F5 201 Practice Test - Questions Answers, Page 10

A BIG-IP Administrator notices that one of the servers that runs an application is NOT receiving any traffic. The BIG-IP Administrator examines the configuration status of the application and observes the displayed monitor configuration and affected Pool Member status. What is the possible cause of this issue?

A virtual server is configured to offload SSL from a pool of backend servers. When users connect to the virtual server, they successfully establish an SSL connection but no content is displayed. A packet trace performed on the server shows that the server receives and responds to the request. What should a BIG-IP Administrator do to resolve the problem?

A BIG-IP Administrator needs to collect HTTP status code and HTTP method for traffic flowing through a virtual server.

Which default profile provides this information?

DNS queries from two internal DNS servers are being load balanced to external DNS Servers via a Virtual

Server on a BIG-P device. The DNS queries originate from 192.168.101.100 and 192.168.101.200 and target 192.168.21.50

All DNS queries destined for the external DNS Servers fail

Which property change should the BIG-IP Administrator make in the Virtual Server to resolve this issue?

A 816-IP Administrator recently deployed an application Users are experiencing slow performance with the application on some remote networks.

Which two modifications can the BIG-IP Administrator make to address this issue? (Choose two)

Refer to the exhibit.

A BIG-IP Administrator needs to fall over the active device. The administrator logs into the Configuration

Unity and navigates to Device Management > Traffic Group. However, Force to Standby is greyed out

What is causing this issue?

A BIG-IP Administrator is working with a BIG-IP device and discovers that one of the Interfaces on a

Trunk is DOWN.

What is the reason for this Interface status?

A BIG-IP Administrator creates a new VLAN on BIG-IP Cluster Member A and attaches an Interface to it. Although the Auto Config Sync is in place, the new VLAN does NOT show up on Cluster Member B. What should the BIG-IP Administrator do to ensure the new VLAN is configured on each Cluster Member?

A BIG-IP Administrator must determine if a Virtual Address is configured to fail over to the standby member of a device group in which area of the Configuration Utility can this be confirmed?