How is bandwidth allocated to traffic flows in a flow-based WFQ solution?

Voice has priority and the other types of traffic share the remaining bandwidth.

All the bandwidth is divided based on the QoS marking of the packets.

Each type of traffic flow has equal bandwidth.

Bandwidth is divided among traffic flows. Voice has priority.

Voice has priority and the other types of traffic share the remaining bandwidth.

An administrator must configure the Local Route Group feature on Cisco UCM. Which step will enable this feature?

For each device pool, configure a route group to use as a Local Route Group for that device pool

For each route group, check the box for the Local Route Group feature.

For each route pattern, select the Local Route Group as the destination.

For each device pool, configure a route group to use as a Local Route Group for that device pool

For each route list, configure a route group to use as a Local Route Group.

Which call flow matches traffic from a Mobile and Remote Access registered endpoint to central call control?

Endpoint>Expressway-C>Expressway-E>Cisco UCM

Endpoint>Expressway-E>Expressway-C> Cisco UCM

Endpoint>Expressway-E> Cisco UCM

Endpoint>Expressway-C> Cisco UCM

An administrator installs a new Cisco TelePresence video endpoint and receives this error:"AOR is not permitted by Allow/Deny list. Which action should be taken to resolve this problem?

Correct the restriction policy settings.

Reboot the VCS server and attempt reregistration.

Change the SIP trunk configuration.

Correct the restriction policy settings.

Refer to the exhibit. A call is falling to establish between two SIP Devices The called device answers with these SOP WhichSOP parameter causes issue?

The calling device did not offer a ptime value

The media stream is set to send only

The payload for G.711ulaw must be 18.

An administrator is asked to implement toll fraud prevention in Cisco UCM, specifically to restrict offnet to off-net call transfers. How is this implemented?

Set the appropriate service parameter.

Enforce ad-hoc conference restrictions.

Set the appropriate service parameter.

What is required when deploying co-resident VMs by using Cisco UCM?

Avoid hardware oversubscription.

Provide a guaranteed bandwidth of 10 Mbps.

Deploy the VMs to a server running Cisco UCM.

Avoid hardware oversubscription.

Ensure that applications will perform QoS.

An engineer with ID012345678 must build an international dial plan in Cisco UCM. Which action is taken when building a variable-length route pattern?

create a second route pattern followed by the # wildcard

configure single route pattern for international calls

set up all international route patterns to 0.!

reduce the T302 timer to less than 4 seconds

create a second route pattern followed by the # wildcard

What is the major difference between the two possible Cisco lM and Presence high-availability modes?

Balanced mode provides user load balancing and user failover in the event of an outage.Active/standby mode provides an always on standbynode in the event of an outage, but it does not provide load balancing.

Balanced mode provides user load balancing and user failover in the event of an outage.Active/standby mode provides an always on standbynode in the event of an outage, and it also provides load balancing.

Balanced mode provides user load balancing and user failover only for manually generated failovers. Active/standby mode provides anunconfigured standby node in the event of an outage, but it does not provide load balancing.

Balanced mode provides user load balancing and user failover in the event of an outage.Active/standby mode provides an always on standbynode in the event of an outage, but it does not provide load balancing.

Balanced mode does not provide user load balancing, but it provides user failover in the event of an outage. Active/standby mode provides analways on standby node in the event of an outage, but it does not provide load balancing.