HP HPE0-V14 Practice Test - Questions Answers, Page 8

List of questions
Question 71

Which HPE remote management tool offers simplified warranty and contract case management?
Question 72

Which series of internal checks will an HPE ProLiant server use to validate that the base hardware components are working correctly before booting the operating system?
Question 73

A customer needs to move from their traditional tape-based backup infrastructure to a standalone application to disk based backup solution using HPE StoreOnce. The environment does not use a hypervisor.
The customer has the following goals for their long-term backup retention: retain data for over two years at low cost data is archival and rarely accessed, if ever Which HPE StoreOnce components can help meet the customer goals in the most cost effective manner? (Choose three.)
Question 74

Which disk technology provides the lowest latency for performing random reads?
Question 75

What does the term composable mean when applied to HPE infrastructure?
Question 76

When configuring a single ProLiant Gen10 server, which embedded tool can be used to deploy a reliable and consistent configuration?
Question 77

Read the question, and then refer to the exhibit.
<Switch-A>display int Ten-GigabitEthernet 1/0/1 Ten-GigabitEthernet1/0/1 Current state: UP Line protocol state: UP IP packet frame type: Ethernet II, hardware address: d894-03fb-793d Description:
Ten-GigabitEthernet1/0/1 Interface Bandwidth: 10000000 kbps Loopback is not set Media type is stack wire, port hardware type is STACK SFP_PLUS 10Gbps-speed mode, full-duplex mode Link speed type is autonegotiation, link duplex type is autonegotiation Flow-control is not enabled Maximum frame length: 10000 Allow jumbo frames to pass Broadcast max-ratio: 100% Multicast max-ratio:
100% Unicast max-ratio: 100% PVID: 1 MDI type: Automdix Port link-type: Trunk VLAN Passing: 10 VLAN permitted: 10 Trunk port encapsulation: IEEE 802.1q Port priority: 0 <SNIP> An administrator connected a hypervisor to interface Ten-Gigabit Ethernet1/0/1 in a switch. The administrator created virtual machines in VLAN 10 and 20 on the hypervisor. These VLANs are configured to be tagged on the hypervisor.
The administrator found that all the virtual machines within VLAN 20 can communicate with each other, but not to any resource on VLAN 20 outside the hypervisor.
What must you do to resolve this issue?
Question 78

You are reviewing a series of MSA2052 storage designs for a customer's remote locations. Their largest remote site requires the highest possible level of internal data protection with at least 20 TB of storage. Which disk drive design is adequate for this site?
Question 79

What is the correct cable type to use when connecting a server to a switch using 10 Gbps Short Range (SR) SFP+ optical connections?
Question 80

A customer needs a server memory subsystem that meets the following requirements: approaches the speed of traditional DRAM ensures high capacity, high performance, and ongoing data safety in case of a power failure Which HPE memory feature meets the customer needs?
Question