A customer deploys 32 virtualization hosts in a Cisco UCS domain. All hosts run in the same cluster and have Identical hardware specifications. The operating system requires that all firmware is consistent across the hosts (or driver support. The customer must provision additional interfaces later for expandability. Which feature of Cisco UCS Manager meets these requirements?

Updating Service Profile Template

Initial Service Profile Template

Updating Service Profile Template

Refer to the exhibit. The data center DC1 uses VXLAN technology The company asked a service provider to design another data center called DC2 and stretch EVPN information between the data centers based on the same technology The fabric requires• endpoint information propagated end-to-end across both data centers• misconfiguration replicated from DC1 to DC2Which actions must the design include in DC2 to meet these criteria?

• Set BGP AS to 65500• Configure RIP as an underlay IGP

• Set BGP AS to 65501• Configure EIGRP as an underlay IGP

• Set BGP AS to 65501• Configure RIP as an underlay IGP

• Set BGP AS to 65500• Configure IGRP as an underlay IGP

A customer is implementing a business continuity solution for the current data centers The new location must mitigate the impact of a disaster in any existing data centers by providing an acceptable level of service The solution must support• fully segregated Layer 2 and 3 fault domains• low or no human intervention for service restoration• medium to high RPCVRTO for a subset of applications• asynchronous storage replication for application dataWhich disaster recovery solution must the customer select to meet these requirements?

identical infrastructure facility ready to provide service

mirrored inactive infrastructure facility with fully stretched resources

cold infrastructure facility with basic infrastructure

partially equipped infrastructure faculty for on-demand activation

A customer must deploy a new Cisco HyperFlex stretched cluster solution to ensure virtual server availability in case the data center fails. The current network environment provides multiple geographic locations. Which action must be taken to meet these objectives?

Deploy the stretch duster sites to be within the distance of 300 miles apart

Implement the round trip time latency between the sites to be lower than 20 ms

Place an independent witness component at a third site

Deploy the stretch duster sites to be within the distance of 300 miles apart

Configure the cluster with the maximum data replication factor

Refer to the exhibit. A system administrator needs a solution to manage random packet drops between two Cisco UCS C240 M4 serversThe servers are connected to a pair of Cisco Nexus 7009 switches using 10G fibre interfacesBoth servers are generating too many east-west traffic flows from TCP-based applications which causes significant latency that impacts the customerAlso the transfer of files from Server-1 to Server-2 larger than 10 GB results in multiple retransmitsWhich design solution resolves this issue?

Connect both servers m the same VLAN

Add a second uplink to each server NIC

Increase the amount of memory m both servers

Apply rate-limit on the server 1 VLAN interface per application flow.

Connect both servers m the same VLAN

An engineer is configuring a Cisco UCS Service Profile template for an environment that will host Windows servers Some of the servers require access to a Fibre Channel storage network The design requires the server HBA to send the maximum number of commands to a Fibre Channel disk using a single transmission Which action must be taken to meet these requirements?

Decrease Link Down Timeout to 20.000

Increase Max Data Field Size to 2096

Refer to the exhibit. The security team created a new security policy that requires certain types of traffic to be subject to deep packet inspection The traffic types are• internet traffic to application servers• internet traffic to corporate users• partner network traffic to application servers• partner network traffic to corporate usersWhere must the next-generation firewalls be inserted to implement the new policy?

one-armed insertion from the ACl border leaf duster

one-armed insertion from the core switch cluster

inline insertion between the edge router duster and the core switch cluster

one-armed insertion from the ACl border leaf duster

inline insertion between the user network switch cluster and the core cluster

An engineer must design a solution to divide the workload across two different data centers and achieve redundancy in case of the failure of either data center Which solution must the engineer choose?

single Cisco HyperFlex stretched cluster

single Cisco HyperFlex standard cluster

Refer to the exhibit. A customer runs an Online Transaction Processing (OLTP) application on Server1. The application generates a small number of transactions and requires low storage latency. Server2 is a backup server that performs backups twice a dayDuring the backup window, the OLTP application experiences high-latency spikes that affect the application performance The customer must meet these requirements• Maintain consistent low I/O latency for the OLTP server.• Guarantee I/O throughput for the OLTP server during backup time• Allow the customer to keep the existing hardware.Which action must be taken to meet these requirements?

Configure QoS and scheduler for data traffic on both Fibre Channel switches

Apply a traffic shaper to the FC Switch 1 interface that is facing the server

Create a SAN port channel between FC Switch! and FC Switch2.

Add another 8G link to the Serverl and create F-Port-channel

Configure QoS and scheduler for data traffic on both Fibre Channel switches

An engineer working for a private telecommunication company with an employee ID 4419 90 979 is installing a pair of Nexus 7000 Series Switches and must deploy the solution with these requirements• The environment must be separated for test and production purposes• The separation should include control, data and management plane with fault domain isolation and improved security• The test environment needs only F2 series line cards and a maximum of 256 VLANsWhich set of actions meets these requirements?A. Use VRF faQUMIife environmentsConfigure allow feature set for both VRFsEnable limit-resource vlan minimum for the test VRF

Use VDC for each of the environmentsConfigure allow feature set for both VRFsEnable limit-resource vlan maximum for the test VRF

Use VDC for each of the environmentsConfigure limit-resource module-type functionality for the test VDCEnable limit resource vlan for the test VDC.

Use VDC for each of the environmentsConfigure allow feature set for both VRFsEnable limit-resource vlan maximum for the test VRF

Use VRF for each of the environmentsConfigure limit-resource module-type functionality for the test VDC.Enable module-type for the VRF

A network architect needs secure access to the organization’s perimeter routers and firewalls. The administrator must access network devices from a remote location that is reachable from the WAN cloud Which action meets these requirements?

Create an out-of-band network management network

Create a secure IPsec tunnel interface using an internet link for device management purposes

Enable the SSH protocol with a strong username and password using an internet link for management purposes

Create an out-of-band network management network

Create an in-band network management network

An engineer must design a Cisco UCS environment for a customer The design requires the most efficient use of available bandwidth with active-active uplinks The upstream Cisco Nexus 9000 Series Switch must automatically initiate the port-channel connectivity to the fabric interconnects Which configuration must the engineer choose to meet these requirements?

• fabric interconnects in Ethernet end-host mode • LACP port-channel from fabric interconnects and Cisco Nexus 9000 switches

• fabric interconnects in Ethernet switching mode • LACP port-channel from fabric interconnects and Cisco Nexus 9000 switches

• fabric interconnects in Ethernet switching mode • static port-channel from fabric interconnects and Cisco Nexus 9000 switches

• fabric interconnects in Ethernet end-host mode • LACP port-channel from fabric interconnects and Cisco Nexus 9000 switches

• fabric interconnects in Ethernet end-host mode • static port-channel from fabric interconnects and Cisco Nexus 9000 switches

Refer to the exhibit. A Cisco engineer is configuring a customer scenario with 2 x MDS 9000 switches 24 x UCS B200M6 blade servers. UCS 64S4 Fabric Interconnect in end-host mode and 3 x UCS 5108 server chassis with 2408 Fabric Extenders The engineer installs 6 x SQL Server 2019 on all blades and then notices that there are read and write latencies What is the best way to balance the utilization across the shared ports?

Disable restrictions on oversubscription ratios

Enable "Only dedicate rate mode

Change the assigned speed to 8 Gbps Auto.

Disable restrictions on oversubscription ratios

A company plans to implement high availability between the iSCSI host and the Fibre Channel target. Which solution must the company implement to recover from a failure of a host NIC. MDS IP storage port or Fibre Channel target port?

Map the Fibre Channel target ports to one IP storage port

Implement HSRPofi thf MDS IP storage ports

Set up IP storage ports to export the two Fibre Channel target ports

Map the Fibre Channel target ports to one IP storage port

Configure FCoE between the host NICs and MDS ports

Refer to the exhibit In this scenario a Cisco engineer is building a loop-free topology where a dedicated layer of the vPC domain adjacent to the aggregation layer which also runs vPC Is used to interconnect the two data centers together. The engineer globally configures a vPC domain identifier on both vPC devices where the domain ID is the same on both peer devices. Which action successfully forms the domain?

Configure vPC-peer-keepalive link on both peer devices

Put peer device interfaces into a suspended state.

Enable and reuse an ISL Layer 3 trunk port channel

Synchronize the MAC addresses for the member ports

Refer to the exhibitA Cisco engineer is configuring a next-generation Cisco HyperFlex HX data platform with 2 x Cisco UCS 6248UP fabric interconnects. 8 x Cisco HX-Series HX240c-M4SX servers, plus 8 x Cisco UCS B200-M4 blade servers Cisco UCS5108 blade chassis, and Cisco UCS 2204XP fabric extenders The solution is configured with HX Release 4 5(2a) using VMware ESXi 7 0 U2 After the engineer migrates all customer VMs to the new solution platform, the engineer decides to create HX Native snapshots for all the VMs The engineer performs the operation and notices that some of the VMs are not creating snapshots. What is the most probable reason that the HX Native snapshots are not created?

The source disk is thick provisioned

Virtual machines are in suspended state

The servers have duplicate names

The source disk is thick provisioned

The node has insufficient datastore space

A Cisco engineer is configuring MPLS VPN BGP at a customer site that is connected to the provider site by more than one path MPLS VPN BGP Local Convergence link protection is enabled. After the engineer installs the main forwarding path and the redundant backup path within the BGP, they assign a unique route distinguisher to each VRF table on all PE devices that serve as a backup to the link. What is a prerequisite for this local convergence to work?

The system is performing a PE-CE link protection on both ends

Interautonomous system option A (back-to-back VRF) is active.

BGP must support lossless switchover between operational paths

The system is performing a PE-CE link protection on both ends

Cisco 300-610 Practice Test 5 - Free Online Exam Prep & Questions

A SAN fabric is built between a pair of Cisco MDS 9000 Series Switches. The requirement is for the ISL to use the VSAN ID to toward traffic from multiple VSANs across the same physical link. Additionally, the Fibre Channel trace feature must be supported. Which ISL interface parameters are required to meet these requirements?

Cisco 300-610 image Question 161 113145 10072024010008000000

Become a Premium Member for full access

Unlock Premium Member

Cisco 300-610 Practice Test 5

Question

Cisco 300-610 Practice Tests

Practice Tests