis? (Choose three.)
Fabric Extender
Power supply
Heat sink
SAS Hard Drive
2x8GB Kit DIMMs
Mezzanine card
Which five things should the administrator verify after performing maintenance or replacing a blade server? (Choose five.)
blade server status
hard drive status
host OS boot status
CPU status
mezzanine card status
memory DIMM status
fan and power status
Which two statements about DIMM replacement in Cisco UCS Servers are true? (Choose two.)
In blade servers, DIMMs can be installed in either 1, 2, 4, or 8 DIMMs per channel.
Rack-mount and blade servers have memory fault LEDs that indicate which DIMM requires attention.
In servers that require pairs of DIMMs, the pairs must be identical (manufacturer, size, part #, and so on).
If the memory in a server is not fully populated, you can install DIMMs in any open slot.
Which three tools are necessary to console into a Cisco UCS C-Series Rack-Mount Server? (Choose three.)
Cisco DB-9-to-RJ-45 console cable
laptop
monitor
keyboard
KVM dongle
USB serial adapter
After installation or replacement of a Cisco UCS C-Series Rack-Mount Server, the host does not boot.
Which four options should be verified? (Choose four.)
Verify the power source to the equipment.
Check for loose HDD cables.
Reseat the DIMMs, CPU, and PCI cards.
Verify that power supplies are receiving power.
Reseat the mezzanine card connector.
Check the CPU sockets for bent pins.
Check the Cisco IMC for fan faults.
Which three firmware components does the Host Upgrade Utility upgrade? (Choose three.)
Fabric Interconnect firmware
LAN on Motherboard
Cisco UCS Manager
CIMC
System BIOS
Question