ExamGecko
Login
Home / Cisco / 300-430 / List of questions
Ask Question

Cisco 300-430 Practice Test - Questions Answers, Page 4

List of questions

Question 31

Report Export Collapse

Refer to the exhibit. Which two items must be supported on the VoWLAN phones to take full advantage of this WLAN configuration? (Choose two.)

Cisco 300-430 image Question 31 112364 10072024005858000000

TSPEC

TSPEC

SIFS

SIFS

802.11e

802.11e

WMM

WMM

APSD

APSD

Suggested answer: C, D
asked 07/10/2024
Kumar, Manivannan
28 questions

Question 32

Report Export Collapse

An engineer must use Cisco AVC on a Cisco WLC to prioritize Cisco IP cameras that use the wireless network. Which element do you configure in a rule?

permit-ACL

permit-ACL

WMM required

WMM required

mark

mark

rate-limit

rate-limit

Suggested answer: C
asked 07/10/2024
Yuri Shpovlov
44 questions

Question 33

Report Export Collapse

An IT administrator is managing a wireless network in which most devices are Apple iOS. A QoS issue must be addressed on the WLANs. Which configuration must be performed?

Enable Fastlane globally under Wireless > Access Points > Global Configuration.

Enable Fastlane globally under Wireless > Access Points > Global Configuration.

Create a new AVC Profile named AUTOQOS-AVC-PROFILE and apply to all WLANs.

Create a new AVC Profile named AUTOQOS-AVC-PROFILE and apply to all WLANs.

Enable Fastlane under each WLAN setting.

Enable Fastlane under each WLAN setting.

Enable WMM TSPEC/TCLAS negotiation under Wireless > Advanced.

Enable WMM TSPEC/TCLAS negotiation under Wireless > Advanced.

Suggested answer: C
Explanation:

Reference: https://www.cisco.com/c/dam/en/us/td/docs/wireless/controller/technotes/8-3/Optimizing_WiFi_Connectivity_and_Prioritizing_Business_Apps.pdf

asked 07/10/2024
Victor Cantu
40 questions

Question 34

Report Export Collapse

What is the Cisco recommended configuration for a Cisco switch port connected to an AP in local mode for optimal voice over WLAN performance with an 8821 wireless phone?

switchport encapsulation dot1q switchport mode trunk mls qos trust device cisco-phone

switchport encapsulation dot1q switchport mode trunk mls qos trust device cisco-phone

switchport mode access mls qos trust device cisco-phone

switchport mode access mls qos trust device cisco-phone

switchport mode access mls qos trust cos

switchport mode access mls qos trust cos

switchport mode access mls qos trust dscp

switchport mode access mls qos trust dscp

Suggested answer: C
Explanation:

Reference:

https://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/cuipph/8821/english/Deployment/8821_wlandg.pdf

asked 07/10/2024
ftere yagoglu
49 questions

Question 35

Report Export Collapse

An engineer has configured Media Stream on the WLC and must guarantee at least 2 Mbps stream per user. Which RRC template should the engineer use?

coarse

coarse

medium

medium

low

low

ordinary

ordinary

Suggested answer: B
Explanation:

Reference: https://www.cisco.com/c/en/us/td/docs/wireless/controller/7-4/configuration/guides/consolidated/b_cg74_CONSOLIDATED/b_cg74_CONSOLIDATED_chapter_0101010.html

asked 07/10/2024
Rudrappa Sarvi
40 questions

Question 36

Report Export Collapse

Refer to the exhibit.

Cisco 300-430 image Question 36 112369 10072024005858000000

Which COS to DSCP map must be modified to ensure that voice traffic is tagged correctly as it traverses the network?

COS of 6 to DSCP 46

COS of 6 to DSCP 46

COS of 3 to DSCP 26

COS of 3 to DSCP 26

COS of 7 to DSCP 48

COS of 7 to DSCP 48

COS of 5 to DSCP 46

COS of 5 to DSCP 46

Suggested answer: D
asked 07/10/2024
Yan Wei
40 questions

Question 37

Report Export Collapse

Which QoS level is recommended for guest services?

gold

gold

bronze

bronze

platinum

platinum

silver

silver

Suggested answer: B
asked 07/10/2024
MYKEL PERRY
43 questions

Question 38

Report Export Collapse

An engineer wants to configure WebEx to adjust the precedence and override the QoS profile on the WLAN. Which configuration is needed to complete this task?

Change the WLAN reserved bandwidth for WebEx

Change the WLAN reserved bandwidth for WebEx

Create an AVC profile for WebEx

Create an AVC profile for WebEx

Create an ACL for WebEx

Create an ACL for WebEx

Change the AVC application WebEx-app-sharing to mark

Change the AVC application WebEx-app-sharing to mark

Suggested answer: B
asked 07/10/2024
Michael Weaver
24 questions

Question 39

Report Export Collapse

All APs are receiving multicast traffic, instead of only the APs that need it. What is the cause of this problem?

The multicast group includes all APs

The multicast group includes all APs

The wrong multicast address was used

The wrong multicast address was used

The multicast group is assigned the wrong VLAN

The multicast group is assigned the wrong VLAN

Multicast IGMP snooping is not enabled

Multicast IGMP snooping is not enabled

Suggested answer: D
asked 07/10/2024
Vahit Erciyas
46 questions

Question 40

Report Export Collapse

What is the difference between PIM sparse mode and PIM dense mode?

Sparse mode supports only one switch. Dense mode supports multiswitch networks.

Sparse mode supports only one switch. Dense mode supports multiswitch networks.

Sparse mode floods. Dense mode uses distribution trees.

Sparse mode floods. Dense mode uses distribution trees.

Sparse mode uses distribution trees. Dense mode floods.

Sparse mode uses distribution trees. Dense mode floods.

Sparse mode supports multiswitch networks. Dense mode supports only one switch.

Sparse mode supports multiswitch networks. Dense mode supports only one switch.

Suggested answer: C
asked 07/10/2024
Kareem Dadoul
50 questions
Total 216 questions
Go to page: of 22
Open VPLUS File
Convert VPLUS to PDF

Related questions

An engineer must implement rogue containment for an SSID. What is the maximum number of APs that should be used for containment?
A wireless engineer must implement a corporate wireless network for a large company in the most efficient way possible. The wireless network must support 32 VLANs for 300 employees in different departments. Which solution must the engineer choose?
A Cisco CMX 3375 appliance on the 10.6.1 version code counts duplicate client entries, which creates wrong location analytics. The issue is primarily from iOS clients with the private MAC address feature enabled. Enabling this feature requires an upgrade of the Cisco CMX 3375 appliance in a high availability pair to version 10.6.3. SCP transfers the Cisco CMX image, but the upgrade script run fails. Which configuration change resolves this issue?
After receiving an alert about a rogue AP, a network engineer logs into Cisco Prime Infrastructure and looks at the floor map where the AP that detected the rogue is located. The map is synchronized with a mobility services engine that determines that the rogue device is actually inside the campus. The engineer determines that the rogue is a security threat and decides to stop if from broadcasting inside the enterprise wireless network. What is the fastest way to disable the rogue?
An engineer must implement a BYOD policy with these requirements: Onboarding unknown machines Easily scalable Low overhead on the wireless network Which method satisfies these requirements?
An engineer has configured passive fallback mode for RADIUS with default timer settings. What will occur when the primary RADIUS fails then recovers?
Refer to the exhibit. An engineer implemented the CPU ACL on your Cisco 5520 Series Wireless LAN Controller, and the controller is no longer manageable via the network. What must be changes on this CPU ACL to enable it to manage the controller again?
Refer to the exhibit. A network architect configured the Cisco Catalyst 9800 Series Controller to find out information on client types in the wireless network. RADIUS profiling is enabled so that the controller forwards the information about clients to a Cisco ISE server through vendor-specific RADIUS attributes. The ISE server is not profiling any data from the controller. Which configuration must be added in the blank in the code to accomplish the profiling on the Cisco 9800 Series controller?
An engineer is troubleshooting a Cisco CMX high-availability deployment and notices that the primary and backup Cisco CMX servers are both considered primary. Which command must the engineer run on the backup server?
A network engineer needs to configure multicast in the network. The implementation will use multiple multicast groups and PIM routers. Which address provides automatic discovery of the best RP for each multicast group?