Which two commands could be used if the cf giveback command foils? (Choose 2)

If an error message indicates that the cluster interconnect adapter itself is faulty, what is your corrective action?

To remove a cluster setup, you must perform the following steps.

1. Type cf disable.

2. Unlicense cluster.

3. Remove partner entries for network interfaces from the /etc/rc file.

4. Halt and make sine the partner-sysid is blank.

5. Power down and remove the cluster interconnect card.

6. Perform steps 1-5 above on the partner node.

You are troubleshooting a clustered failover problem at a customer site. The customer explains that both storage appliances were NFS mounted onto the Solaris host. You attempt to create a file on the NFS mount point for the inaccessible appliance, but you get the following error:NFS server filer2 not responding still trying.Symptoms:

1) When not in takeover mode, both storage appliances operate normally.

2) In takeover mode, the taken over node is not accessible on the network.You perform a 'cf giveback' and you can now create a file over NFS on both appliances.

What should vou do first to resolve this issue?

One method of configuring an interface for takeover is to enter ifconfig interface partner address at the command line. To make tins configuration persistent across reboots, you must enter tins information in the_____file for each appliance.

For aggregates or traditional volume SyncMirror to work correctly, the configuration of each plex must be identical with regard to____________.

Which one of the following commands would you use to create a new SyncMirror volume, lettina Data ONTAP select the disk drives?

Which one of the following SyncMirror commands would you use to mirror an existing unmirrored volume where Data ONTAP selects the disk drives?

While troubleshooting a double disk failure with SyncMirror. You decide to remove and destroy a plex from a mirrored volume. What steps would you perform to remove a plex from a mirrored volume?