ExamGecko
Home Home / Cisco / 300-815

Cisco 300-815 Practice Test - Questions Answers, Page 13

Question list
Search
Search

List of questions

Search

Related questions











An administrator is working on an issue between the customer s Cisco Unified Border Element and the service provider. The provider only wants to see mid-call signaling from the Cisco Unified Border Element for fax calls. Which command must be configured on Cisco Unified Border Element?

A.

midcall-signallng passthru

A.

midcall-signallng passthru

Answers
B.

midcall-signaling preserve-codec

B.

midcall-signaling preserve-codec

Answers
C.

no update-callerid

C.

no update-callerid

Answers
D.

midcall-signaling passthru media-change

D.

midcall-signaling passthru media-change

Answers
Suggested answer: D

An engineer is troubleshooting local ringback on a Cisco SIP gateway The gateway is not ignoring the SIP 180 response with SDP from the service provider, and the far end device is sending the 180 with SDP to play ringback from the IP address specified m the SDP Which configuration change must be made on the gateway to resolve the issue?

A.

Router(conf-voi-serv)# dlisable-early-media 180

A.

Router(conf-voi-serv)# dlisable-early-media 180

Answers
B.

Router(conftg-sip-ua)# disable-early-media 180

B.

Router(conftg-sip-ua)# disable-early-media 180

Answers
C.

Router(con(-voi-serv)# no disable-early-media 180

C.

Router(con(-voi-serv)# no disable-early-media 180

Answers
D.

Router(config-sip-ua)# no disable-early-media 180

D.

Router(config-sip-ua)# no disable-early-media 180

Answers
Suggested answer: B

An engineer has temporarily disabled toll fraud prevention for SIP line calls on a Cisco CME12.6x and must enforce security and toll fraud prevention for the SIP line side on Cisco Unified CME. Which configuration must be used to start this process?

A.

voice service volp Ip address trusted list

A.

voice service volp Ip address trusted list

Answers
B.

voice service volp enablo ip address trust authentication

B.

voice service volp enablo ip address trust authentication

Answers
C.

voice service volp enable Ip address trust list

C.

voice service volp enable Ip address trust list

Answers
D.

voice service volp ip address trusted authenticate

D.

voice service volp ip address trusted authenticate

Answers
Suggested answer: D

A company has users that are logged in to hunt groups. However, there is a requirement for hunt group configurations to provide an option to turn on audible ringtones when calls to a line group arrive at a phone that is logged out and on a break. This ringtone alerts a logged-out user that there is an incoming call to a hunt list to which the line is a member, but the call does not ring at the phone of that line group member because of the logged-out status. Which action meets this requirement?

A.

Configure the HLog softkey on the phone so that while a user is logged off, it plays an audible tone when a call is missed.

A.

Configure the HLog softkey on the phone so that while a user is logged off, it plays an audible tone when a call is missed.

Answers
B.

Set the service parameter Party Entrance Tone to True.'

B.

Set the service parameter Party Entrance Tone to True.'

Answers
C.

Configure the service parameter hunt group logoff notification and specify the name of the ringtone file.

C.

Configure the service parameter hunt group logoff notification and specify the name of the ringtone file.

Answers
D.

Set the service parameter Enterprise Feature Access number for hunt group logout and set up an access number

D.

Set the service parameter Enterprise Feature Access number for hunt group logout and set up an access number

Answers
Suggested answer: C

An engineer needs to deploy Cisco Extension Mobility. The engineer already activated the required services, configured the Extension Mobility Phone Service, and created an Extension Mobility device profile that is associated with end users. Which two additional steps are required to complete the configuration? (Choose two.)

A.

Subscribe IP phones to the Extension Mobility Phone Service.

A.

Subscribe IP phones to the Extension Mobility Phone Service.

Answers
B.

Consolidate Cisco UCM certificates by using Bulk Certificate Management.

B.

Consolidate Cisco UCM certificates by using Bulk Certificate Management.

Answers
C.

Subscribe directory numbers to the Extension Mobility Phone Service.

C.

Subscribe directory numbers to the Extension Mobility Phone Service.

Answers
D.

Subscribe the device profile to the Extension Mobility Phone Service.

D.

Subscribe the device profile to the Extension Mobility Phone Service.

Answers
E.

Define the default Device Template on IP phones when users log out.

E.

Define the default Device Template on IP phones when users log out.

Answers
Suggested answer: D, E

Refer to the exhibit.

Users report high delays when calling national numbers in the United States. An engineer analyzes the route patterns in Cisco UCM. What must be done to resolve this issue?

A.

Change the Cisco UCM routing logic to the longest-match algorithm.

A.

Change the Cisco UCM routing logic to the longest-match algorithm.

Answers
B.

Select Allow Overlap Sending for the \+! route pattern.

B.

Select Allow Overlap Sending for the \+! route pattern.

Answers
C.

Mark the \+ [2-9JXX[2-91XXXXXX route pattern with urgent priority.

C.

Mark the \+ [2-9JXX[2-91XXXXXX route pattern with urgent priority.

Answers
D.

Set the interdigit timeout service parameter value to 0.

D.

Set the interdigit timeout service parameter value to 0.

Answers
Suggested answer: C

An organization needs to ensure that the Cisco UCM can provide a resume softkey to users on their desk phones when they disconnect an anchored call on their mobile phone. Which solution must be used to accomplish these goals?

A.

Set the 'Retain Media on Disconnect with PI for Active Call' service parameter to False.

A.

Set the 'Retain Media on Disconnect with PI for Active Call' service parameter to False.

Answers
B.

Set the 'Retain Media on Disconnect with PI for Active Cal' service parameter to True

B.

Set the 'Retain Media on Disconnect with PI for Active Cal' service parameter to True

Answers
C.

Configure a handoff number.

C.

Configure a handoff number.

Answers
D.

Add Other Dual-Mode Device.

D.

Add Other Dual-Mode Device.

Answers
Suggested answer: A

Refer to the exhibit.

An administrator received reports that users do not hear a ringback when they dial specific external numbers. For example, the Cisco Unified Border Element receives a delayed offer invite from Cisco UCM and responds with the 183 session progress in the exhibit. Assume that the PSTN is responsible for generating ringback in these problematic scenarios. Which action resolves the issue?

A.

Enable early media on the appropriate SIP trunk on Cisco UCM.

A.

Enable early media on the appropriate SIP trunk on Cisco UCM.

Answers
B.

Edit the configuration for SIP ReMXX Options in the appropriate SIP profile on Cisco UCM to Send PRACK if 1xx Contains SDP.

B.

Edit the configuration for SIP ReMXX Options in the appropriate SIP profile on Cisco UCM to Send PRACK if 1xx Contains SDP.

Answers
C.

On Cisco Unified Border Element: voice service voip sip Re1xx require 100rel

C.

On Cisco Unified Border Element: voice service voip sip Re1xx require 100rel

Answers
D.

On Cisco Unified Border Element: voice service voip sip Re1xx disable 100rel

D.

On Cisco Unified Border Element: voice service voip sip Re1xx disable 100rel

Answers
Suggested answer: B

An engineer needs to deploy the local route group feature to a Cisco UCM server by using the standard local route group. For each device pool, the engineer needs to specify a different PSTN access for emergency calls. What must the engineer do?

A.

Add a new standard local route group. Select a route group as the new standard local route group in Device Pools. Create a route pattern of 911 that points to a route list that contains the new standard local route group.

A.

Add a new standard local route group. Select a route group as the new standard local route group in Device Pools. Create a route pattern of 911 that points to a route list that contains the new standard local route group.

Answers
B.

Create a new local route group name. In Device Pools, select a route group for that new local route group. Create a route pattern of 911 that points to a route list that contains the new local route group.

B.

Create a new local route group name. In Device Pools, select a route group for that new local route group. Create a route pattern of 911 that points to a route list that contains the new local route group.

Answers
C.

Set a new local route group name. Select a route group as the new local route group in Device Pools. Create a route pattern of 911 that points to the new local route group.

C.

Set a new local route group name. Select a route group as the new local route group in Device Pools. Create a route pattern of 911 that points to the new local route group.

Answers
D.

Add a new standard local route group. Select a route group as the new standard local route group in Device Pools. Create a route pattern of 911 that points to the new standard local route group.

D.

Add a new standard local route group. Select a route group as the new standard local route group in Device Pools. Create a route pattern of 911 that points to the new standard local route group.

Answers
Suggested answer: A

What is a capability of the gateway-preferred, network-based recording option in Cisco UCM?

A.

It requires SIP trunk and CTI with recording application.

A.

It requires SIP trunk and CTI with recording application.

Answers
B.

Cisco UCM integrates with recording destination via SIP trunk.

B.

Cisco UCM integrates with recording destination via SIP trunk.

Answers
C.

It uses BIB of IP phone to fork audio to the recording destination.

C.

It uses BIB of IP phone to fork audio to the recording destination.

Answers
D.

It initiates when the application (recorder) dictates that it must be initiated.

D.

It initiates when the application (recorder) dictates that it must be initiated.

Answers
Suggested answer: B
Total 174 questions
Go to page: of 18