An administrator is in the process of moving cisco unity connection mailboxes between mailbox stores the administrator notices that some mailboxes have active message waiting indicators what happens to these mailboxes when they are moved?

The MWI status is retained after a mailbox is moved from one store to another.

The move will fall If MWI status Is active.

Moving the mailboxes from one store to another falls If MWI Is turned on.

If source and target mailbox store are not disabled. MWI status is not retained.

The MWI status is retained after a mailbox is moved from one store to another.

Which service must be enabled when LDAP on cisco UCM is used?

Cisco Bulk provisioning Service

An end user at a remote site is trying to initiate an Ad Hoc conference call to an end user at the main site. The conference receives an error message on the phone: Cannot complete conference call.What is the cause of the issue?

The transcoder resource is missing.

The remote phone does not have the conference feature assigned

A software conference bridge is not assigned.

A Media Termination Point is missing.

During the Cisco IP Phone registration process the TFTP download fails. What are two reasons for this issue? (Choose two)

The Cisco IP Phone does not know the IP address of the TFTP server

Option 150 string was not specified, or an incorrect Option 150 string was specified

The DNS server was not specified, which is needed to resolve a hostname in an Option 150 string.

The Cisco IP Phone does not know the IP address of the TFTP server

The Cisco IP Phone does not know the IP address of any of the Cisco UCM Subscriber nodes

Option 100 string was not specified, or an incorrect Option 100 string was specified

Option 150 string was not specified, or an incorrect Option 150 string was specified

An administrator is integrating a Cisco Unity Express module to a Cisco UCME system A test call is placed to the Cisco Unity Express pilot number, but the administrator receives a busy signal. The dialpeer is configured as follows:dial-peer voice 4100 voipdestination-pattern 41..session protocol sipv2session target ipv4:10.1.10.1dtmf-relay sip-notify no vadHow is this issue resolved?

The dial-peer needs to be reconfigured to support the G.711 voice codec.

The dial-peer needs to be reconfigured to support vad.

The destination pattern needs to be changed to match the dialed number of 4100.

The dial-peer needs to be reconfigured to support H 323 instead of SIP.

How does traffic policing respond to violations?

Excess traffic is retransmitted.

Refer to the exhibit. An engineer is confining class of control for a user in Cisco UCM. Which change will ensure that the user is unable to call 2143?

Set the users device CSS to <None>

Change line partition to Partition_A

Change line CSS to only contain Partition_B

Set the user's line CSS to <None>

Set the users device CSS to <None>

An administrator is asked to implement toll fraud prevention in Cisco UCM, specifically to restrict offnet to off-net call transfers How is this implemented?

Set the appropriate service parameter

Enforce ad-hoc conference restrictions

An administrator installed a Cisco Unified IP 8831 Conference Phone that is failing to register Which two actions are taken to troubleshoot the problem? (Choose two)

Verify that the switch port of the phone is enabled

Verify that the phone's network can access the option 150 server.

Disable HSRP on lhe access layer switch.

Verify that the switch port of the phone is enabled

Verify that the RJ-11 cable is plugged into the PC port.

Verify that the phone's network can access the option 150 server.

An administrator has been asked to implement toll fraud prevention in Cisco UCM Which tool is used to begin this process?

Cisco UCM Access Control Group restrictions

Cisco Unified Real-Time Monitoring Tool

What is the most efficient way to configure a speed dial to number 1111 on multiple phones using the Self-Provisioning feature in Cisco UCM?

Configure a universal device template that has speed dials in the phone button configuration field, then specify 1111 as a speed dial by editing the speed dial within the universal device template.

Configure each phone with the same DN and then configure a speed dial of 1111 on one of the phones manually by navigating to Devices>Phones and modifying the phone. This will automatically replicate to all the other phones.

Configure the phones with a phone button template that has speed dials then specify 1111 as a speed dial via BAT>Phones>Add/Update phones web page to specify the speed dial number after the phone is in Cisco UCM.

Configure a universal device template that has speed dials in the phone button configuration field, then allow the user to specify 1111 as a speed dial via the Cisco Unified Communications Self Care Portal.

Configure a universal device template that has speed dials in the phone button configuration field, then specify 1111 as a speed dial by editing the speed dial within the universal device template.

What is required for Cisco UCM to accept SIP calls with a URI in the format of "sip 2001@cucmpub.cisco.com"?

Define Cluster Fully Qualified Domain Name in Enterprise Parameters.

Define Cluster Fully Qualified Domain Name under Servers in Cisco UCM.

Change the Destination Address to a Fully Qualified Domain Name on the SIP trunk.

Set the SIPS URI Handling to True in CallManager Service Parameters.

Define Cluster Fully Qualified Domain Name in Enterprise Parameters.

Configuration of DNS is required to achieve a fully functional Cisco UCM system Cisco UCM uses DNS to resolve fully qualified domain names to IP addresses for which destinations?

Primary TFTP Server for option 150

Cisco Unified Communications Manager Name

Which feature is enabled by Cisco Mobile and Remote Access?

Clients such as Cisco Jabber can use call control on Cisco UCM.

Internal SIP clients registered to Cisco UCM can call external companies.

Clients such as Cisco Jabber can use call control on Cisco UCM.

VPN connectivity can be established to Cisco UCM.

Cisco UCC Express clients can obtain VPN connectivity to Cisco UCC Enterprise.

What is required when deploying co-resident VMs by using Cisco UCM?

Avoid hardware oversubscription.

Provide a guaranteed bandwidth of 10 Mbps.

Ensure that applications will perform QoS.

Avoid hardware oversubscription.

Deploy the VMs to a server running Cisco UCM.

A customer asked to integrate Unity Connection with Cisco UCM using SIP protocol Which two features must be enabled on SIP security profiles? (Choose two)

Accept unsolicited notification

Enable application level authorization.

Accept unsolicited notification

Refer to the exhibit A user takes a phone from San Francisco to New York for a short reassignment.The phone was set up to use the San Francisco device pool, and device mobility is enabled on the Cisco UCM. The user makes a call that matches a route pattern in a route list that contains the Standard Local Route Group. To where does the call retreat?

The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco

The call egresses in New York because the device automatically is assigned a New York device pool and uses the local gateway

The call egresses in San Francisco because the user uses device mobility and is allowed to roam while still keeping the number and resources assigned in San Francisco

The call fails because the Standard Local Route Group is being used only if no configuration is set for the device pools

The call fails because device mobility is turned on. and the phone is not configured in New York The engineer must configure which sites the device should be roaming to

A user reports that when receiving an inbound call on their IP Phone from the PSTN they are unable to transfer this call to another PSTN number What is the reason for this failure?

The service parameter related to Öffnet to Offnet Call Transfer is set to TRUE

The incoming calling search space of the SIP trunk does not include the partition of the line in the IP phone

The gateway is configured with the wrong device pool

The service parameter related to Öffnet to Offnet Call Transfer is set to TRUE

The IP phone is configured with the wrong region

An administrator is designing a new Cisco UCM for a company with many departments and firm structure on their communications policies. The administrator must make sure that these communication policies are reflected in the phone system setup. Certain departments cannot be accessed directly, even if they have dedicated DID numbers. Some phones, especially public phones, must not be able to dial international numbers Which type of function is configured to control which device is allowed to call another device in Cisco UCM?

partitions and calling search spaces

calling patterns and route patterns

What are two functions of Cisco Expressway in the Collaboration Edge? (Choose two)

The Expressway-C and Expressway-E pair can interconnect H 323-to-SIP calls for voice.

Expressway-E provides a perimeter network that separates the enterprise network from the Internet.

Expressway-E provides a VPN entry point for Cisco IP phones with a Cisco AnyConnect client using authentication based on certificates.

Expressway-C provides encryption for Mobile and Remote Access but not for business-to-business communications.

The Expressway-C and Expressway-E pair can interconnect H 323-to-SIP calls for voice.

The Expressway-C and Expressway-E pair can enable connectivity from the corporate network to the PSTN via a T1/E1 trunk.

Expressway-E provides a perimeter network that separates the enterprise network from the Internet.

An employee of company ABC just quit. The IT administrator deleted the employee's userid from the active directory at 10 a m. on March 4th The nightly sync occurs at 10 p.m daily. The IT administrator wants to troubleshoot and find a way to delete the userid as soon as possible How is this issue resolved?

Wait until 3:15 a.m. on March 6th for garbage collection to remove the user from Cisco UCM.

Wait until 10 pm on March 4th when the user is automatically removed from Cisco UCM

Wait until 10 pm on March 5th when the user is automatically removed from Cisco UCM.

Wait until 3:15 a.m. on March 6th for garbage collection to remove the user from Cisco UCM.

Wait until 3:15 a.m. on March 5th for garbage collection to remove the user from Cisco UCM

An administrator is configuring LDAP for Cisco UCM with Active Directory integration. A customer has requested to use 'ipphone' instead of 'telephoneNumber ' as the phone number attribute. Where does the administrator specify this attribute mapping in Cisco UCM?

LDAP directory custom user fields

Cisco 350-801 Practice Test 5 - Free Online Exam Questions 161-200

An end used at a remote site is trying initiate an ad hoc conference call to an end user at the main site the conference bridge is configured to support G.711 remote user phone only support G.729 the remote end user receives an error message on the phone "cannot complete conference call what is the cause of the issue?

Become a Premium Member for full access

Unlock Premium Member

Cisco 350-801 Practice Test 5

Question

Cisco 350-801 Practice Tests

Practice Tests